JVC LVT2015-001A User Manual

c DVD-R, DVD+R, DVD-RW, DVD+RW and

DVD-RAM can be used to record on your
DR-MV80B.
For recommended recordable DVD discs, please
refer to page 3 in your owner’s manual.

When your DR-MV80B is first turned on, it will flash
"Hello" as the internal EPROM chip is updated with
information.

c Please wait until "Hello" stops flashing before you

attempt to use the remote control or front panel
buttons. It takes 25-30 seconds until the set

can be operated when a disc is on the tray.

Your DR-MV80B has a progressive scan feature.
This feature only works with a TV that accepts a pro­gressive scan signal.

c If the picture is distorted, press OUTPUT

STATUS button and select 480i.

c If the picture is distorted, press OUTPUT STATUS

repeatedly until the picture appears normally to
change the resolution setting.

There is no signal output from COMPONENT OUT
when HDMI is connected and 720p/1080i/1080p is
selected at OUTPUT STATUS.

c Press OUTPUT STATUS button and select either

480i or 480p in order to watch the video signal
from COMPONENT OUT.

c You must "Finalize" the DVD before it can play in

another DVD player.
Please see page 18 in your owner’s manual.

c This unit doesn’t have an Auto Clock Setting. You

will need to manually set your clock as shown on
page 14 of your owner’s manual under the Initial
Setup Wizard. You can also look on page 15 of
your owner’s manual and follow the directions for
Clock Set.

You need to connect an external tuner such as
Cable/Satellite box. If your Cable/Satellite box has a
programmable ON/OFF timer function, the recording
will start/stop at the programmed time (Timer-Link
function).

See page 30 of your owner’s manual for instructions
on how to use Timer-Link.

How can I record TV program? How can I
use Timer-Link function?

During the Initial Set Up, I am being asked
to set the Clock. Does this model have Auto
Clock Set?

My newly recorded DVD plays in my
DR-MV80B but does not play in other DVD
players.

My DR-MV80B is showing no pic

ture.

When the resolution is set to 1080p in VCR
playback, the picture can be distorted.

My DR-MV80B is showing a distorted pic­ture.

When I turn on my DR-MV80B, it flashes
"Hello" and all the buttons on the remote
control and the front panel will not respond
for 10 - 15 seconds. Is this normal?

What DVDs can I use to record on my
DR-MV80B?

Thank you for your purchase of the JVC DR-MV80B DVD Video Recorder.
If you have any questions regarding the hookup or operation of your DR-MV80B, please contact our

Customer Care Center at 1-800-252-5722.

Please Note:

Be sure to connect the AC power plug into the power outlet after all other connections are completed.

DR-MV80B Quick Guide FAQ’s

JVC Customer Care Center

1-800-252-5722

For additional troubleshooting tips please refer to pages 43-45 in your owners manual.

LVT2015-001A

0209SKMLGEEGL