Invacare 95-2, 95-1, 90-2 User Manual
CareGuard™Shower Chair
Assembly, Installation and Operating Instructions
Model Nos. 95-1, 95-2, 90-2
SAVE THESE INSTRUCTIONS
NOTE: Check all parts for shipping damage. In case of damage, DO NOT use. Contact
Carrier/Invacare for further instructions.
MODEL NO. DESCRIPTION
95-1 One (1) Pack Shower Chair with Back Aluminum Legs
95-2 Two (2) Pack Shower Chair with Back Aluminum Legs
90-2 Two (2) Pack Shower Chair without Back Aluminum Legs
SAFETY SUMMARY
To ensure the safe and proper installation of the CareGuard Shower Chair, these
instructions MUST be followed:
WARNING
DO NOT install this equipment without first reading and understanding this
instruction sheet. If you are unable to understand these Warnings, Cautions
and Instructions, contact a healthcare professional, dealer or technical
personnel if applicable before attempting to install this equipment otherwise, injury or damage may occur.
All four (4) leg tips MUST be in contact with shower/tub floor at all times.
Always inspect the shower chair to ensure that it is properly positioned and
stable before using. DO NOT use if shower chair is wobbly or unstable.
Check leg tips for rips, tears, cracks or wear. If any of these conditions exist,
replace leg tips immediately.
ALWAYS ensure that the snap buttons fully protrude through the same
respective adjustment hole of each adjustable leg before using.
This product should only be used with tub floors wider than 16-inches.
Users with limited physical capabilities should be supervised or assisted when
using the shower chair.
Shower chair is NOT to be used as a transfer bench, transfer device or
climbing device.
These shower chairs (Models 95-1, 95-2, and 90-2) have a weight limitation of
300 lbs (136 kg).
Exercise caution when assembling the chair to avoid pinching.
Invacare products are specifically designed and manufactured for use in con-
junction with Invacare accessories. Accessories designed by other manufacturers have not been tested by Invacare and are not recommended for use
with Invacare products.
For more information regarding Invacare products, parts, and services,
please visit www.invacare.com
Part No 1118360 1 CareGuard™Shower Chair
INSTALLATION WARNING
f
After ANY adjustments, repair or service and BEFORE use, make sure that
all attaching component parts are secure.
For Model Nos. 95-1, 95-2, and 90-2, ensure that the snap buttons fully protrude through the same respective adjustment hole of each adjustable leg
before using. This ensures that the adjustable legs are securely locked in position and an even height adjustment is achieved.
ASSEMBLING THE
SHOWER CHAIR
ATTACHING THE LEGS
NOTE: Refer to WARNINGS in the
SAFETY SUMMARY of this instruction
sheet.
NOTE: For this procedure, refer to
FIGURE 1 and FIGURE 2.
1. Remove all contents from the
package. For Model Nos. 95-1 and
95-2, put backrest to the side and
refer to Installing/Removing the
Backrest on page 4 after attaching
and adjusting the legs.
2. Place seat upside down on a stable
surface (floor, table, etc.).
3. Position one (1) leg over one (1)
socket in the seat and align.
4. Angle the leg slightly so the rear
corner enters the socket first as
shown in FIGURE 1.
STEP 2
STEP 3
STEP 4
Leg
Rear
Corner
Leg
Seat
Socket
Leg
Socket
5. Push the leg down and rotate leg to
front of socket until leg is fully
STEP 5
Leg
seated in socket.
Front o
Socket
FIGURE 1 - ATTACHING THE
LEGS
CareGuard™Shower Chair 2 Part No 1118360
6. Ensure locking tabs are positioned through socket tab windows. Refer to
FIGURE 2.
NOTE: Listen for two (2) audible clicks per leg to indicate tabs are properly engaged.
7. Pull up on the leg to ensure that is has “locked” into place.
8. Visually inspect tab windows to ensure locking tabs are properly engaged.
9. Repeat STEPS 3-5 for the remaining three (3) legs.
CORRECT INCORRECT
Locking
Tab
Legs
Locking
Socket Tab
Window
Socket Tab
Window
Tab
Seat
Locking Tab
FIGURE 2 - LEGS INSERTED
ADJUSTING THE LEG EXTENSIONS
WARNING
Ensure that the shower chair is level and stable before using.
NOTE: Refer to WARNINGS in the SAFETY SUMMARY of this instruction sheet.
NOTE: For this procedure, refer to FIGURE 3.
1. Ensure the legs are attached. Refer to Attaching the Legs on page 2.
2. Place seat and legs upside down so legs are facing up.
3. Select one (1) of the eight (8) adjustment holes located on the leg frame.
4. Depress the snap button and slide the leg extension up or down to the desired
height.
5. Ensure that the snap button protrudes fully through the adjustment hole of the
leg frame. Repeat for the other three (3) legs.
6. Make sure all four (4) legs are adjusted to the same height so that the Shower
Chair sits level.
Part No 1118360 3 CareGuard™Shower Chair
Snap Button
Leg Extension
Adjustment
Holes
FIGURE 3 - ADJUSTING THE LEG EXTENSIONS
INSTALLING/REMOVING THE BACKREST
NOTE: Refer to WARNINGS in the SAFETY SUMMARY of this instruction sheet.
NOTE: For this procedure, refer to FIGURE 4.
