Jensen MR-750 User Manual

R

AM/FM/NOAA WEATHER BAND RADIO

USER MANUAL

MR-750

PLEASE READ THIS USER MANUAL COMPLETELY BEFORE

OPERATING THIS UNIT AND RETAIN IT FOR FUTURE REFERENCE

DEAR JENSEN® CUSTOMER

Sound can be deceiving. Over time your hearing "comfort level" adapts to
higher volumes of sound. So what sounds "normal" can actually be loud
and harmful to your hearing.Guard against this by setting your equipment
at a safe level BEFORE your hearing adapts.

affecting your sensitive hearing.

Selecting fine audio equipment such as the unit you've just purchased is
only the start of your musical enjoyment. Now it's time to consider how you
can maximize the fun and excitement your equipment offers. This
manufacturer and the Electronic Industries Association's Consumer
Electronics Group want you to get the most out of your equipment by
playing it at a safe level. One that lets the sound come through loud and
clear without annoying blaring or distortion and, most importantly, without

To establish a safe level:

Start your volume control at a low setting.
Slowly increase the sound until you can hear it comfortably and

clearly, and without distortion

Once you have established a comfortable sound level:

Set the dial and leave it there.

Taking a minute to do this now will help to prevent hearing damage or
loss in the future. After all, we want you listening for a lifetime.

We Want You Listening For a Lifetime

Used wisely, your new sound equipment will provide a lifetime of fun and
enjoyment. Since hearing damage from loud noise is often undetectable
until it is too late, this manufacturer and the Electronic Industries
Association's Consumer Electronics Group recommend you avoid
prolonged exposure to excessive noise.

Customer's Record:

The serial number of this product is found on its bottom cover. You should
note the serial number of this unit in the space provided as a permanent
record of your purchase to aid in identification in the event of theft of loss.

Model Number: MR-750 Serial Number: _____________

1

IMPORTANT SAFETY INSTRUCTIONS

When used in the directed manner, this unit has been designed and
manufactured to ensure your personal safety. However, improper use can
result in potential electrical shock or fire hazards. Please read all safety
and operating instructions carefully before installation and use, and keep
these instructions handy for future reference. Take special note of all
warnings listed in these instructions and on the unit.

1.Read these instructions – All the safety and operating instructions
should be read before the appliance is operated.

2.Keep these instructions – The safety and operating instructions should
be kept for future reference.

3.Heed all warnings – All warnings on the appliance and in the operating
instructions should be adhered to.

4. Follow all instructions – All operation and use instructions should be
followed

5.Do not use this apparatus near water – The appliance should not be
used near water; for example, near a bath tub, washbowl, kitchen sink,
laundry tub, in a wet basement, or near a swimming pool.

6.Clean only with dry cloth – The appliance should be clean6d only as
recommended by the manufacturer.

7.Do not install near any heat sources such as radiators, heat registers,
stoves, or other apparatus (including amplifiers) that produce heat.

8.Only use attachments / accessories specified by the manufacturer.

9.Refer all servicing to qualified service personnel. Servicing is required
when the apparatus has been damaged in any way, such as
power-supply cord or plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has been exposed to rain
or moisture, does not operate normally, or has been dropped.

10.This appliance shall not be exposed to dripping or splashing water and
that no object filled with liquids such as vases shall be placed on the
apparatus.

11.Power Sources – The appliance should be connected to a power supply
only of the type described in the operating instructions or as marked on
the appliance. Do not overload wall outlet.

12.Danger of explosion if battery is incorrectly replaced. Replace only with
the same or equivalent type.

13. Do not attempt to dismantle, open or repair this product yourself. If a
fault occurs, seek advice from your local qualified service technician or
contact the distributor via the telephone number at the back of this
instruction manual.

14.Caution marking and nameplate are located on bottom of product.

2

This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:

(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including

interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help

To prevent any scratching or damage to your furniture, we strongly
recommend that you purchase small self-adhesive felt pads, available at
hardware stores and home improvement centers everywhere, and apply
these pads to the bottom of the unit before you place the product on any
fine wooden furniture.

SPECIAL NOTE

CAUTION:Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to
operate the equipment.

COMPLIANCE WITH FCC REGULATIONS

3

LOCATION OF CONTROLS

1.Flashlight ON/OFF button

3.LCD Display

4.Volume Up (+) button

5. Solar Panel

6. LED Flashlight

7.Power On/Standby button
8 .Clock/Radio Tune Down button

9.Volume Down (-) Button

10.Radio Mode selection/Clock Set button

11.Weather Alert Indicator

12.Speaker

2 .Clock/Radio Tune Up button

AM / FM / WE ATHER BAN D RECEI VER

ALER T

VOL.

MODE

+

-

VOL.

TUNE

TUNE

1

2

3

4

5

7 8 9

10 12

6

11

4

13.Telescopic Antenna

15.Battery Compartment
16 Rubber Dust Cover.

17. Rubber Dust Cover)Mini USB DC Input Port (located under the

18. Rubber Dust Cover)Charging Indicator (located under the
19 Rubber Dust Cover).USB Charging Port (located under the

20.Headphone Jack (located under the Rubber Dust Cover)
21 Rubber Dust Cover).Power Source Selector (located under the
22 Rubber Dust Cover).Reset button (located under the

23.Crank Handle

14.Metal Hook

14

13

16

15

23

17 18 19 20 21 22

POWER SOURCE

This radio is designed to operate on multiple power sources.
MPORTANT: If you pull the insulation tab out to activate the internal

rechargeable battery and the display does not turn on or the display comes
on, but the radio and flashlight do not work, you will need to reset the unit
using the following procedures.

normal operation. Please see “Resetting the Unit” under CARE AND
MAINTENANCE section of this manual.

1.Press the RESET button on the back and the MR-750 should return to

2
rechargeable battery or use fresh “AAA” batteries.

.If low battery icon appears on the display, fully recharge the internal

5