P/N 064214-004
™
TRAKKER® Antares
2400 Series
Vehicle-Mount Holder Instruction Sheet
The vehicle-mount holder is a convenient way to use and store the TRAKKER Antares 2420 or
2425 terminal on a vehicle. It is designed to attach to a vertical or horizontal surface and will
securely hold your terminal when the vehicle is moving.
The vehicle-mount holder is a two-piece unit consisting of a locking swivel stand and a terminal
holder that is lined with a removable foam insert. Also included is an Allen wrench for adjusting
the stand. The mounting hardware (bolts, nuts, and washers) is not supplied.
To order a replacement foam insert, contact your local Intermec representative.
Adjusting the Locking
Swivel Stand
An Allen wrench is included to
I/O
F5
F1
F4
F2
F3
7
8
9
5
4
6
2
1
3
0
Fn R
Fn L
Enter
C
A
DE
B
H
F
IJ
G
L
K
NO
M
PQRST
UZVWXY
Esc
Tab
adjust the locking swivel stand.
Loosen the ball joint screws using
the Allen wrench and adjust to the
desired position. Tighten the screws
.
to 60 in-lb (6.78 N
m) to secure the
stand.
Allen
wrench
Locking swivel
stand
Ball joint
screw
242XI.001
Removable
foam insert
Terminal
holder
Installation Tips
When you attach the vehicle-mount
holder to a vehicle, make sure there
is enough clearance to insert or
remove the terminal from the holder.
All mounting hardware (bolts, nuts,
washers, etc.) should be of sufficient
strength to secure the vehicle-mount
holder in place.
Use the vehicle-mount holder’s base
as a template for the screw position.
The holes are 2 inches (5.08 cm) apart
and use No. 8 (M3.5) screws.
Attaching to Plastic
If you attach the vehicle-mount
holder to a plastic dashboard or
console, position an aluminum or
steel plate behind the plastic to
secure it to the vehicle.
Tip: Use a metal plate with pressed-in
nuts if dashboard space is tight.
Locking swivel
stand
Vehicle-mount
holder base
Plastic
dashboard
Metal plate
(not included)
242XI.004
Clamping to a Post
To clamp the vehicle-mount holder to a post, first attach it to a separate metal
plate. This metal plate should have counter-recessed holes where the vehiclemount holder base attaches so it will fit flat against the post. Then drill four
holes in the metal plate positioned wider than the post.
Place a second metal plate (with the same hole pattern) on one side of a post
and the metal plate with the vehicle-mount holder on the other side. Use
bolts and nuts to connect the two metal plates together with the post in
between.
Vehicle-mount
holder base
Post
242XI.005
Metal plates
(not included)
6001 36th Avenue West
P.O. Box 4280
Everett, WA 98203-9280
© 1998 Intermec
All Rights Reserved
P/N 064214-004
Loading...