juwel Eccoflow 500, Eccoflow 600, Eccoflow 1000, Eccoflow 1500 Instruction Manual

JUWEL Eccoflow
300/500/600/
1000/1500

Typ
280/500/600/
1000/1500

Instruction Manual

Pump Set

www.juwel-aquarium.com

Introduction

Thank you for choosing a JUWEL Aquarium product.
Our products represent over 40 years experience in the manufacturing of aquariums

and their accessories applying the most modern production techniques in bringing
together the JUWEL Aquarium system, which is both easy to use and simple to
maintain.

Safety instructions:

This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use of
the appliance in a safe way and understand the hazards involved. Children shall
not play with the appliance. Cleaning and user maintenance shall not be made by
children without supervision.

Always unplug all immersed electrical equipment from mains before placing your
hands into the water.

Operation with the RC circuit breaker only, max. 30mA.

The power plugs of the electrical devices must not become moist. Connect the
power plugs to the power supply at such a height that the connection cable
forms a loop which would enable the water to drip down.

Safety instructions:

Never operate the power head out of water.
Always unplug the power head from the power supply before removing it from the

filter.
The power head is intended for indoor use and for use in fluids up to 35°C.
Never repair the electrical cord or plug. In case of damage replace the complete

power head.

Recommendation:

In order to ensure that the power head operates at its optimum and maintains its
low noise level, we recommend to check and potentially replace the parts subject
to wear and tear, such as the impeller and the adapter.

All spare parts are available from your local JUWEL Aquarium retailer.

If you wish to operate the pump JUWEL Eccoflow in a seawater aquarium, you
will need the JUWEL Eccoflow ceramic shaft set for the impeller. Item No. 85225
for pump JUWEL Eccoflow 500/600/1000.

Item No. 85226 for pump Juwel Eccoflow 1500.
Inquire at your specialist retailer to that end.

The pump JUWEL Eccoflow

The new pump JUWEL Eccoflow distinguishes itself with operating quietness and a
high flow rate. The new design and the improved technology make the use and the
maintenance even easier. Utilising the enclosed adapters, the pump JUWEL Eccoflow is
suitable as replacement for the pumps JUWEL Bioflow and also the JUWEL pump types
300/500/600/1000/1500.

The new pump JUWEL Eccoflow essentially consists of:

1. Motor

2. Impeller with axle and rubber mounts

3. Pump adapter for the JUWEL filter system Bioflow

4. Connection ring for the JUWEL Compact, Standard H and Jumbo filter system
(Pump adapter Order No. 85136)

1 2 3

4

2

Installation of the pump JUWEL Eccoflow in the filter system
Bioflow Super , 3.0, 6.0, 8.0

Please ensure that the impeller has been properly inserted and the pump adapter has
been firmly connected to the motor prior to the installation of the new pump.

Please proceed as follows:

1. Disconnect all electrical devices of the aquarium from the power grid.

2. Remove the outlet nozzles and remove the old pump from the filter.

3. Insert the new pump into the separation wall of the filter and firmly push it into
place.

4. Connect the outlet nozzle to direct the waterflow as desired from the outside to the
outlet opening of the pump. Reinstall the gasket into the round opening of the filter
housing when connecting the outlet. This decreases vibration transmissions.

Now the pump is ready for operation and you may reconnect the electrical devices to
the power grid.

Maintenance of the pump JUWEL Eccoflow in the filter system
Bioflow Super , 3.0, 6.0, 8.0

The pump JUWEL Eccoflow should be checked with regard to functionality and cleaned
at regular intervals (at least once a month).

Please proceed as follows to that end:

1. Disconnect all electrical devices of the aquarium from the power grid.

2. Remove the outlet nozzles.

3. Remove the pump from the separation wall of the filter.

4. Disconnect the adapter (A) from the motor by turning it counter-clockwise and
remove the impeller.

5. Thoroughly clean all components. It is particularly necessary to remove the impeller
from the chamber and remove deposits and dirt from the chamber itself as well as the
impeller. The function of the pump will be impaired otherwise. Also check the impeller
for damage and possible signs of wear of the magnet.

After that, please reinstall the pump in reverse order in the filter.

A

A

Recommendation

JUWEL Digital Thermometer 2.0

To monitor the temperature we recommend the JUWEL Digital Thermometer (Part No.

85702). Available from your JUWEL Aquarium retailer.

3

Installation of the pump JUWEL Eccoflow in the filter system
Compact, Standard H and Jumbo

Please proceed as follows in order to install the new pump:

1. Disconnect all electrical devices of the aquarium from the power grid.

2. Remove the adapter (A) from the motor and replace it with the connection ring (B)
as shown on the picture at the new pump JUWEL Eccoflow.

