JVC AAV80EK-AA-V80, AAV80EG, AAV80U User Manual
AC POWER ADAPTER/CHARGER
ADAPTATEUR SECTEUR/CHARGEUR DE BATTERIE
ADAPTADOR/CARGADOR DE CA
AA-V80U
MANUEL D’INSTRUCTIONS
MANUAL DE INSTRUCCIONES
INSTRUCTIONS
For Customer Use:
Enter below the Serial No. which is located on the
bottom of the unit.
Retain this information for future reference.
Model No. AA-V80U
Serial No.
LYT0002-0F1A
ENGLISHFRANÇAISESPANOL
Thank you for purchasing the JVC AC Power
Charger/ Adapter. This unit provides DC power for
the JVC Digital Video Camera from a household AC
outlet. It can be used to recharge the JVC battery
pack for exclusive use with the JVC Digital Video
Camera, and is capable of charging two battery
packs consecutively. To avoid problems and obtain
the best results, please read this instruction booklet
carefully before use.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING:
TO PREVENT FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS UNIT TO RAIN
OR MOISTURE.
This unit should be used with AC 120V
only in the USA and Canada. In other countries,
this unit should be used with AC 110 – 240 V
50/60 Hz only.
CAUTION:
To prevent electric shocks and fire hazards, do
NOT use any other power source.
``
`, 60 Hz
``
``
`,
``
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
EN-2
NO USER-SERVICEABLE PARTS INSIDE.
The lightning flash with arrowhead symbol, within an
equilateral triangle, is intended to alert the user to the
presence of uninsulated “dangerous voltage” within the
product's enclosure that may be of sufficient magnitude
to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in
the literature accompanying the appliance.
NOTE:
The rating plate (Serial number plate) is on the
bottom of the unit.
CAUTION:
TO PREVENT ELECTRIC SHOCK MATCH WIDE
BLADE OF PLUG TO WIDE SLOT, FULLY
INSERT.
USING HOUSEHOLD AC PLUG ADAPTER
In case of connecting attached Power Cord Plug
to AC wall outlet other than American National
Standard C73 series type, use an AC plug
adapter, so called “Siemens Plug”, as shown
below.
Plug adapter (optional)
CAUTIONS:
•If used near a radio, this unit may interfere
with reception.
•Prevent inflammables, water and metallic
objects from entering the unit.
•Do not disassemble or modify the unit.
•Do not apply shocks to the unit.
•Do not subject the unit to direct sunlight.
•Avoid using the unit in extremely hot or humid
places.
•Avoid using the unit in places subject to
vibrations.
A WORD ON THE EXCLUSIVE BATTERY PACKS
The battery packs are lithium-ion.
Give attention to the following to make the most
of their characteristics.
For charging: 10°C to 35°C (50°F to 95°F)
For operating: 0°C to 40°C (50°F to 104°F)
For storing: –10°C to 30°C (14°F to 86°F)
EN-3
CHARGING THE BATTERY PACK
You can charge one battery pack at a time, or two consecutively.
ATTACH
To AC outlet
Battery pack BN-V812U
Power cord
DETACH
EN-4
Charger
indicator 1
Power lamp
Charger
indicator 2
DC jack
AC Power Adapter/
Charger AA-V80U
SUPPLY POWER TO CHARGER
1
Plug the AC Adapter/Charger's power
cord in to an AC outlet. The power
indicator comes on.
ATTACH BATTERY/BATTERIES
2
Make sure the + – marks are facing down
and aligned with the corresponding marks
on the AC Power Adapter/Charger.
•The Charge Indicator (1 or 2) begins
blinking to indicate charging has started.
CONFIRM STATUS
3
When the charger indicator stops blinking
but stays lit, charging is finished.
•If two batteries are attached to the
charger, they will be charged in the
order that they were attached.
DETACH BATTERY/BATTERIES
4
Slide the battery or batteries in the
direction of the arrow and lift off.
•Remember to unplug the AC Adapter/
Charger's power cord from an AC outlet.
NOTE:
Perform charging where the temperature is
between 10° and 30°C. (20°–25°C is the ideal
temperature range for charging.) If the
environment is too cold, charging may be
incomplete.
BATTERY PACK CHARGING TIME
Battery Pack 1 Battery Pack 2 Battery Packs
BN-V812U
* When charged at temperatures between 20°
and 25°C.
•When charging Battery Packs after a long
storage period, charging time will be longer
than the time indicated above.
approx. approx.
100 min.* 200 min.*
EN-5
SUPPLYING POWER
You can connect the camcorder or its Docking Station directly to an AC outlet using the
AA-V80U AC Power Adapter/Charger.
To AC outlet
AC Power
Adapter/Charger
EN-6
DC cord
Core Filter
Power cord
JVC Digital
camcorder
DC-IN
Connector is under
this cover
SUPPLY POWER TO ADAPTER
1
Plug the AC Adapter/Charger's power
cord in to an AC outlet.
SUPPLY POWER TO CAMCORDER
2
Connect the AC Adapter to the
camcorder.
NOTE:
When using the provided DC cord, make sure
you connect the end of the cable with the core
filter to the camcorder. The core filter improves
performance of equipment.
Loading...