Jenn-Air CMV1100AAQ, CMV1100AAB, CMV1100AAW Dimension Guide

www.dexpress.com DIMENSION EXPRESS Fax on Demand [phone]

This Data Sheet Includes Information On

Jenn-Air

• Product Model Number (s): •

Over the Range Microwaves:

CMV1100AAQ, CMV1100AAB and CMV1100AAW

• Dimensions (Actual Size) •

Unit height:

Unit depth:

Unit width:

Recommended opening depth:

Recommended opening width:

Mounting height from floor:

17"
14 1/2"
29 7/8"
13"
30"
66" Min.

Minimum mounting height

from cooking surface:

30"

Distance from unit

face to open door:

22 1/2"

• Additional Information •

• Electrical requirements: Voltage 120, single phase,

60Hz. AC. Ampere 15 or 20. 2 wire with ground circuit
required. Locate outlet box in the cabinet above in the
lower right hand corner, cut a 1 1/2" hole in the back
right hand corner of the cabinet above for the units
cord.

• Wall construction should be a minimum of 2"x4" wood

studding and 3/8" thickness drywall or plaster/both.

• Units are designed for use above all Maytag

non-grilling gas and electric ranges and cooktops (not
recommended over grill-ranges or cooktops with grilling
capability unless the range or cooktop is equipped with
downdraft ventilation).

• Outside ventilation requires hood exhaust duct. The

hood exhaust has been designed to mate with a
standard 3 1/4" x 10" duct. If round is required, a
transition adaptor must be used. Do not use less than
6" round duct.

• Maximum duct length: The total duct length of 3 1/4" x

10" or 6" round duct should not exceed 140 equivalent
feet. When calculating the total duct length add
equivalent lengths of all transitions and adaptors plus
the lengths of all straight duct sections.

• 280 Hi/ 180 Low CFM Vertical exhaust (3 1/4" x 10"

duct).

• 300 Hi/ 200 Low CFM Horizontal exhaust (3 1/4" x 10"

duct).
See page 2-3 for additional information

22 1/2"

Door Open

66" Min.

Minimum

mounting

height from

floor

14 1/2"

(not to scale)

30"

Minimum

mounting

height from

cooking
surface

Exhaust outlet

connects to

3 1/4" X 10" duct

29 7/8"

17"

13"

30"

Wall View (not to scale)

Subject to change without notice. This system is designed to
be updated daily if necessary. Dimension Express is not
responsible for use of superseded, voided, or outdated data
sheets. Because of the difficulty or impracticability of deter­mining actual damages, liability of Dimension Express shall
not exceed $50.00.
Copyright © Dimension Express, 2002.

• NEVER reuse Data Sheets. Data Sheets are subject to change without • Call Dimension Express if you have any questions at [phone] •
notice. Dimension Express is a FREE service bureau and is updated daily, • Always refer to a current Code at a Glance or manufacturer directory •
it makes far more sense to spend the time necessary to request new Data • Data Sheet codes change on the first of odd numbered months at 12:01am •
Sheets for each project, as opposed to the problems, time, costs, and risks
associated with reusing old Data Sheets.

191

BN • A191B278C150 • • 032603 • 95659 • 42906

www.dexpress.com

DIMENSION EXPRESS

Fax on Demand [phone]

Additional Information:

• Equivalent lengths of typical duct adaptors: 3 1/4" x 10" 45° elbow =
5 feet straight. 3 1/4" x 10" 90° elbow = 25 feet straight.
3 1/4" x 10" transition to 6" round = 5 feet straight. 6" round 45° elbow
= 5 feet straight. 6" round 90° elbow = 10 feet straight.
6" round wall cap = 40 feet straight. Roof cap = 24 feet straight.

Wall View

(not to scale)

Shaded area must be free of obstruction.

Page 2

This Data Sheet Includes Information On

Jenn-Air

• Product Model Number (s): •

Over the Range Microwaves:

CMV1100AAQ, CMV1100AAB and CMV1100AAW

Grounded
electrical outlet.
Locate power
supply hole in
the rear corner.

30"

17"

30" minimum

2" min.

from cooking
surface

66"
minimum
from floor

Range (or Cooktop) below

Subject to change without notice. This system is designed to be updated daily if necessary. Dimension Express is not responsible for use of superseded, voided, or
outdated data sheets. Because of the difficulty or impracticability of determining actual damages, liability of Dimension Express shall not exceed $50.00.
Copyright © Dimension Express, 2002.

• NEVER reuse Data Sheets. Data Sheets are subject to change without • Call Dimension Express if you have any questions at [phone] •
notice. Dimension Express is a FREE service bureau and is updated daily, • Always refer to a current Code at a Glance or manufacturer directory •
it makes far more sense to spend the time necessary to request new Data • Data Sheet codes change on the first of odd numbered months at 12:01am •
Sheets for each project, as opposed to the problems, time, costs, and risks
associated with reusing old Data Sheets.

BN • A191B278C150 • • 032603 • 95659 • 42906

278