Jackson M24STD-6 User Manual

Dishmachine Stand

Installation Instructions

FOR JACKSON MODEL:

M24STD-6

August 7, 2006
P/N 07610-003-26-13 Rev. A

Jackson MSC, INC.

P.O. BOX 1060

HWY. 25E

BARBOURVILLE, KY. 40906

FAX [phone]

PHONE [phone]

www.jacksonmsc.com

M24STD-6 INSTALLATION INSTRUCTIONS

Tools Required:

• Standard Allen wrench set

• Tube of food-grade silicon

• Silicon gun

• Rag

Time Requirements:

It is expected that it will take 30 minutes to

install the M24STD-6 dishmachine stand.

Notes:

• Ensure that the dishmachine stand is

level prior to placing the dishmachine
on the stand.

• Never attempt to lift a dishwasher on

your own. Always use other personnel
to help or the appropriate lifting devices
to prevent accident and injury.

Steps:

• Inspect the assembly to ensure that

there has been no freight damage. If
there is any damage, contact the
freight carrier immediately.

• Your package should contain the fol-

lowing:

• Stand platform weldment

• (4) legs

• Instructions

• If any of these items are missing, im-

mediately contact Jackson Technical
Service at 1-888-800-5672.

• Remove the items from the box.

• Ensure that the set screws are located

within the leg sockets. If they are miss­ing, immediately contact Jackson
Technical Service (See Figure 1).

• Verify that the foot of each leg can be

turned; this is how the stand will be ad­justed in order to level it. Please note
that when assembled, there should be
a minimum of 6” (152.4mm) of space
between the bottom of the stand and
the finished floor.

Figure 1—Leg socket showing set screw

• Place the legs fully into the leg sockets

of the platform and tighten down the
set screws to secure them in place.
(See Figure 2).

• Once all of the legs are tightly in place,

Figure 2—Tightening the legs

flip the dishmachine stand over and set
it down on all four legs. Ensure that the
legs are stable.

• If stable, take a small amount of silicon

and apply it to the set screw to cover
any exposed threads and to fill in the
hole for the Allen wrench. (See Figure

3). Note: do not use excessive
amounts of silicon; only enough to
complete the task.

Installation Instructions 07610-003-26-13

Issued: 08-10-2006 Revised: N/A

2

M24STD-6 INSTALLATION INSTRUCTIONS

Figure 3—Applying silicon

To mount the undercounter dishmachine,

•

remove the feet from the frame bottom by un­screwing them.

•

Set the unit on top of the stand (minus the
feet) on the platform, lining up the holes in the
frame to the corresponding holes in the plat­form.

•

Secure the unit to the platform by rein­serting and tightening the feet.

•

Verify that the unit is level prior to making
any utility connections. If the unit is not level,
it may operate inefficiently.

After Maintenance Actions:

• Wipe down the stand to remove any

excess silicon.
Once the dishmachine is fully hooked

•

up and operational (per the manufac­turer’s instructions), operate the ma­chine and observe it to ensure that
there is no excessive vibration or any
other source of concern.

Preventative Maintenance:

• Keep the area under the platform free

of dirt, soil and debris.
Clean the stand regularly with a wet

•

towel to prevent the build-up of residue
and soil.

Installation Instructions 07610-003-26-13

Issued: 08-10-2006 Revised: N/A

3