INSTALLING
1. Before installing the backrest, attach and adjust the legs so the shower chair is
level. Refer to Attaching the Legs on page 2 and Adjusting the Leg Extensions
on page 3.
2. Position the backrest into the slot on the seat.
3. Push down on the backrest until it sits securely into the seat slot.
4. Check under the seat to ensure the compression tabs on the backrest protrude
beyond the seat slot. If they are visible, the backrest is attached properly. If they
are not, push the backrest further into the seat slot. Refer to Detail “A” in
FIGURE 4.
5. Before using, pull upward on the backrest to ensure the backrest is securely
attached and locked into place.
REMOVING
1. Locate the compression tabs underneath the seat.
2. Depress both compression tabs with one hand.
3. Using the other hand, hold the backrest handle and pull up and away from the
seat.
4. Release the compression tabs to avoid pinching and continue pulling the
backrest up until it is removed from the seat.
CareGuard™Shower Chair 4 Part No 1118360
Backrest Handle
Backrest
DETAIL “A” - COMPRESSION TAB
IN LOCKED POSITION
Compression
Tab
Seat
Backrest in
Installed
Position
Compression
Tab
Compression
Tab
Slot in Seat
for Backrest
Seat
FIGURE 4 - INSTALLING/REMOVING THE BACKREST
CLEANING
NOTE: Before using any cleaning products, test an area on the underside of the seat for any
discoloration or staining.
1. Use water and a mild soap or non-abrasive cleanser to clean the shower chair.
Part No 1118360 5 CareGuard™Shower Chair
LIMITED WARRANTY
PLEASE NOTE: THE WARRANTY BELOW HAS BEEN DRAFTED TO COMPLY
WITH FEDERAL LAW APPLICABLE TO PRODUCTS MANUFACTURED AFTER
JULY 4, 1975.
This warranty is extended only to the original purchaser/user of our product.
This warranty gives you specific legal rights and you may also have other legal rights
which vary from state to state.
Invacare warrants its product to be free from defects in materials and workmanship for
the lifetime of use by original purchaser. If within such warranty period any such
product shall be proven to be defective, such product shall be repaired or replaced, at
Invacare's option. This warranty does not include any labor or shipping charges incurred
in replacement part installation or repair of any such product. Invacare's sole obligation
and your exclusive remedy under this warranty shall be limited to such repair and/or
replacement.
For warranty service, please contact the dealer from whom you purchased your
Invacare product. In the event you do not receive satisfactory warranty service, please
write directly to Invacare at the address on the back page. Provide dealer's name,
address, model number, date of purchase, indicate nature of the defect and, if the
product is serialized, indicate the serial number.
Invacare Corporation will issue a return authorization. The defective unit or parts must
be returned for warranty inspection using the serial number, when applicable, as
identification within thirty (30) days of return authorization date. DO NOT return
products to our factory without our prior consent. C.O.D. shipments will be refused;
please prepay shipping charges.
LIMITATIONS AND EXCLUSIONS: THE WARRANTY SHALL NOT APPLY TO
PROBLEMS ARISING FROM NORMAL WEAR OR FAILURE TO ADHERE TO THE
ENCLOSED INSTRUCTIONS. IN ADDITION, THE FOREGOING WARRANTY
SHALL NOT APPLY TO SERIAL NUMBERED PRODUCTS IF THE SERIAL NUMBER
HAS BEEN REMOVED OR DEFACED; PRODUCTS SUBJECTED TO NEGLIGENCE,
ACCIDENT, IMPROPER OPERATION, IMPROPER MAINTENANCE OR STORAGE;
OR PRODUCTS MODIFIED WITHOUT INVACARE'S EXPRESS WRITTEN
CONSENT INCLUDING, BUT NOT LIMITED TO: MODIFICATION THROUGH THE
USE OF UNAUTHORIZED PARTS OR ATTACHMENTS; PRODUCTS DAMAGED BY
REASON OF REPAIRS MADE TO ANY COMPONENT WITHOUT THE SPECIFIC
CONSENT OF INVACARE; PRODUCTS DAMAGED BY CIRCUMSTANCES
BEYOND INVACARE'S CONTROL; PRODUCTS REPAIRED BY ANYONE OTHER
THAN AN AUTHORIZED INVACARE DEALER. SUCH EVALUATION SHALL BE
SOLELY DETERMINED BY INVACARE.
THE FOREGOING EXPRESS WARRANTY IS EXCLUSIVE AND IN LIEU OF ANY
OTHER WARRANTIES WHATSOEVER, WHETHER EXPRESSED OR IMPLIED,
INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS
FOR A PARTICULAR PURPOSE, AND THE SOLE REMEDY FOR VIOLATIONS OF
ANY WARRANTY WHATSOEVER, SHALL BE LIMITED TO REPAIR OR
REPLACEMENT OF THE DEFECTIVE PRODUCT PURSUANT TO THE TERMS
CONTAINED HEREIN. THE APPLICATION OF ANY IMPLIED WARRANTY
WHATSOEVER SHALL NOT EXTEND BEYOND THE DURATION OF THE
EXPRESS WARRANTY PROVIDED HEREIN. INVACARE SHALL NOT BE LIABLE
FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES WHATSOEVER.
THIS WARRANTY SHALL BE EXTENDED TO COMPLY WITH STATE/
PROVINCIAL LAWS AND REQUIREMENTS.
CareGuard™Shower Chair 6 Part No 1118360
Loading...