JUKI DLU-5494N-7/IP-110C Installation Manual

ENGLISH

INSTALLATION MANUAL

* "CompactFlash(TM)" is the registered trademark of SanDisk Corporation, U.S.A.

CONTENTS

1. CHECK AT THE BEGINNING ..................................................................... 1

(1) Control box to be used ............................................................................................. 1

(2) List of parts to be used ............................................................................................ 1

2. SETUP OF THE HARDWEAR .................................................................... 1

(1) Attaching the circuit board ...................................................................................... 1

3. SETUP OF THE SOFTWARE ..................................................................... 3

(1) Checking procedure of the software version ......................................................... 3

(2) Rewriting procedure of the software by means of IP-110 ..................................... 4

1) Common procedure ..........................................................................................................................4

2) Rewriting procedure of the software of IP-110 ...............................................................................5

3) Rewriting procedure of the software of main shaft ...................................................................... 7

1. CHECK AT THE BEGINNING

(1) Control box to be used

Fig. A

There are cases where the control box to be used

may not be utili zed. Che ck that REV. No. 1 as

shown in Fig. A is after "02". If the number is before

it, the control box cannot be used.

1

(2) List of parts to be used

On the occasion of using DLU-5494N-7/IP-110C, check that the products (parts) below are on hand.

1. DLU-5494N-7 machine head

2. IP-110C panel

3. SC-910 control box

4. M-91 motor

5. Extension p.c.b (KT-01(EPF) p.c.b.) for DLU-5494N-7

2. SETUP OF THE HARDWEAR

When the parts to be used are ready, install the extension p.c.b. on SC-910 following the procedure below.

(1) Attaching the circuit board

1. Open the front cover and upper cover according

to the instructions given in the Instruction Manual

for the control box main unit.

Inserting position

2

2. Insert stud 2 supplied with the unit as

accessories to KT-01(EPF) p.c.b. A (asm.) 1.

Be careful of the inserting direction.

Rear side

1

– 1 – – 1 – – 1 –