Jwin JP-119 User Manual

DIGITAL PHOTO FRAME WITH

BUILT-IN MEMORY

Instruction Manual

JP-119

Please read this manual carefully before operating and save it

for future reference.

Have a question? Please visit http://www.jWIN.com

Digital Photo Frame V10M10_IM_EN_08242007

USER SAFETY GUIDE

Instructions on Environmental Protection

Do not dispose of this product in the usual
household garbage at the end of its life
cycle; bring it to a collection point for the
recycling of electrical and electronic
appliances. This symbol on the product
means the instructions for use or the packing
will inform about the methods for disposal. The materials are
recyclable as mentioned in its marking. By recycling, material
recycling, or other forms of re-utilization of old appliances, you
make an important contribution to protect the environment.
Please inquire at your local community administration for the
authorized disposal location.

Important Safety Warnings

1. To prevent fire or electric shock, do not expose the unit to
rain or moisture.

2. Never attempt to open the cabinet. Always refer servicing to
a qualified technician.

FCC regulations state that any change or modification to the
equipment, not expressly approved by maker or its
authorized parties, could void user’s authority to operate
this equipment.

- 1 -

www.jWIN.com

Digital Photo Frame V10M10_IM_EN_08242007

USER SAFETY GUIDE

Important Safety Instructions

1. READ INSTRUCTIONS - All safety and operating
instructions should be read before the appliance is
operated.

2. RETAIN INSTRUCTIONS - The safety and operating
instructions should be retained in a secure place for future
reference.

3. HEED WARNINGS - All warnings on the appliance and in
the operating instructions should be observed.

4. FOLLOW INSTRUCTIONS - All operating and use
instructions should be followed.

5. WATER AND MOISTURE - The appliance should not be
used near water. For example: near a bathtub, kitchen sink,
laundry tub, and/or swimming pool.

6. HEAT - The appliance should be situated away from heat
sources such as radiators, heat registers, stoves, or other
appliances (including amplifiers) that produce heat.

7. POWER SOURCES - The appliance should be connected
to a power supply only of the type described in the
operating instructions or as marked on the appliance.

8. CLEANING - The appliance should only be cleaned with a
dry cloth.

9. OBJECT AND LIQUID ENTRY - Care should be taken so
that objects do not fall and liquids are not spilled into the
device’s openings.

10. CARTS AND STANDS - The appliance
should be used only with a cart or stand that
is recommended by the manufacturer. An
appliance and cart combination should be
moved with care. Quick stops, excessive
force, and uneven surfaces may cause the appliance and
cart combination to overturn causing possible injury to the
user and/or damage to the unit.

- 2 -

www.jWIN.com

Digital Photo Frame V10M10_IM_EN_08242007

USER SAFETY GUIDE

Important Safety Instructions – Continued

11. DAMAGE REQUIRING SERVICE - The appliance should
be serviced by qualified service professional when:
a. Objects have fallen into, or liquid has been spilled into

the appliance’s apertures.
b. The appliance has been exposed to rain.
c. The appliance has been dropped and suffered damage.
d. The appliance does not appear to operate normally, or

exhibits a change in performance.

12. SERVICING - The user should not attempt to service the
appliance beyond what is described in the user's operating
instructions. All other servicing should be referred to
qualified service professional.

13. LEAD AND MERCURY - This product may contain lead
and/or mercury. Disposal of these materials may be
regulated by your local authorities due to environmental
considerations. For more detailed disposal or recycling
information, please contact your local authorities or the EIA
(Electronic Industries Alliance) – http://www.eiae.org

Additional Safety Instructions

• When not in use, keep your device in a safe place where it
will not be bent or crushed.

- 3 -

www.jWIN.com

Digital Photo Frame V10M10_IM_EN_08242007

USER SAFETY GUIDE

FCC Notice to U.S. Users

This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation. Refer to 47 CFR Sec. 15.19.

This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications, which can be determined by turning the
equipment off and on, the user is encouraged to correct the
interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and

receiver.

• Connect the equipment to an outlet on a circuit different
from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician
for help.

NOTE: Changes or modifications not expressly approved by
the party responsible for compliance could void the user’s
authority to operate the equipment. Refer to 47 CFR Sec.

15.21.

- 4 -

www.jWIN.com

Digital Photo Frame V10M10_IM_EN_08242007

USER SAFETY GUIDE

Industry Canada Notice to Canadian Users

Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference
that may cause undesired operation of the device. Refer to IC
RSS 210 Sec. 5.11. The term “IC” before the certification or
registration number only means that the registration was
performed based on a Declaration of Conformity and that
Industry Canada technical specifications were met. It does not
imply that Industry Canada (IC) approved this equipment. Refer
to Self-Marking 6(f) and RSP 100 Sec. 4.

- 5 -

www.jWIN.com