jWin JH-E1100 Owner's Manual

Active Noise Reduction In-Ear

Earphones

Instruction Manual

JH-E1100

Please read this manual carefully before operating and save it

for future reference.

Have a question? Please visit www.jWIN.com

Noise Reduction In-Ear Earphones V10M10_IM_EN_08272007

USER SAFETY GUIDE

INSTRUCTIONS ON ENVIRONMENT PROTECTION

Do not dispose of this product in the usual household garbage at
the end of its life cycle; bring it to a collection point for the
recycling of electrical and electronic appliances.
This symbol on the product means the instructions
for use or the packaging will inform about the
methods of disposal. The materials are recyclable
as mentioned in its marking. By recycling, material
recycling, and other forms of re-utilization of old appliances, you
make an important contribution to the protection of the
environment. Please inquire at your local community
administration for an authorized disposal location.

Important Safety Instructions

1. Read instructions – All safety and operating instructions
should be read before the appliance is operated.

2. Retain instructions – The safety and operating instructions
should be retained in a secure place for future reference.

3. Heed warnings – All warnings on the appliance and in the
operating instructions should be observed.

4. Follow instructions – All operating and use instructions
should be followed.

5. Water and moisture – The appliance should not be used
near water (bathtub, kitchen sink, laundry tub, pool, etc.).

6. Heat – The appliance should be situated away from heat

- 1 -

www.jWIN.com

Noise Reduction In-Ear Earphones V10M10_IM_EN_08272007

USER SAFETY GUIDE

Important Safety Instructions-Continued

sources such as radiators, heat registers, stoves, or other
appliances (including amplifiers) that produce heat.

7. Power sources – The appliance should be connected to a
power supply only of the type described in the operating
instructions or as marked on the appliance.

8. Cleaning – The appliance should be cleaned with a dry cloth.

9. Objects and liquids entry – Care should be taken so that
objects do not fall and liquids are not spilled into the device’s
openings.

10. Servicing – The user should not attempt to service the
appliance beyond that described in the user's operating
instructions. All other servicing should be referred to qualified
service professional.

FCC Notice (USA)

This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation. Refer to 47 CFR Sec. 15.19.

This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio

- 2 -

www.jWIN.com

Noise Reduction In-Ear Earphones V10M10_IM_EN_08272007

USER SAFETY GUIDE

FCC Notice (USA)-Continued

communications, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for
help.

NOTE: Changes or modifications not expressly approved by
the party responsible for compliance could void the user’s
authority to operate the equipment. Refer to 47 CFR Sec.

15.21.

Industry Canada Notice to Canadian Users

Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference
that may cause undesired operation of the device. Refer to IC
RSS 210 Sec. 5.11. The term “IC” before the certification or
registration number only means that the registration was
performed based on a Declaration of Conformity and that
Industry Canada technical specifications were met. It does not
imply that Industry Canada (IC) approved this equipment. Refer
to Self-Marking 6(f) and RSP 100 Sec. 4.

- 3 -

www.jWIN.com