JBL D38 User Manual

Decade
tm
D38, D315
Simple Setup Guide
thank you for choosing JBL. For more than 50 years, JBL has
been involved in every aspect of music and film recording and reproduction, from live performances to monitoring the recordings you play in your home, car or office.
We’re confident that the JBL loudspeakers you have chosen will provide every note of enjoyment that you expected – and that when you think about purchasing additional audio equipment for your home, car or office, you will once again choose JBL.
Please take a moment to complete the enclosed profile card. It enables us to keep you posted on our latest advancements, and helps us to better understand our customers and to build products that meet their needs and expectations.
JBL Consumer Products
one. Speaker Placement
D38
D315
two. Speaker Connections
– +– +
– + – +
Speaker Outputs
RIGHT LEFT
Connection Tips
Speakers and electronics terminals have corresponding (+) and (–) terminals. It is important to connect both speakers identi­cally: (+) on the speaker to (+) on the amplifier and (–) on the speaker to (–) on the amplifier. Wiring “out of phase” results in thin sound, weak bass and a poor stereo image.
Troubleshooting
If there is no sound from any of the speakers, check the following:
• Receiver/amplifier is on and a source is playing.
• Review proper operation of your receiver/amplifier.
If there is no sound coming from one speaker, check the following:
• Check the “Balance” control on your receiver/amplifier.
• Check all wires and connec­tions between receiver/ amplifier and speakers.
• Make sure all wires are connected. Make sure none of the speaker wires are frayed, cut or punctured.
If the system plays at low volumes but shuts off as volume is increased, check the following:
• Check all wires and connec­tions between receiver/ amplifier and speakers.
• Make sure all wires are con­nected. Make sure none of the speaker wires are frayed, cut or punctured.
• If more than one pair of main speakers is being used, check the minimum imped­ance requirements of your receiver/amplifier.
If there is low bass output, check the following:
• Make sure the polarities (+ and –) of the left and right “Speaker Inputs” are connected properly.
Declaration of Conformity
We, JBL Europe A/S
Kongevejen 194B DK-3460 Birkerød DENMARK
declare in own responsibility, that the products described in this owner’s manual are in compliance with technical standards: EN 50081-1:1992 EN 50082-1:1992
Steen Michaelsen
JBL Europe A/S
Birkerød. DENMARK. 9/98
Specifications
A Harman International Company
D38 D315
Frequency Response (–6dB): 50Hz – 20kHz 40Hz – 20kHz
Recommended Maximum
Amplifier Power*: 175 watts 250 watts
Sensitivity @ 1 watt/1 meter:
Nominal Impedance: 8 ohms 8 ohms
Woofer: 8" 15"
Midrange: 4" 4"
Tweeter: 2" 2"
Dimensions (H x W x D): 16-3/4 x 10-3/4 x 12 inches 30-7/8 x 16-1/4 x 11-1/2 inches
Weight (each): 17 lbs/7.7 kg 35 lbs/15.9 kg
92dB 96dB
(425 x 273 x 305mm) (784 x 413 x 292mm)
*The maximum recommended amplifier power rating will ensure proper system head­room to allow for occasional peaks. We do not recommend sustained operation at these maximum power levels.
JBL Consumer Products 250 Crossways Park Drive, Woodbury, NY 11797 8500 Balboa Boulevard, Northridge, CA 91329 1-800-336-4JBL (4525) (USA only) www.jbl.com
1998 JBL, Incorporated.
©
JBL is a registered trademark of JBL, Incorporated. 9/98 Part No.: D38,D315OM
Occasional refinements may be made to existing products without notice, but will always meet or exceed origi­nal specifications unless otherwise stated.
Loading...