Kawasaki K10400-040 User Manual
Assembly Instructions
Description: iPod® Adapter Cable
Model: Vulcan 1700 Voyager
MP3/Audio Adapter Cable
Part Number: K10400-040
K10400-041
Before you begin installation, read through the installation instructions and check to be sure all parts are
present.
If you are in doubt as to any part of the installation, please ask your authorized Kawasaki dealer to
complete the installation. Please note that Kawasaki cannot assume any responsibility for damage
resulting from incorrect installation.
Approximate
Assembly Time:
15 min.
Parts List
Seq. Description Qty
1. iPod® Adapter Cable (K10400-040 only) 1
2. Cushion 1
3. MP3/Audio Adapter Cable (K10400-041 only) 1
Installation Instructions
Installation
Install cable
z Open left fairing pocket and locate the vehicle harness with
dual plug connectors. One plug is triangular 3-pin and the
other is square 4-pin.
z Connect your adapter cable to the mating vehicle harness
connectors. You will use both connectors for an iPod adapter
cable and the 3-pin connector only for the MP3/media adapter
cable.
Attach cable
Connect your media player to the adapter cable as follows:
z The iPod connects to the large at receptor (Apple® refers to
this as a 30-pin dock connector) at the bottom of the device.
z Insert the iPod charging module into the space provided in the
cushion.
z All other audio devices connect to the round 3.5mm headphone
or line out socket.
Note
o Be sure to adjust the media player volume level to at least a few
steps below maximum output to ensure the signal going to the
radio is not distorted. This will also help conserve battery life.
Insert player and cushion into fairing pocket
z With the connection side of the device facing downward, insert
it into the underside slot of the supplied foam cushion. The
wider slot is designed to accommodate devices such as the
iPod. The smaller slot is sized for devices such as the iPod
nano®. Larger devices such as cassette or CD players may
require modication of the cushion or may be too large to t
inside the fairing pocket.
z Carefully coil the cable and connectors under the cushion.
Insert the cushion into fairing pocket until the upper edge of the
cushion is no more than ½” above the top of the pocket.
z Close and latch the cover.
NOTICE
Do not operate the motorcycle without rst closing and
locking the fairing pocket lid.
NOTE
o All Apple iPod devices with the 30-pin dock connector will
display song title, artist, etc and the iPod will be charged. The
iPod adapter cable is not designed to work with the iPhone™.
o If using any other media player, only volume can be controlled
and displayed.
o If using any media player that will not t inside the cushion,
care must be taken to protect it from road vibration and shock.
Removal of media player
z Remove the cushion and media player from the fairing pocket.
z Disconnect the media player from the adapter cable.
z Carefully remove the media player from the cushion.
z Replace the cushion and adapter cable in the fairing pocket.
Close and latch the cover.
Kawasaki Motors Corp., U.S.A. will not be responsible for any loss or damage to devices used with this
kit.
© Kawasaki Motors Corp., U.S.A., July 2009
Loading...