
DMX LED Motor Rocket III Manual
Our DMX LED Motor Rocket light offers many possibilities to achieve very nice laser effects which you want. It is
specially designed for the stages, disco, night clubs etc. Please read the manual before operation.
A. SPECIFICATION
1. Power input: AC 110V/240V, 60Hz/50Hz
2. Power consumption: 60W
3. LEDs: 20*3W RGBW(R: 5pcs, G: 5pcs, B: 5pcs, W: 5pcs)
4. Control feature: Built-in programs, auto running, DMX mode, M/S, sound-active mode
5. DMX channels: 3CH
6. Size: 345*345*262mm
7. Weight: 5.2kg
B. OPERATION
This series of product has rich effect programs, easier operation, there are five working modes:
Built-in program
Auto running
DMX mode
M/S mode
Sound active
1. Built-in Program
1) Press “MODE” button, enter built-in program menu “Pr××”
2) Press “UP” or “DOWN” button ,select the effect programs ~
3) Press “SETUP” button, setup speed program menu “SP××”
4) Press “UP” or “DOWN” button ,setup speed value ~ (SP100).
5) Press “SETUP” button, setup flash program menu “FS××”
6) Press “UP” or “DOWN” button ,setup flash value ~ .
2. Auto Running

1) Press “MODE” button, enter auto run mode menu “ ”
2) Press “SETUP” button, setup auto run time’s menu “n×××”
3) Press “UP” or “DOWN” button ,setup auto run times value ~ .
4) Press “SETUP” button, enter auto run speed menu “SP××”
5) Press “UP” or “DOWN” button ,setup speed value ~ (SP100).
6) Press “SETUP” button, enter auto run flash menu “FS××”
7) Press “UP” or “DOWN” button ,setup flash value ~ .
3. DMX Mode
1) Press “MODE” button, enter DMX mode menu “d×××”
2) Press “UP” or “DOWN” button, setup DMX address value ~ .
3) Press “SETUP” button, setup DMX mode
4. M/S Mode
Press “MODE” button, enter the slave mode “SLAV”
5. Sound Active
1) Press “MODE” button, enter sound active mode “SoUn”

2) Press “SETUP” mode, enter sound active sensitivity menu “So××”
3) Press “UP” or “DOWN” button, setup the value of sound active sensitivity ~ .
C. On/off LED Display
1. Press “MODE” button, enter on/off LED display mode “Led”
2. Press “SETUP” button; enter LED display on or off.
3. Press “UP” “DOWN” to setup LED display on or off
Note: When you chose on, LED display always light up. When you chose off, LED display will turn off 20 seconds
later.
D. Convert LED Display
1. Press “MODE” button, enter convert LED display mode “dISP”.
2. Press “SETUP” button, enter convert LED display (standard display “dISP”, covert display “dSIP”.)
E. Version No.
1. Press “MODE” button, enter the version of the software “Ver”.
2. Press “SETUP” button, to show the version No. “V10”.