JVC AA-V90U User Manual

AC POWER ADAPTER/CHARGER

ADAPTATEUR SECTEUR/CHARGEUR DE BATTERIE
ADAPTADOR/CARGADOR DE CA

AA-V90U

INSTRUCTIONS

MANUEL D’INSTRUCTIONS

MANUAL DE INSTRUCCIONES

For Customer Use:

Enter below the Serial No. which is located
on the bottom of the unit.
Retain this information for future reference.

Model No. AA-V90U
Serial No.

LYT0002-0V5A

ENGLISHFRANÇAISESPANOL

Thank you for purchasing the JVC AC Power Adapter/
Charger. This unit provides DC power for the JVC
Digital Video Camera from a household AC outlet. It
can be used to recharge the JVC battery pack for
exclusive use with the JVC Digital Video Camera, and
is capable of charging two battery packs
consecutively. To avoid problems and obtain the best
results, please read this instruction booklet carefully
before use. Before using as a power adapter, make
sure that this unit's model number is the same as that
of the power supply unit specified in the instruction
manual of the equipment you wish to power.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR BACK).

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. 

EN-2

NO USER-SERVICEABLE PARTS INSIDE.



The lightning flash with arrowhead symbol, within an
equilateral triangle, is intended to alert the user to the
presence of uninsulated “dangerous voltage” within the
product's enclosure that may be of sufficient magnitude
to constitute a risk of electric shock to persons.



The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in
the literature accompanying the appliance.

WARNING:
TO PREVENT FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS UNIT TO RAIN
OR MOISTURE.

This unit should be used with AC 120V
only in the USA and Canada. In other countries,
this unit should be used with AC 110 – 240 V
50/60 Hz only.

CAUTION:
To prevent electric shocks and fire hazards, do
NOT use any other power source.

NOTE:

The rating plate (Serial number plate) is on the
bottom of the unit.

CAUTION:

TO PREVENT ELECTRIC SHOCK MATCH WIDE
BLADE OF PLUG TO WIDE SLOT, FULLY
INSERT.

``

`, 60 Hz

``

``

`,

``

USING HOUSEHOLD AC PLUG ADAPTER

In case of connecting attached Power Cord Plug
to AC wall outlet other than American National
Standard C73 series type, use an AC plug
adapter, so called “Siemens Plug”, as shown
below.

Plug adapter (optional)

CAUTIONS:

•If used near a radio, this unit may interfere
with reception.

•Prevent inflammables, water and metallic
objects from entering the unit.

•Do not disassemble or modify the unit.

•Do not apply shocks to the unit.

•Do not subject the unit to direct sunlight.

•Avoid using the unit in extremely hot or humid
places.

•Avoid using the unit in places subject to
vibrations.

A WORD ON THE EXCLUSIVE BATTERY PACKS

The battery packs are lithium-ion.
Give attention to the following to make the most

of their characteristics.
For charging: 10°C to 35°C (50°F to 95°F)

For operating: 0°C to 40°C (50°F to 104°F)
For storing: –10°C to 30°C (14°F to 86°F)

EN-3

CHARGING THE BATTERY PACK

You can charge one battery pack at a time, or two consecutively.

ATTACH

To AC outlet

Charger
indicator 1

Power lamp

Charger
indicator 2

EN-4

Battery pack
BN-V907U

DC jack

Power cord

AC Power Adapter/
Charger AA-V90U

DETACH

SUPPLY POWER TO CHARGER

1

Plug the AC Adapter/Charger's power
cord in to an AC outlet. The power
indicator comes on.

ATTACH BATTERY/BATTERIES

2

Remove the battery pack’s protective cap
and attach while making sure the
marks are facing down and aligned with
the corresponding marks on the AC
Power Adapter/Charger.

•The Charge Indicator (1 or 2) begins
blinking to indicate charging has started.

CONFIRM STATUS

3

When the charger indicator stops blinking
but stays lit, charging is finished.

•If two batteries are attached to the
charger, they will be charged in the
order that they were attached.

DETACH BATTERY/BATTERIES

4

Slide the battery or batteries in the
direction of the arrow and lift off.

•Remember to unplug the AC Adapter/
Charger's power cord from an AC outlet.

NOTE:

Perform charging where the temperature is
between 10° and 35°C. (20°–25°C is the ideal
temperature range for charging.) If the
environment is too cold, charging may be
incomplete.

BATTERY PACK CHARGING TIME

Battery Pack 1 Battery Pack 2 Battery Packs

BN-V907U

* When charged at temperatures between 20°

and 25°C.

•When charging Battery Packs after a long
storage period, charging time will be longer
than the time indicated above.

approx. approx.
100 min.* 200 min.*

EN-5

SUPPLYING POWER

To AC outlet

Power cord

AC Power
Adapter/Charger

JVC Digital
camcorder

You can connect the camcorder or its Dock­ing Station directly to an AC outlet using the
AA-V90U AC Power Adapter/Charger.

SUPPLY POWER TO ADAPTER

1

Plug the AC Adapter/Charger's power
cord in to an AC outlet.

SUPPLY POWER TO CAMCORDER

2

Connect the AC Adapter to the
camcorder.

EN-6

DC cord

Core
Filter

DC-IN

Connector is
under this cover

NOTE:

When using the provided DC cord, make sure
you connect the end of the cable with the core
filter to the camcorder. The core filter improves
performance of equipment.