Kanomax AL900 Data sheet

Rosco Laboratories Inc.

A

I

I

E

April 15, 2012

52 Harbor View Avenue

Stamford, CT, USA, 06902

Phone: [phone]

ROSCO FOG FLUID & ROSCO SMOKE SIMULATION FLUID

MSDS Preparation Date:

MATERIAL SAFETY DATA SHEET

SECTION 1 - PRODUCT AND COMPANY IDENTIFICATION

ROSCO FOG FLUID & ROSCO SMOKE SIMULATION FLUID

Product Name

:
:

Product Use

Chemical Family

Supplier’s name and address:

:

Rosco Laboratories Inc.

52 Harbor View Avenue
Stamford, CT, United States
06902

24 Hr. Emergency Tel #

HMIS Rating

WHMIS Classes:

Fog fluid

queous glycol solution

[phone]

:

:

- Chronic hazard 0 - Minimal 1 - Slight 2 - Moderate 3 - Serious 4 - Severe

*

1 Reactivity: Flammability:Health: 0 0

MSDS No.:ROS002

Page 1 of 6

Unregulated

SECTION 2 - COMPOSITION/INFORMATION ON INGREDIENTS

ACGIH TLV

Ingredients

Triethylene glycol
1,3-Butylene glycol
Propylene glycol

Deionized water

* Note: The ACGIH TLV listed above for the following ingredient(s) is an AIHA WEEL: Propylene glycol.

CAS #

112-27-6

107-88-0

57-55-6

N/Av

% (weight)

N/Av
N/Av
N/Av 50 ppm( t ot al)

N/Av

N/Av
N/Av

10 mg/m3

N/Av

STEL TWA STELPEL

N/Av
N/Av
N/Av

N/Av

OSHA PEL

N/Av N/Av
N/Av N/Av

; 10 mg/m3

(aerosol)

N/Av

N/Av

N/Av

SECTION 3 - HAZARDS IDENTIFICATION

EMERGENCY OVERVIEW

Green liquid. Faint odor. No special hazards exist with this product. As with any chemical substance, caution and care will prevent

unnecessary accidents and safety problems. Read instructions on label before use. HEALTH CAUTION: Fog from this fluid, like any other

common material in an aerosolized state, may be irritating to or cause allergic symptoms in some persons with allergenic

sensitivity. Persons with active asthma should limit their exposure to the fog.

***POTENTIAL HEALTH EFFECTS***

None reported by the manufacturer.

: Target organs

Routes of exposure

Potential acute health effects :

yes:

Skin:

:

May cause mild transient irritation.

May cause irritation.

nhalation:

YES NO YES YES

Skin Absorption: Skin & Eyes:

ngestion:

Rosco Laboratories Inc.

I

I

April 15, 2012

52 Harbor View Avenue

Stamford, CT, USA, 06902

Phone: [phone]

ROSCO FOG FLUID & ROSCO SMOKE SIMULATION FLUID

MSDS Preparation Date:

nhalation:
ngestion:

Potential chronic health effects

Medical conditions aggravated by overexposure

Potential environmental effects

Can cause irritation of the respiratory tract. Persons suffering from asthma or reactive airway disorders may

experience asthma-like effects from exposure to this material.

Not an expected route of entry. Ingestion of large amounts may cause nausea, vomiting, diarrhea, as well as

depression of the central nervous system.

None reported by the manufacturer.

:

Pre-existing skin and respiratory disorders.

:

Additional health hazards

:

None reported by the manufacturer.

None reported by the manufacturer.

:

SECTION 4 - FIRST AID MEASURES

Inhalation problems are not anticipated. Remove exposed person to fresh air if adverse

Inhalation

:

effects, such as breathing difficulty arise. If irritation persists, seek prompt medical attention.

Skin contact :

Eye contact :

Ingestion

Flush skin with large amounts of water. Wash affected areas with soap and water. Remove
and wash contaminated clothing before re-use. Obtain medical attention if symptoms
develop and persist.

If in eyes, rinse with water for 15 minutes. Lift upper and lower lids during flushing to ensure
complete removal of chemical. If irritation persists, seek prompt medical attention.

Ingestion of large amounts may be harmful. Keep at rest. Seek immediate medical

:

attention/advice.
Low degree of toxicity. Treat symptomatically.

:

Notes For Physician

MSDS No.:ROS002

Page 2 of 6

SECTION 5 - FIRE FIGHTING MEASURES

Fire hazards/conditions of flammability

:

Flammability classification (OSHA 29 CFR 1910.1200)

:

Flash point
Flash point Method

Lower flammable limit (% by vol.)

Suitable extinguishing media

Explosion data: Sensitivity to mechanical impact / static discharge

Special fire-fighting procedures/equipment

Hazardous combustion products

:

:

:
:

:

:
:

:

Not flammable under normal conditions of handling.

