JL Audio ZR570-CSTR570-CXi Installation Manual
INSTALLATION GUIDE
for the
SB-F-F1502/10W3v3
SB-F-F1502/10W3v3
2004 - 2008 Ford F-150 Super Crew & Super Cab
2004 - 2008 Ford F-150 Super Crew & Super Cab
&
&
2006 - 2008 Lincoln Mark LT
2006 - 2008 Lincoln Mark LT
Thank you for choosing a JL Audio Stealthbox® for your automotive sound system. With proper
installation, your new vehicle-specific enclosed subwoofer system will deliver years of listening pleasure.
We strongly recommend that you have your new Stealthbox® installed by your authorized JL Audio
dealer. The installation professionals employed by your dealer have the necessary tools and experience
to disassemble and reassemble your vehicle properly. If you prefer to perform your own installation,
please read this installation guide completely
before beginning the process.
If you choose to per form the installation yourself, it is absolutely vit al that
the Stealthbox
®
be properly m ounted to the vehicle according to these
instructions. Failure to mount the enclosure properly presents two prob lems:
1) The sub-bass performance will suf fer due to the movement of the enclosure
caused by the force exerted by the woofer(s).
2) A loose enclosure presents a seriou s safety hazard in the event of a collision
or sudden deceleration.
STEP 1
Remove all contents from the rear seating area.
Lift up both seats.
Remove the jack, jack tools and the jack’s mounting bracket.
The jack and the jack tools must be relocated.
Continued on Next Page
STEP 2
Thread a supplied socket cup screw into the driver’s side rear
of the Stealthbox®, leaving 1.0” of the threads exposed.
STEP 3
Thread another supplied so cket cup screw into the
passenger’s side rear of the Stealthbox ®, leaving 1.0” of the
threads exposed.
SB-F-F1502/10W3v3_INSTR_SKU#011251
SB-F-F1502/10W3v3_INSTR_SKU#011251
INSTALLATION
DIFFICULTY:
1
5
OUT
OF
ESTIMATED TIME:
1
HOU R
HOUR
SB-F-F1502/10W3v3_INSTR_SKU#011251
SB-F-F1502/10W3v3_INSTR_SKU#011251
STEALTHBOX WALL
REAR SEAT BRACKET
THREADED INSERT
LOCK WASHER
FLAT WASHER
SOCKET CUP SET SCREW
HEX NUT
CONGRATULATIONS
You have completed the installation for this model!
Please refer to the Power Recommendation sec tion for an
amplifier recommendation and basic set-up help.
STEP 6
Place a supplied flat washer, lock washer and then hex nut
onto each socket cup set screw and secure.
STEP 5
Guide the two socket cup s et screws through the existing
holes that are located on the rear seat brackets.
STEP 4
Run speaker wir e from t he amplifie r’s location to t he
Stealthbox® locati on and check for proper ope ration of
the woofer.
Page 3 • JL Audio, Inc 2007
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered
trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.
JLA-SKU#011251-01-24-200
JLA-SKU#011251-01-24-20088 • Printed in USA • ©2007 JL Audio, Inc. • U.S. PATENTS: #5,734,734 #5,949,898 #6,118,884 #6,229,902
#6,243,479 #6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign
patents pending. For more detailed information please visit us online at www.jlaudio.com.
(954) 443-1100
www.jlaudio.com
10369 NORTH COMMERCE PARKWAY • MIRAMAR, FLORIDA • 33025 • USA
INCLUDED HARDWARE
(2)
(2)
3/8” -16 x 2-1/4” Socket Cup Set Screw
3/8” -16 x 2-1/4” Socket Cup Set Screw
(2)
(2)
3/8” Flat Washer
3/8” Flat Washer
(2)
(2)
3/8” Split Lock Washer
3/8” Split Lo ck Washer
(2)
(2)
3/8” -16 Hex Nut
3/8” -16 Hex Nut
SPECIFICATIONS
Enclosure Type:
Bass Reflex (ported)
Bass Reflex (ported)
Driver Type:
10W3v3-4
10W3 v3-4
Nominal Impedance:
4 ohms mono
4 ohms mono
Continuous Power Handling:
500 Watts
500 Watts
P O W E R R E C O M M E N D A T I O N
POWER RECOMMENDATION
JL Audio recommends using a high quality amplifier such as the JL Audio 500/1v2.
The diagram below shows the recommended crossover, infrasonic filter and equalizer settings for the 500/1v2
when being used to power your Stealthbox®.
+12VDC Ground Remote Preamp Output Section
Infrasonic Filter
“Q” Center Freq. Boost (dB)
Amp LP Filter
Advanced
Bass
Control
Amplifier Input Section
Subwoofer Output
MONO OUTPUT ONLY
Left Output Right Output Left Ch. Right Ch.Filter Freq. (Hz) Filter Freq. (Hz)Infrasonic Freq. (Hz) Remote Bass Port
Full Range | Amp Filter | Out Filter
Output Mode Filter Slope Mode
Mode | Slope
Input Voltage Input Sens. Signal Sensing
12dB| 24dB
Filter Mode
LP| HP
Bass EQ
Off | On
Off | 12dB | 24dB Low | High Off | OnOff | On
40
45
556580
100
200 15
18
223045
55
60 40
45
556580
100
200
0.5
0.7
1.1
1.6
2.7
4.3 20
25
304060
75
80 0
+4
+10
+13
+15
500/1v2
Monoblock Subwoofer Amplifier
The JL Audio 500/1v2 is a very versatile audio component. Please consult the owner’s manual for even more
detailed information about installing and tuning this amplifier.
MID/HIGH FREQUENCY DRIVER FITMENT
A variety of JL Audio coa xial and component systems will fit in the factor y speaker locations of you vehicle.
Front Speaker Size / Location:
5” x 7” / Front Doors
5” x 7” / Front Doors
Fits JL Audio Mo dels:
TR570-CXi, C5-570, C5-570x & ZR570-CS
TR570-CXi, C 5-570, C5-570x & ZR570- CSii
Rear Speaker Size / Location:
5” x 7” / Rear Door
5” x 7” / Rear Door
Fits JL Audio Models:
TR570-CXi, C5-570, C5-570x & ZR570-CS
TR570-CXi, C 5-570, C5-570x & ZR570- CSii
Loading...