Kambrook KB220 User Manual

Mega Blend

KB220 Issue 1/04

Kambrook Safety

Welcome to Kambrook and your new Mega Blend.At Kambrook we believe that the safe performance of our products is the first priority in any consumer product so that you, our valued customer, can confidently use and trust our products.

We ask that any electrical appliance that you use be operated in a sensible fashion with due care and attention placed on the following important operating instructions:

Read all instructions thoroughly before activating the appliance and retain them for future reference.

Ensure that the power source to be used is the same as the voltage requirements of the product.

Always switch the appliance to off, switch the power off at the power outlet and then unplug from the outlet when the appliance is not being used and before cleaning.

Never immerse the power cord, plug or blender body in any form of liquid.

Always place the appliance on a dry, level surface when in use.

Ensure the blender lid is securely in place before operating.

Do not remove blender jug from the motor base whilst blender is in operation.

Do not place your hands or utensils in the blender jug while the blender is operating.

Do not place hands or utensils in the jug unless the unit is disconnected from the power outlet.

Do not use this blender for anything other than food or beverage preparation.

Do not blend hard food items such as nutmeg, lump sugar and ice.

Do not operate blender continuously on

heavy loads for more than 1 min Do not process boiling or hot liquids or

ingredients, let them cool bef into the jug.

ute

e placing

Do not place any part of the blender in the dishwasher

Make sure the motor and blade have completely stopped before disassembling.

This appliance is not intended for use by young children or infirm persons without supervision.

Close supervision is required at all times when operating the appliance near children. Young children should be supervised to ensure that they do not play with the appliance.

Do not leave the appliance unattended when in use.

Do not let the cord hang over the edge of a table or counter, touch hot surfaces or become knotted.

Do not place this appliance on or near a hot gas burner, electric element, or in a heated oven.

This appliance is suitable for domestic use only.

Do not use this appliance for anything other than its intended use.

Do not use outdoors.

Regularly inspect the supply cord, plug and actual appliance for any damage. If found damaged in any way, immediately cease use of the appliance and return the entire appliance to the nearest authorised Kambrook Service Centre for examination, replacement or repair.

The installation of a residual current device (safety switch) is recommended to provide additional safety protection when using electrical appliances. It is advisable that a safety switch with a rated residual operating current not exceeding 30mA be installed in the electrical circuit supplying

ppliance. See your electrician for

the a professional advice.

Features of your Kambrook Mega Blend

1. Removable filler cap –

for adding additional ingredients during blending, liquid ingredients can be added when the cap is placed upside down and drip through the small hole in the cap

2. Extra large 1.6 litre capacity jug – for blending small or large

quantities

3. Powerful 500W motor –

powerful blending action.

4. Stainless steel blade assembly CAUTION Blades must be handled carefully as they are sharp!

5. 2 speeds dial plus pulse setting

our blending needs

or all y

6.Wrap around cord storage with securing clip

Using Your Kambrook Mega Blend

Before first use remove any promotional labels and wash the blender jug and lid in warm, soapy water, then dry.

Place the blender motor base on a level, flat surface.

Place the empty jug onto the base

Place food or liquid into the jug and firmly push the lid on top of the jug.

Ensure the speed dial is in the Off (O position.

Plug into a 230/240-volt power outlet. Turn power outlet on.

When switching the unit on hold the lid down to ensure it is safely in place.

To begin blending move the speed dial from the Off (O)position to either the Low (1 or High (2)speed, depending upon mixing requirements.The speed can be changed at any time during the blending process.

When blending is complete, turn blender off by moving the speed dial to the Off position.Wait until blades have stopped rotating before removing the lid or the blender jug from the base.

Use the PULSE setting for ingredients that require short bursts of power.

Hold the speed dial on this setting until desired blending is achieved.When released, the speed dial will automaticall the Off (O)position.

)

(O)

y return to

switch off and unplug from the power outlet, then push the food back onto the blades using a plastic spatula to scrape down the sides of the jug.Then recommence blending.

NOTE: If any moisture or liquid appears on top of the motor base, wipe immediately with paper towelling

NOTE:When blending liquids a small amount of liquid may come up from around the filter cap.This is normal.

Ensure that the filter cap is correctly in place BEFORE blending. Once blending has commenced (ie/ dial is in a position 1 or 2) you may remove the filler cap and add additional ingredients.

NOTE: Ensure that the maximum level is not exceeded.

Correctly fitting the filler cap

)

Align the protruding nubs on the filler cap with the indents on the lid and push through.Turn the cap clockwise until fully locked into position ie/ the cap can not be turned any further and the tabs are hidden under the white of the lid.

NEVER PLACE ANYTHING OTHER THAN FOOD AND LIQUIDS IN THE MEGA BLEND WHILST THE MOTOR IS RUNNING.

DO NOT PROCESS BOILING OR HOT LIQUIDS OR INGREDIENTS, LET THEM COOL BEFORE PLACING INTO THE JUG.

If ingredients stick to the sides of the blender jug during the blending process, turn the speed to the Off (O)position,

+ 8 hidden pages