3. Remove the outlet nozzles and remove the old pump and the pump adapter from the
filter.

4. Now arrange the pump on the pump adapter (C) and turn it all the way to the right.

5. Firmly place the new pump on the separation wall; the outlet of the pump must
point at the round opening in the filter housing.

6. Connect the outlet nozzle to direct the waterflow as desired from the outside to the
outlet opening of the pump. Reinstall the gasket into the round opening of the filter
housing when connecting the outlet. This decreases vibration transmissions.

Now the pump is ready for operation and you may reconnect the electrical devices to
the power grid.

A

C

C

B

Maintenance of the pump JUWEL Eccoflow in the filter system
Compact, Standard H, Jumbo

The pump JUWEL Eccoflow should be checked with regard to functionality and cleaned
at regular intervals (at least once a month).

Please proceed as follows:

1. Disconnect all electrical devices of the aquarium from the power grid.

2. Remove the outlet nozzles.

3. Remove the pump from the filter.

4. Disconnect the pump adapter (C) and the connection ring (B) from the motor by
turning them counter-clockwise and remove the impeller.

5. Thoroughly clean all components. It is particularly necessary to remove the impeller
from the chamber and remove deposits and dirt from the chamber itself as well as the
impeller. The function of the pump will be impaired otherwise. Also check the impeller
for damage and possible signs of wear of the magnet.

After that, please reinstall the pump in reverse order in the filter.

CB

4

Proper disposal (electrical waste)

The labelling on the product or on the accompanying literature declares that it
must not be disposed of, at the end of its service life, together with household
rubbish. Please dispose of this equipment separately from other waste, to protect
the environment or public health from damage by unregulated waste disposal.
Recycle the equipment and support the sustained recycling of material resources.

Private users should contact the dealer who sold them the product or the
responsible authorities, for a demonstration on how to recycle the equipment in
an environmentally friendly way.

Guarantee

We guarantee the performance of the JUWEL-Aquarium product or its accessories to the
purchaser for a period of 24 months from the date of purchase according to the
following conditions:

§ 1 Extent of the guarantee
(1) This guarantee extends to the JUWEL-Aquarium product and its components

excluding items subject to wear and tear such as light tubes and filter media. It is
limited to the product as such and does not cover damage to other property and/or
individuals. In addition, the provisions of the product liability law apply. These
provisions are not limited by the aforementioned arrangement.

(2) It is the prerogative of JUWEL-Aquarium to decide whether the guarantee is
performed by means of repair or replacement. If neither repair nor replacement can
ensure the performance of the JUWEL-Aquarium product the purchaser is entitled to
demand a reduction in price or to return the product against repayment of the
purchase price.

§ 2 Guarantee period and settlement procedure
(1) The guarantee period begins on the day of the purchase of the product from the

retailer. Claims under this guarantee will not be honoured, if
(a) the damage is caused as a result of improper use or maintenance or non-

observance of the instructions given in this manual
(b) the product or its components have been maintained by persons or companies not

authorised by the manufacturer to do so
(c) the product or its components have been damaged by mechanical means of

whatsoever kind, in particular broken glass
(2) All claims under this guarantee have to be notified to the retailer, from whom the

aquarium has been purchased without delay, however, not longer than 2 weeks from
the day of first occurrence of defects. Rights under the consumer protection laws will
remain unaffected.

(3) Guarantee claims will only be accepted if the validity of the claim is supported by
evidence of purchase of the JUWEL-Aquarium product.

This declaration of guarantee is a translation only. In case of doubts the original
German language version prevails.

We reserve the right to make technical alterations.

© JUWEL AQUARIUM
® JUWEL, Trigon, Vision, Rekord, Rio, Lido, Vio, Korall, Monolux, Duolux, Multilux,

Korallux, Violux, High-Lite, Warm-Lite, Colour-Lite, Day-Lite, Juwel Twin-Lite, Juwel
Eccoflow, Bioflow, Cirax, Nitrax.

JUWEL AQUARIUM GMBH & CO. KG
Karl-Göx-Straße 1 27356 Rotenburg/Wümme . GERMANY
Telefon [phone]
Telefax +49(0)42 61/93 79-856
Service-Mail [e-mail]

JUWEL AQUARIUM UK Branch
Gateway 11 Business Park
Penfold Drive, Wymondham Norfolk NR18 0WZ
Tel.: [phone] Fax: [phone]
E-Mail: [e-mail]
Service-Mail: [e-mail]

5