Jonsered GT21L Instruction Manual

Bedienungsanweisung
Manual de instrucciones
Libretto d’Istruzioni
Lesen Sie diese Hinweise zur Handhabung des Geräts aufmerksam durch. Verwenden Sie es erst, wenn Sie sicher sind, daß Sie alle Anweisungen verstanden haben.
Leggere attentamente queste istruzioni e accertarsi di averle comprese prima di usare l’unità.
530088139
1/10/02
Deutsch
Italiano
Español
Instruction Manual
Manuel d’instructions
English
Français
Please read these instructions carefully and make sure you understand them before using this unit.
Avant d’utiliser cet appareil, veuillez lire attentive­ment les instructions et assurez--vous de les avoir comprises.
ENGLISH
FRANÇAIS DEUTSCH
ITALIANO
ESPANOL
Lees deze instructies zorgvuldig en wees er zeker van dat u ze begrijpt alvorens dit apparaat te gebrui­ken.
Handleiding
Nederlands
NEDERLANDS
JONSERED SERVICE
2
IDENTIFICATION (WHAT IS WHAT?)
Shield
Choke
Primer Bulb
ON/OFF Switch
Trimmer head
Tube
Assist handle
Throttle
Fuel tank
Assist handle adjustment
Starter Handle
Manual
Muffler
IDENTIFICATION OF SYMBOLS
A.
WARNING!
This trimmer can be dangerous! Careless or improper use can cause
serious or even fatal injury. B. Read and understand the instruction manual before using the trimmer. C. Never use blades with this tool.
D.
WARNING!
The trimmer line can throw objects violently. You can be blinded or
injured. Always wear eye protection. E. Always use:
Ear protection
Protective glasses or visor F. Assist handle to be positioned only below the arrow. G. The operator of the machine must insure that no one comes within a 15 meter radius
while working. When several operators are working within the same area a safety dis-
tance of at least 15 meters must be observed. H. Use unleaded or quality leaded petrol and two--stroke oil mixed at a ratio of 2.5%. I. Engine ON/OFF Switch. J. Sound power level K. Max speed of output axle, rpm
3
SAFETY RULES
WARNING:
When using gardening
appliances, basic safety precautions should al­ways be followed to reduce the risk of fire and serious injur y. Read and follow all instructions.
This power unit can be dangerous! Operator is responsible for following instructions and warn­ings on unit and in manual. Read entire instruc­tion manual before using unit! Be thoroughly fa­miliar with the controls and the proper use of the unit. Restrict the use of this unit to persons who read, understand, and follow instructions and warnings on unit and in manual. Never allow children to operate this unit.
SAFETY INFORMATION ON THE UNIT
INSTRUCTION MANUAL
DANGER:
Never use blades, wire, or flailing devices. This unit is designed for line trimmer use only. Use of any other accessories or attachments will increase the risk of injury .
WARNING:
Trimmer line throws ob-
jects violently. You and others can be blinded/ injured. Wear safety glasses and leg protec­tion. Keep body parts clear of rotating line.
Safety Glasses or similar eye protection
Boots
Hazard Zone
15 meters
Keep children, bystanders, and animals 15 me­ters away. If approached stop unit immediately.
If situations occur which are not covered in this manual, use care and good judgement. If you need assistance, contact your authorized service dealer.
OPERATOR SAFETY
S Dress properly. Always wear safety
glasses or similar eye protection when op­erating, or performing maintenance, on your unit (safety glasses are available). Eye protection should be marked Z87.
S Always wear face or dust mask if operation
is dusty.
S Always wear heavy, long pants, long
sleeves, boots, and gloves. W earing safety leg guards is recommended.
S Always wear foot protection. Do not go
barefoot or wear sandals. Stay clear of spinning line.
S Secure hair above shoulder length. Secure
or remove loose clothing or clothing with loosely hanging ties, straps, tassels, etc. They can be caught in moving parts.
S Being fully covered also helps protect you
from debris and pieces of toxic plants thrown by spinning line.
S Stay Alert. Do not operate this unit when you
are tired, ill, upset or under the influence of al­cohol, drugs, or medication. Watch what you are doing; use common sense.
S Wear hearing protection. S Never start or run inside a closed room or
building. Breathing exhaust fumes can kill.
S Keep handles free of oil and fuel.
UNIT / MAINTENANCE SAFETY
S Disconnect the spark plug before performing
maintenance except carburetor adjustments.
