LAP TRAY
Assembly, Installation, and Operating Instructions
NOTE: Check all parts for shipping damages before using. In case of damage, do NOT use the equipment. Contact the Carrier/ Dealer for further instructions.
SAFETY SUMMARY
WARNING
DO NOT install this equipment without first
reading and understanding this instruction
sheet. If you are unable to understand
these instructions, contact a healthcare
professional, dealer or technical personnel if
applicable before attempting to install this
equipment - otherwise, injury or damage may
occur.
INTRODUCTION
The Lap Trays are fully molded and designed to fit most
wheelchairs. They feature a continuous lip along three (3)
sides to prevent items from sliding off and is designed
without comers or crevices which helps prevent the collection of food and dirt.
The Lap Trays are available in two (2) styles - Clear and
Black. The clear trays are composed of a Thermal Polyester composition that allows surface scratches to be
removed with a heat gun or hair dryer. The Black trays are
made of ABS Plastic. Both styles are extremely durable.
The trays are available with or without a torso cutout.
The tray mounts firmly to the wheelchair by sliding onto
the arm rests. The tray will mount on flat padded (SR -
mounting hardware) or tubular (TR - mounting hard
ware) arm rests.
INSTALLATION (FIGURE 1)
1. Remove Lap Tray/tray rails from packaged container.
2. Measure the distance (outside to outside) at the
front and rear of armrest pads.
3. Subtract this measurement from the width of the Lap
Tray. Refer to the example.
Example:
Width of Lap Tray 24-inches
Armrest Measurement -
4. Take the difference between the two (2) measurements and divide by 2.
Example:
5. Measure the distance from the outside edge of the
Lap Tray toward the inside of the tray rail using the
distance measurement obtained in STEP 4. Perform
this procedure for both sides of the Lap Tray.
6. Position tray rails with the mounting holes that are
closest to the outside of the tray rails at the rear of the tray.
7. Loosely secure the tray rails to the Lap Tray with the
screws provided.
4-inches = 2
2
Difference between the width of the lap tray and
the outside of the armrests divided by two.
REAR
Sling T-nuts
20-inches (minus)
- 4-inches
NOTE: These mounting holes/ screws must be positioned at the rear of the lap tray.
Standard Rail
(Shown)
Desk Arm Pad
Pin Position
NOTE: These
mounting holes/
screws must be
positioned at the
front of the lap
tray.
Full Length Arm
Pad Pin Position
FIGURE 1 - INSTALLATION
Mounting Screws
Sling T-nuts
Tray Rails
FRONT
Install Tray
1
8. Tighten the screws in place and re-check measurement.
9. Open wheelchair and slide the Lap Tray over the armrests.
10. Position stop pins in tray rails according to type of arm
pads on wheelchair (FIGURE 1).
DO NOT continue to use this product if any
deformation, breakage or other problems
should be discovered. Corrective maintenance can be performed at or arranged
through your local Invacare Dealer.
WARNING
The Lap Tray is designed for use with a
MAINTENANCE
wheelchair ONLY. The Lap Tray is NOT designed, however, for use while the wheel-
To maintain the appearance and extend the life of your
Lap Tray:
1. Clean surface weekly with a mild non-abrasive
cleanser and a soft cloth or brush.
chair is being propelled. Wheel locks on the
chair MUST be engaged when the tray is in
use or bodily injury could result. Remove
Lap Tray from the chair before allowing the
chair to be propelled. DO NOT use in con-
2. Visually inspect all parts weekly for deformation, breakage, compression, corrosion and wear.
junction with any other tray or other attachments except those noted.
LIMITED WARRANTY
PLEASE NOTE: THE WARRANTY BELOW HAS BEEN DRAFTED TO COMPLY WITH FEDERAL LAW APPLICABLE TO PRODUCTS MANUFACTURED AFTER JULY 4,1975.
This warranty is extended only to the original purchaser/user of our products.
This warranty gives you specific legal rights and you may also have other legal rights which vary
from state to state.
Invacare warrants its product to be free from defects in materials and workmanship for a period of
two (2) years from date of purchase. If within such warranty period any such product shall be
proven to be defective, such product shall be repaired or replaced, at Invacare’s option. This
warranty does not include any labor or shipping charges incurred in replacement part installation or
repair of any such product. Invacare’s sole obligation and your exclusive remedy under this warranty shall be limited to such repair and/or replacement.
For warranty service, please contact the dealer from whom you purchased your Invacare product. In the event you do not receive satisfactory warranty service, please write directly to
Invacare at the address on the back cover, provide dealer’s name, address, and the date of
purchase, indicate nature of the defect and, if the product is serialized, indicate the serial
number. Do not return products to our factory without our prior consent.
LIMITATIONS AND EXCLUSIONS: THE FOREGOING WARRANTY SHALL NOT APPLY TO SERIAL NUMBERED
PRODUCTS IF THE SERIAL NUMBER HAS BEEN REMOVED OR DEFACED, PRODUCTS SUBJECTED TO
NEGLIGENCE, ACCIDENT, IMPROPER OPERATION, MAINTENANCE OR STORAGE, COMMERCIAL OR
INSTITUTIONAL USE, PRODUCTS MODIFIED WITHOUT INVACARE’S EXPRESS WRITTEN CONSENT (INCLUDING, BUT NOT LIMITED TO, MODIFICATION THROUGH THE USE UNAUTHORIZED PARTS OR ATTACHMENTS;
PRODUCTS DAMAGED BY REASON OF REPAIRS MADE TO ANY COMPONENT WITHOUT THE SPECIFIC
CONSENT OF INVACARE, OR TO A PRODUCT DAMAGED BY CIRCUMSTANCES BEYOND INVACARE’S
CONTROL, AND SUCH EVALUATION WILL BE SOLELY DETERMINED BY INVACARE. THE WARRANTY SHALL
NOT APPLY TO PROBLEMS ARISING FROM NORMAL WEAR OR FAILURE TO ADHERE TO THE FOLLOWING
INSTRUCTIONS.
THE FOREGOING WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER EXPRESS WARRANTIES. IMPLIED WARRANTIES, IF ANY, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE, SHALL NOT EXTEND BEYOND THE DURATION OF THE EXPRESSED WARRANTY PROVIDED HEREIN AND
THE REMEDY FOR VIOLATIONS OF ANY IMPLIED WARRANTY SHALL BE LIMITED TO REPAIR OR REPLACEMENT OF
THE DEFECTIVE PRODUCT PURSUANT TO THE TERMS CONTAINED HEREIN. INVACARE SHALL NOT BE LIABLE FOR
ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES WHATSOEVER. THIS WARRANTY SHALL BE EXTENDED TO
COMPLY WITH STATEIPROVINCIAL LAWS AND REQUIREMENTS.
Invacare Corporation www.invacare.com
USA
One Invacare Way
Elyria, Ohio USA
44036-2125
800-333-6900
Canada
5970 Chedworth Way
Mississauga, Ontario Canada
L5R 3T9
Phone (905) 890-8300,
1-800-668-5324
Fax (905)-890-5244
Invacare is a registered trademark of Invacare
Corporation
© 1999 Invacare Corporation
Form No.91-61 P/N 1036459 Rev. E (1) - 11/99