Invacare 6908A User Manual

MPR Push Handle Pad Kit - Model 6905A,6907A, 6908A
Assembly, Installation and Operating Instructions
Kit No. 1124321, 1124322
SAVE THESE INSTRUCTIONS
NOTE: Check ALL parts for shipping damage. In case of shipping damage, DO NOT use. Contact Carrier/Dealer for further instruction.
To ensure the safe installation, operation and use of the MPR Push Handle Pad Kit, these instructions MUST be followed:
GENERAL WARNING
DO NOT install or use this equipment without first reading and understanding these instructions. If you are unable to understand the Warnings, Cautions or Instructions, contact a healthcare professional, dealer or technical personnel before attempting to install this equipment - otherwise injury or damage may occur.
INSTALLATION WARNING
After ANY adjustments, repair or service and before use, make sure all attaching hardware is tightened securely - otherwise injury or damage may occur.
MODELS 6905A AND 6907A
Push Handle Pad Kit (Part No. 1124321) contains the following items:
DESCRIPTION QUANTITY
Push Handle Pad 2
REPLACING PUSH HANDLE PADS - MODELS 6905A AND 6907A (FIGURE 1)
1. Remove the two (2) hex screws that secure the push handle to the back frame.
2. Cut the existing push handle pads and remove.
3. Clean the push handle and apply a small amount of dish soap on the push handle.
4. Work the new push handle pads onto the push handle until they are completely in place.
5. Secure the push handle to the back frame using the existing hardware.
Back
Cushion
Push Handle
FIGURE 1 - REPLACING PUSH
HANDLE PADS - MODELS 6905A
AND 6907A
Push Handle
Pads
Hex
Screws
Back
Frame
For more information regarding Invacare products, parts, and services,
please visit: www.invacare.co
Part No. 1125025 1 MPR Push Handle Pad Kit
m
MODEL 6908A
Push Handle Pad Kit (Part No. 1124322) contains the following items:
DESCRIPTION QUANTITY
Push Handle Pad 2
REPLACING THE PUSH HANDLE PADS - MODEL 6908A (FIGURE 2)
1. Remove the top two (2) hex screws that secure the push handle to the
Push Handle
Pad
seat frame.
2. Remove the push handle and cut either of the two (2) EXISTING push handle pads that are damaged or worn, and remove.
Push
Handle
Back
Frame
Recline
Lever
Push
Handle
Pad
3. Clean the push handle and apply a small amount of dish soap on the push handle.
4. Note the cut outs on the NEW push handle pads. They must seat on the underside of the push handle and fit
FIGURE 2 - REPLACING THE PUSH
HANDLE PADS - MODEL 6908A
Hex Screws
around the recline lever.
5. Work the NEW push handle pad onto the push handle until it is completely in place.
6. Using the two (2) existing hex head screws secure the push handle to the back frame and securely tighten.
Invacare Corporation www.invacare.com
USA Canada
One Invacare Way 570 Matheson Blvd E Unit 8 Invacare is a registered trademark of Elyria, Ohio USA Mississauga Ontario Invacare Corporation. 44036-2125 L4Z4G4 Canada Yes, you can. is a trademark of Invacare 800-333-6900 800-668-5324 Corporation.
© 2004 Invacare Corporation Part No. 1125025 Rev A - 3/04
Loading...