BOXNUC6CAYH
Intel NUC Kit NUC6CAYH User Guide
Intel®
User
NUC Kit
Guide
NUC6CAYH
Regulatory Model NUC6CAY
1
Intel NUC Kit NUC6CAYH User Guide
Before You Begin
CAUTIONS
The procedures in this user guide assume familiarity with the general terminology associated with
personal computers and with the safety practices and regulatory compliance required for using
and modifying electronic equipment.
Disconnect the computer from its power source and from any telecommunications link or network before
performing any of the procedures described in this guide. Failure to disconnect power,
telecommunications links, or networks before you open the computer or perform any procedures can
result in personal injury or equipment damage. Some circuitry on the board can continue to operate
even though the front panel power button is off.
Follow these guidelines before you begin:
Always follow the steps in each procedure in the correct order.
Set up a log to record information about your computer, such as model, serial numbers,
installed options, and configuration information.
Electrostatic discharge (ESD) can damage components. Perform the procedures described in
this chapter only at an ESD workstation using an antistatic wrist strap and a conductive foam
pad. If such a station is not available, you can provide some ESD protection by wearing an
antistatic wrist strap and attaching it to a metal part of the computer chassis.
Installation Precautions
When you install and test the Intel NUC, observe all warnings and cautions in the installation
instructions.
To avoid injury, be careful of:
Sharp pins on connectors
Sharp pins on circuit boards
Rough edges and sharp corners on the chassis
Hot components (such as SSDs, processors, voltage regulators, and heat sinks)
Damage to wires that could cause a short circuit
Observe all warnings and cautions that instruct you to refer computer servicing to qualified
technical personnel.
Observe Safety and Regulatory Requirements
If you do not follow these instructions, you increase your safety risk and the possibility of
noncompliance with regional laws and regulations.
2
Intel NUC Kit NUC6CAYH User Guide
This guide tells you how to:
• Install a different wireless card (optional)
• Install and remove memory
• Install a 2.5” drive
• Install a VESA mount bracket (optional)
• Connect power
• Install an operating system
• Install the latest drivers
Open the Intel NUC Chassis
To open the Intel NUC chassis, follow these steps:
1. Unscrew the four corner screws on the bottom cover of the chassis and lift the cover.
Install a Different Wireless Card (Optional)
The Intel NUC Kit NUC6CAYH includes a pre-installed Intel® Dual Band Wireless-AC 3168 wireless card. If
you choose to install a different card, it needs to be an M.2 2230 form factor.
Only the following wireless adapters have been evaluated for regulatory compliance for use with the Intel
NUC Kit NUC6CAYH in all regions:
Intel® Dual Band Wireless-AC 3165
Intel® Dual Band Wireless-AC 7265
The operation of any other wireless adapter with Intel® NUC Kit NUC6CAYH, other than those listed above,
may violate regulatory compliance requirements for your region.
For more information on wireless adapters, go to: http://www.intel.com/support/wireless/wlan.
3
Loading...