Jenn-Air JWC2450ACX User Manual

Top View

BUILT-IN UNDER COUNTER WINE CELLAR

PRODUCT DIMENSIONS

INCHES CENTIMETERS

A 34 86 .4

C D

B 34 1/4

35 87.0 - 88.9

C 23 7/8 60 .6

D 22 55.9

E1 24 1/4 61.6

F 34 1/2

/4 87.6 - 89.5

G 24 61.0

H 2 4 61.0

J 25 1/2 64.8

MODEL SKUs

JWC2450ACX

A B

Style of product may vary from picture

NOTES:

1. With 3/4" cabinet panel installed.

2. If door is recessed between cabinets, cabinet cutout must be 24 1/4" wide.

3. Door must open a minimum of 135 degrees to allow wine racks to pull out.

Electrical requirements: Provide for 120 VAC, 60 Hz. The unit must be properly circuit protected and wired according to local electrical codes.

Important: Because of continuing product improvements, Jenn-Air® reserves the right to change specifications without notice. Dimensional specifications are provided for planning purposes only. For complete details see installation instructions that accompany each product before selecting cabinetry, making cutouts or beginning installation.

BUILT-IN UNDER COUNTER WINE CELLAR PANEL

PRODUCT DIMENSIONS

For a 3 1/2" (8.9 cm) Toe Kick

COVERS THE ENTIRE DOOR EXTRUSION

INCHES CENTIMETERS

A 30 5/16 77.0

TO MATCH EXISTING CABINET TOE KICK HEIGHT

For a 4" (10.2 cm) Toe Kick

INCHES CENTIMETERS

Back View

A 29 13/16 75.7

Common Dimensions for Both Applications

INCHES CENTIMETERS

B 23 7/16 59.5

C 15 5/8 39 .7

D 7 13/16 19.8

E 22 1/2 57.2

F 15 5/3 2 38.5

G 7 13/16 19.8

/32 1.8

Style of product may vary from picture

NOTES:

1. A custom handle (not supplied) must be installed. Drill pilot holes through the custom panel to match the handle. Countersink the holes in the back of the panel. Attach the custom handle to the front door panel assembly. The custom handle screws should be installed through custom panel and into the custom handle. The screw heads should be countersunk so the inside panel surface can be installed flush with the wine chiller door.

2. Custom Wood Frame thickness: 5/8" (1.6 cm) - 3/4" (1.9 cm).