Not flammable.
Not available.
Not available.

Extinguishing media - large fires: Non-flammable aqueous liquid, all-purpose foam
Extinguishing media - small fires: Carbon dioxide (CO2) , Dry chemical.

Not expected to be sensitive to mechanical impact or static discharge.

Auto-ignition temperature

Upper flammable limit (% by vol.)

None reported by the manufacturer.

Oxides of carbon.
None known or reported by the manufacturer.

Oxidizing properties

SECTION 6 - ACCIDENTAL RELEASE MEASURES

Personal precautions
Environmental precautions

Spill response/cleanup

:

Wear suitable protective clothing (see Section 8).
No special environmental precautions required.

:

Evacuate personnel to safe areas. Restrict access to area until completion of clean-up.

:

Recover free liquid or cover with inert absorbent material and place into appropriate
container for disposal. Dispose in accordance with all applicable federal, state, provincial
and local regulations. Contact your local, state, provincial or federal environmental agency
for specific rules.

Not available.

:

Not available.Not available.

:

Rosco Laboratories Inc.

A

V

April 15, 2012

52 Harbor View Avenue

Stamford, CT, USA, 06902

Phone: [phone]

ROSCO FOG FLUID & ROSCO SMOKE SIMULATION FLUID

MSDS Preparation Date:
Containment :

Recover free liquid or cover with inert absorbent material and place into appropriate
container for disposal. Dispose in accordance with all applicable federal, state, provincial
and local regulations. Contact your local, state, provincial or federal environmental agency
for specific rules.

SECTION 7 - HANDLING AND STORAGE

Safe Handling procedures :

Storage requirements :

Incompatible materials :

Special packaging materials

Do not ingest. Do not inhale aerosol. Avoid contact with skin and eyes. Keep containers
tightly closed when not in use. Use with adequate ventilation. Avoid breathing vapors.

Store in a cool, dry, well-ventilated area. Inspect periodically for damage or leaks. Do not
store near any incompatible materials (see Section 10). Do not freeze. Keep container
tightly closed when not in use.

Strong oxidizing agents and acids.

Liquid-proof glass, plastic or non-corrodible metal containers are recommended.

:

SECTION 8 - EXPOSURE CONTROLS AND PERSONAL PROTECTION

Ventilation and engineering measures

General mechanical ventilation is sufficient for use with this product.

:

Respiratory protection :

Skin protection

Other protective equipment
General hygiene considerations

:

None required under normal conditions.
None required under normal conditions. Gloves of natural rubber or polyvinyl chloride-

coated gloves are recommended.
None required under normal conditions. If splashing might occur, wear eye protection such

: Eye / face protection

as safety glasses with side shields.

Emergency showers and eyewash facilities should be nearby.

:

Wash hands before breaks and immediately after handling the product. Wash hands before

:

breaks and at the end of workday.

MSDS No.:ROS002

Page 3 of 6

SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES

Physical state

Odor

pH

Boiling point
Melting/Freezing point

Vapor pressure (mmHg @ 20° C / 68° F)

apor density (Air = 1)

Volatile organic Compounds (VOC's) (lbs/gal; g/l)

Viscosity
Special Remarks On Fire Hazards

:

Liquid.

:

Faint odor.

: Odor threshold

7.0 (approximately)

:

100-243 °C
Not available.

:

8.4 (approximately)

:

2.9

: Evaporation rate (n-Butyl acetate = 1)

Not available.

:

Not available.

Not flammable under normal conditions of use.

:

SECTION 10 - REACTIVITY AND STABILITY DATA

Stability and reactivity :
Hazardous polymerization
Conditions to avoid

Materials To Avoid And Incompatibility

Hazardous decomposition products

Stable under normal conditions.
Will not occur.

:

Combination with strong oxidizers and/or acids may cause explosive decomposition.

:

Strong oxidizing agents and acids.

:

ppearance

Coefficient of water/oil distribution

Solubility in water

Green liquid.

:

Not available.

:

1.12 (approximately)

:

Specific gravity :

Not available.

:

soluble

:

0.01

:

Not available.

: Volatiles (% by weight)

Rosco Laboratories Inc.

April 15, 2012

52 Harbor View Avenue

Stamford, CT, USA, 06902

Phone: [phone]

ROSCO FOG FLUID & ROSCO SMOKE SIMULATION FLUID

MSDS Preparation Date:

None.

:

SECTION 11 - TOXICOLOGICAL INFORMATION

LC50(4hr)

Ingredients

Triethylene glycol
1,3-Butylene glycol
Propylene glycol
Deionized water

Toxicological data :

Carcinogenic status
Reproductive effects

Mutagenicity

Reproductive Effects :

Irritancy

:

:
:
: Teratogenicity

:

inh, rat

N/Av 12,800 mg/kg (rat)
N/Av 18610 mg/kg (rat)
N/Av 20,000 mg/kg (rat)
N/Av >90 mL/kg (rat)

Low order of toxicity for normal industrial handling.

