Kaiser X500 Complete User Manual
Complete User Guide
Visit kaiserbaas.com for more information
PRODUCT DIAGRAMSAFETY PRECAUTIONS
01 - ENG01 - ENG
Before using your Kaiser Baas X500 Action
Camera please ensure you read and understand
the following product and safety precautions.
● DO NOT use the camera in water without
the waterproof case.
● Always check the waterproof case seal is
clean and free of debris prior to use in water.
● DO NOT attempt to open the camera or
modify it in any way. If the camera has been
opened the warranty
will be void. Maintenance and repairs should
only be performed by Kaiser Baas.
● DO NOT handle or charge the camera
without its waterproof case using wet hands.
Failure to observe this may result in damage
to camera and persons.
● ONLY recharge the camera battery using the
supplied USB cable.
● If using a wall charger, ensure that it is a
certied product for your region. AC Input:
100-240VAC 50/60Hz. DC Output: 5V 1A.
1. Power / Record / OK
POWER: HOLD 2 SECONDS
RECORD: CLICK 1 SECOND
OK: CLICK 1 SECOND
2. Menu / Mode / Scroll
POWER: HOLD 2 SECONDS
RECORD: CLICK 1 SECOND
OK: CLICK 1 SECOND
3. Micro SD Port
CONNECT TO YOUR PHONE
4. Micro HDMI
CONNECT TO YOUR SCREEN
5. Mini USB
CHARGING AND
DATA TRANSFER
6. Battery
QUICK RELEASE DOOR
TO ACCESS BATTERY
7. Tripod Thread
ATTACH TO TRIPOD &
OTHER ACCESSORIES
8. Microphone
ATTACH TO TRIPOD &
OTHER ACCESSORIES
1 2
3
4
5
6 7
8
Only use a USB wall charger with suitable
approval and certication. Do not charge in
conditions outside of the 10°C - 45°C range.
If you do not know the voltage and current
of your charger, use the included cable to
charge from your computer.
● The camera should not be used in heat
exceeding 55°C (131°F).
● DO NOT drop, crush, pierce, bend, deform,
microwave, incinerate or shoot the camera.
PRODUCT DIAGRAM GETTING STARTED
01 - ENG 01 - ENG
9. LENS
KEEP CLEAN FOR
CLEAR FOOTAGE
10. Mount Attachement
ATTACH TO TRIPOD
11.Case Latch
PULL TO OPEN
WATERPROOF CASING
12. Power / Record / OK
POWER: HOLD 2 SECONDS
RECORD: CLICK 1 SECOND
OK: CLICK 1 SECOND
13. Menu / Mode / Scroll
POWER: HOLD 2 SECONDS
RECORD: CLICK 1 SECOND
OK: CLICK 1 SECOND
9
10
11
12 13
Welcome to your new Kaiser Baas X500 Action
Camera. Before you get shooting, please review
the user guide carefully to ensure you get the
maximum performance out of your camera.
Battery Charging
We recommend that you fully charge your
camera before use. A full charge is approxi-
mately 2.5 hours using a 5V 0.5/1A Charger.
MicroSD Card Compatibility
Your camera requires a MicroSD Card
(not included). Kaiser Baas recommends the
use of a brand name Class UHS-1 or higher
MicroSD Card. Any content recording higher
than 1080P@60FPS will require a Class UHS-1
or higher card.
There is only one correct way to insert the
MicroSD card. Do not force the card into the
slot as it may damage the camera and card.
The maximum card size is 64GB.
The list of recommended MicroSD cards can be
found at: www.kaiserbaas.com/support
Format Card
Before you start recording for the rst time, we
recommend you format the MicroSD card.
The format option is found in the Settings
Menu.
For information on how to navigate the menu
please see the Menu Navigation section.
Note: Formatting the card will permanently
erase all data on the card. Be sure to backup
any content prior to formatting.
Firmware Update
Please check the www.kaiserbaas.com/support
page for the latest rmware on your camera.
The current rmware version can be found on
the last settings page.
GETTING STARTED VIDEO MODE
01 - ENG 01 - ENG
Power ON / OFF
To power ON your camera
1. Insert the battery into the camera.
2. Hold the power/toggle button for 2 seconds
until you see the Kaiser Baas logo appear.
Navigation
Navigate the menus and camera modes using
the 2 buttons found on your camera or by using
the touchscreen.
The front Menu/Toggle button cycles through
the cameras modes and settings. It can also be
used to go back/cancel any menu item.
The top Record/OK button will start/stop
recording video, capture photos and conrm/
select menu items.
The arrows on the LCD screen allow for quick
access to menus. Touch the arrows on the left
to open the Photo Scene Mode menu. The
Modes
The X500 features 2 key modes; Video Mode
and Photo Mode.
Video Mode
The default mode is Video Mode.
Click the Record button to start recording.
There is 1 Indicator light on the back of the
X500 Camera. Refer to the Camera Diagram for
exact placement. When recording, the status
LED will ash continuously.
Video Settings
Video Resolution: Your action camera can
be set to support an array of resolutions and
frame rates.
The higher the resolution the greater the detail
and clarity of footage. Higher frames-per-sec-
ond (FPS) capture more motion and appear
smoother on playback.
arrows on the right open the Settings Menu.
The arrows on the bottom of the screen open
WiFi, Sound and Stabilisation shortcuts.
Select from these menus using the touchscreen
or with the buttons.
Resolution FPS
4K 3840x2160 60
4K 3840x2160 30
2.7K 2720x1520 30
FHD 1920x1080 60/30
HD 1280x720 120/60/30
Note: Higher resolutions will become inactive
if the memory card is not Class 10 or higher.
Tip: Recording in higher resolutions/fps also
impacts battery life. Refer to the battery guide
for more tips on battery management.
Loading...