JennAir JMW2430IL, JMW3430IM Dimensions Guide

JENNAIR® DETAILED PLANNING DIMENSIONS

30" COMBINATION MICROWAVE/WALL OVENS

JMW2430I, JMW3430I – 30" x 43-3/4" x 25-5/16"

1 of 2

PRODUCT DIMENSIONS

30" (76.2 CM) MODELS

A. 43-3/4" (111 cm) overall height

B. 30" (76.2 cm) overall width

C. JMW2430IM – 26-3/8" (67 cm)

JMW2430IL – 27-3/16" (69 cm) JMW3430IM – 26-3/8" (67 cm) JMW3430IL – 27-3/16" (69 cm)

D. 23-1/4" (59.1 cm) max. recessed depth

E. 41" (104.1 cm) recessed height

F. 48" (121.9 cm) ﬂexible conduit length measured

from the conduit clamp located at the rear of the oven. Do not remove the conduit clamp.

G. 28-7⁄16" (72.2 cm) recessed width

OPENING/CLEARANCE DIMENSIONS

30" (76.2 CM) MODELS

A. 30" (76.2 cm) min. cabinet width

B. 2-1/4" (5.7 cm) top of cutout to bottom of upper cabinet door

C. 19-1/4" (48.9 cm) bottom of cutout to ﬂoor is recommended.

4"–19-1/4" (10.2– 48.9 cm) bottom of cutout to ﬂoor is acceptable.

D. 28-1/2" (72.4 cm) cutout width

E. 1-1/2" (3.8 cm) min. bottom of cutout to top of cabinet door

F. 41-5⁄16" (105 cm)* recommended cutout height

G. 24" (60.7 cm) cutout depth

*NOTE: The cutout height can be between 41" and 41-1/2" (104.1 cm and 105.6 cm) for microwave/oven combination.

IMPORTANT: Dimensional speciﬁcations are provided for planning purposes only. Do not make any cutouts based on this information. Refer to the Installation or Use & Care Guide

before selecting cabinetry, verifying electrical/gas connections, making cutouts or beginning installation. All JennAir® appliances are appropriately UL, CUL or CSA approved.

JENNAIR® DETAILED PLANNING DIMENSIONS

30" COMBINATION MICROWAVE/WALL OVENS

JMW2430I, JMW3430I – 30" x 43-3/4" x 25-5/16"

ELECTRICAL REQUIREMENTS

2 of 2

If codes permit and a separate ground wire is used, it is recommended that a qualiﬁed electrical installer determine that the ground path and the wire gauge are in accordance with local codes.

Check with a qualiﬁed electrical installer if you are not sure the oven is properly grounded.

This oven must be connected to a grounded metal, permanent wiring system.

Be sure that the electrical connection and wire size are adequate and in conformance with the National Electrical Code, ANSI/NFPA 70-latest edition or CSA Standards C22.1-94, Canadian Electrical Code, Part 1 and C22.2 No. O-M91-latest edition, and all local codes and ordinances.

A copy of the above code standards can be obtained from:

National Fire Protection Association

1 Batterymarch Park

Quincy, MA 02169-7471

CSA International

8501 East Pleasant Valley Road

Cleveland, OH 44131-5575

ELECTRICAL CONNECTION

To properly install your oven, you must determine the type of electrical connection you will be using and follow the instructions provided for it here.

• Oven must be connected to the proper electrical voltage, amperage and frequency as speciﬁed on the model/serial/rating plate. See the following illustration.

• Models rated from 7.3 to 9.6 kW at 240 V (5.4 to 7.4 kW at A. Model/Serial/Rating Plate 208 V) require a separate 40 A circuit.

• A circuit breaker is recommended.

• Connect directly to the fused disconnect (or circuit breaker box) through ﬂexible, armored or nonmetallic sheathed, copper cable (with grounding wire).

• Flexible conduit from the oven should be connected directly to the junction box.

• Do not cut the conduit. The length of conduit provided is for serviceability of the oven.

• A UL listed or CSA approved conduit connector must be provided.

• If the house has aluminum wiring, follow the procedure below:

Connect the aluminum wiring using special connectors and/or tools designed and UL listed for joining copper to aluminum.

Follow the electrical connector manufacturer’s recommended procedure. Aluminum/copper connection must conform with local codes and industry-accepted wiring practices.

For power requirements, refer to the following table:

240 VAC 208 VAC

Model kW kW

JMW2430I

JMW3430I

8.0 6.6

8.2 6.6

A. Model/Serial/Rating Plate

IMPORTANT: Dimensional speciﬁcations are provided for planning purposes only. Do not make any cutouts based on this information. Refer to the Installation or Use & Care Guide

before selecting cabinetry, verifying electrical/gas connections, making cutouts or beginning installation. All JennAir® appliances are appropriately UL, CUL or CSA approved.