OPERATING MANUAL
R E M O T E
MICROPHONE
RM-01
SAFETY INSTRUCTION
In order to correct operation this unit, keep away this microphone from following places.
• Avoid placing it in direct sunlight or close to a source of heat, such as heater, stoves or other
appliance that produce heat.
• Also avoid location subject to vibration and excessive dust.
• Keep away from magnetized appliance.
• This microphone should be situated so that its location or position does not interfere with its proper
ventilation.
• This unit should be situated away from solvents or alcohol or other material that can make fire.
• This microphone should be cleaned with dried soft cloth.
FEATURES
• This microphone built in unit which range is from 60Hz to 18,000Hz.
• Zn diecasting stand can decrease touch noise.
• This microphone can broadcasting with using remote chime, or remote talk switch.
CONNECTION FOR REMOTE CHIME
• After opening the cover of the stand bottom, connect the Receiver or the Remote Chime for the
system to the 2P terminal block.
NAME OF GOOSE NECK ASS’Y
?? ? ? ? ? ?
1. WIND SCREEN
2. UNIT
This unit which range is from 60Hz to 16,000Hz can make sound.
3. UNIT BASE
This base settles unit, and made of aluminium ware to protect goose neck not to be lower.
4. GOOSE NECK
This goose neck can adjust the direct of unit without moving stand.
5. CONNECTOR HOLDER
This case is in order to connect stand to connector.
6. 3P CONNECTOR
XLR connector of stand.
7. WRENCH BOLT
This screw solidifies mounting between goose neck and connector holder.
NAME OF STAND ASS’Y
10 20 50 100 200 500 1000 2000 5000 10000 20000 40000
-20
-30
-40
-10
0
10
-10
-15
-20
-5
0
5
dB
FREQUENCY Hz
?
?
?
?
?
1. RUBBER FOOT
This rubber foot of stand avoid sliding on the glass or table.
2. STAND
This stand made of heavy Zn diecasting which can minimize touch noise.
3. STAND COVER
4. RECEPTACLE
Input signal through 3p connector of goose neck becomes sound at this part of stand ass’y.
5. TALK SWITCH
After press talk switch, the microphone does work and press again is off.
6. TERMINAL BLOCK
This block is connected with remote chime. For connecting remote chime, after open stand cover
connect it with ? driver.
7. CHIME SWITCH
If the chime appliance is connected with the terminal block, can produce sound.
?
?
POLAR PATTERN & RESPONSE
POLAR PATTERN RESPONSE
BLOCK DIAGRAM
SPECIFICATIONS
• POLAR PATTERN .....................................................................................................UNIDIRECTIONAL
• TYPE...............................................................................................................MOVING COIL DYNAMIC
• SENSITIVITY/IMPEDANCE.......................................................–75, ±3dB(0dB=1V/Pa at 1KHz), 400Ω
• FREQUENCY RANGE ........................................................................................................60Hz~18KHz
• MAX. SPL FOR 0.5% THD .................................................................................................130dB(1KHz)
• WEIGHT ..........................................................................................................................................1.4Kg
• DIMENSIONS...............................................................................................90(W)? 45(H)? 133(D) mm
*Specifications and design subject to change without notice for improvements.
MADE IN KOREA
NO: 9007907210
Loading...