S Look for and replace damaged or loose
parts before each use. Look for and repair fuel leaks before use. Keep in good working condition.
S Replace trimmer head parts that are
chipped, cracked, broken, or damaged in any other way before using the unit.
S Maintain unit according to recommended
procedures. Keep cutting line at proper length.
S Use only 1,6 mm diameter Jonsered!
brand line. Never use wire, rope, string, etc.
S Install required shield properly before using
the unit. Use only specified trimmer head; make sure it is properly installed and se­curely fastened.
S Make sure unit is assembled correctly as
shown in this manual.
S Make carburetor adjustments with lower
end supported to prevent line from contact­ing any object.
S Keep others away when making carburetor
adjustments.
S Use only recommended Jonsered! acces-
sories and replacement parts.
S Have all maintenance and service not ex-
plained in this manual performed by an au­thorized service dealer.
FUEL SAFETY
S Mix and pour fuel outdoors. S Keep away from sparks or flames. S Use a container approved for fuel. S Do not smoke or allow smoking near fuel or
the unit.
S Avoid spilling fuel or oil. W ipe up all fuel spills. S Move at least 3 meters away from fueling
site before starting engine.
S Stop engine and allow to cool before re-
moving fuel cap.
S Always store gasoline in a container ap-
proved for flammable liquids.
4
CUTTING SAFETY
WARNING:
Inspect the area before each use. Remove objects (rocks, broken glass, nails, wire, etc.) which can be thrown
by or become entangled in line. Hard objects can damage the trimmer head and be thrown causing serious injury. S Use only for trimming, scalping, mowing
and sweeping. Do not use for edging, prun­ing or hedge trimming.
S Keep firm footing and balance. Do not over-
reach.
S Keep all parts of your body away from muf-
fler and spinning line. Keep engine below waist level. A hot muffler can cause serious burns.
S Cut from your right to your left. Cutting on
left side of the shield will throw debris away from the operator.
S Use only in daylight or good artificial light. S Use only for jobs explained in this manual.
TRANSPORTING AND STORAGE
S Allow the engine to cool; secure unit before
storing or transporting in vehicle.
S Empty fuel tank before storing or transport-
ing the unit. Use up fuel left in the carburetor by starting engine and letting it run until it stops.
S Store unit and fuel in an area where fuel va-
pors cannot reach sparks or open flames from water heaters, electric motors or switches, furnaces, etc.
S Store unit so line limiter cannot accidentally
cause injury. Unit can be hung by the tube.
S Store the unit out of the reach of children
SPECIAL NOTICE:
Exposure to vibra­tions through prolonged use of gasoline pow­ered hand tools could cause blood vessel or nerve damage in the fingers, hands, and joints of people prone to circulation disorders or abnormal swellings. Prolonged use in cold weather has been linked to blood vessel dam­age in otherwise healthy people. If symptoms occur such as numbness, pain, loss of strength, change in skin color or texture, or loss of feeling in the fingers, hands, or joints, discontinue the use of this tool and seek med­ical attention. An anti-vibration system does not guarantee the avoidance of these prob­lems. Users who operate power tools on a continual and regular basis must monitor closely their physical condition and the condi­tion of this tool.
ASSEMBLY
WARNING:
Make sure unit is proper­ly assembled and all fasteners are secure. Examine parts for damage. Do not use dam­aged parts. It is normal for the fuel filter to rattle in the empty fuel tank. Finding fuel or oil residue on muffler is normal due to carburetor adjustments and testing done by the manufacturer.
ADJUSTING THE HANDLE
WARNING:
When adjusting the han­dle, be sure it remains between the trigger
and the safety label. Assist handle must be positioned only below the arrow.
1. Loosen knob on handle.
2. Rotate the handle on the tube to an up-
right position; retighten knob.
ATTACHING THE SHIELD
WARNING:
The shield must be prop­erly installed. The shield provides partial protection from the risk of thrown objects to the operator and others and is equipped with a line limiter which cuts excess line. The line limiter (on underside of shield) is sharp and can cut you.
1. Remove wing nut from shield.
2. Insert bracket into slot on shield.
3. Pivot shield until bolt passes through hole
in bracket.
4. Reinstall wing nut and tighten securely.
Slot
Shield
Wing Nut
Bracket
Line Limiter Blade
Loading...
+ 8 hidden pages