No components are listed as carcinogens by ACGIH, IARC, OSHA or NTP.

Not expected to have other reproductive effects.
Not expected to be a teratogen.
Not expected to be mutagenic in humans.
Not expected to have other reproductive effects.
Direct contact may cause mild eye irritation. Possible inhalation irritant. Irritating to skin.

oral

MSDS No.:ROS002

Page 4 of 6

LD50

dermal

22,460 mg/kg (rabbit)

> 20000 mg/kg (rabbit)

20,800 mg/kg (rabbit)

N/Av

Sensitization to material :

Not expected to be a sensitizer.
None reported by the manufacturer.

Synergistic materials

:

SECTION 12 - ECOLOGICAL INFORMATION

Environmental effects :
Important environmental characteristics

Ecotoxicological

None known or reported by the manufacturer. However, it is recommended not to allow the
material to enter the environment.

None known or reported by the manufacturer.

:

No data is available on the product itself.

:

SECTION 13 - DISPOSAL CONSIDERATIONS

See Section 7 (Handling and Storage) section for further details.

: Handling for Disposal

Methods of Disposal :

Contact waste disposal services. Dispose in accordance with all applicable federal, state,
provincial and local regulations. Contact your local, state, provincial or federal
environmental agency for specific rules.

SECTION 14 - TRANSPORTATION INFORMATION

Regulatory

Information

TDG

TDG

Additional

information

49CFR/DOT

UN Number Shipping Name

None

None.

Not regulated.

None

Not regulated.

Packing

Group

-None-

-None-

Label

Class

Not regulated

Not regulated

49CFR/DOT

Additional

information

None.

Rosco Laboratories Inc.

A

p

April 15, 2012

52 Harbor View Avenue

Stamford, CT, USA, 06902

Phone: [phone]

ROSCO FOG FLUID & ROSCO SMOKE SIMULATION FLUID

MSDS Preparation Date:

ICAO/IATA

ICAO/IATA

Additional

information

IMDG

IMDG

Additional

information

None

None.

None

None.

Not regulated.

Not regulated.

Not regulated

Not regulated

-None-

-None-

MSDS No.:ROS002

Page 5 of 6

SECTION 15 - REGULATORY INFORMATION

US Federal Information:

TSCA: All listed ingredients appear on the Toxic Substances Control Act (TSCA) inventory.
SARA Section 313: This material is not subject to SARA notification requirements, since it does not contain any Toxic Chemical
Constituents above de minimus concentrations.

US State Right to Know Laws:

California Proposition 65: To the best of our knowledge, this product does not contain any chemicals known to the State of
California to cause cancer or reproductive harm.

Canadian Regulations:

Canadian Environmental Protection Act (CEPA) information: All ingredients listed appear on the Domestic Substances List
(DSL).

Canadian WHMIS Classification: Not regulated.

This product has been classified according to the hazard criteria of the CPR and the MSDS contains all of the
information required by the CPR.

SECTION 16 - OTHER INFORMATION

Legend :

References :

Prepared for:

Rosco Laboratories Inc .
52 Harbor View Avenue
Stamford, CT, USA, 06902
Phone: [phone]

http://htt

://www.rosco.com/

Prepared by:

ICC The Compliance Center Inc.

Canada: 1-888-977-4834
USA: 1-888-442-9628

http://www.thecompliancecenter.com

CGIH: American Conference of Governmental Industrial Hygienists
IARC: International Agency for Research on Cancer
N/Ap: not applicable
N/Av: not available
NIOSH: National Institute of Occupational Safety and Health
NTP: National Toxicology Program
OSHA: Occupational Safety and Health Administration

Information obtained from sources including original supplier's Material Safety Data Sheet,
and references including RTECS and CCOHS Cheminfo.

Rosco Laboratories Inc.

f

r

April 15, 2012

April 15, 2012

52 Harbor View Avenue

Stamford, CT, USA, 06902

Phone: [phone]

ROSCO FOG FLUID & ROSCO SMOKE SIMULATION FLUID

MSDS Preparation Date:

MSDS No.:ROS002

Page 6 of 6

DISCLAIMER OF LIABILITY

Every effort has been made to ensure that the safety information on this sheet is accurate, but because Rosco Laboratories, Inc.
has no control over the conditions under which the product will be used, liability is limited exclusively to replacement or refund o
the purchase price of this product. Except as stated herein, there are no express or implied warranties, including implied
warranties of merchantability or fitness for a particular purpose. Rosco Laboratories, Inc. assumes no liability for injury o
incidental or consequential damages arising out of storage, handling or use of this product.

Preparation Date:

END OF DOCUMENT