FOODSERVICE DISPOSER
Installation Manual
www.insinkerator.com
The Danger signal indicates an immediately hazardous situation which, if not
avoided, will result in death or serious injury.
The Warning signal alerts you to potential hazards or unsafe practices which,
if not avoided, could result in severe personal injury or death.
The Caution signal alerts you to hazards of unsafe practices which, if not avoided,
may result in minor personal injury or property damage.
Please be certain that the person who installs or uses this appliance carefully reads
and understands the Safety Instructions contained in this manual.
Part No. 13954 - December 2007
Table of Contents
Introduction
Introduction .................................................................................... 3
Clean the Drain Line ....................................................................... 3
Typical Installation .......................................................................... 3
Required Tools/Materials ................................................................
Installing the Disposer
Disposer Mounting ......................................................................... 4
Mounting Adaptors ........................................................................ 4
Standard InSinkErator Mountings
#5 Mounting Assembly .................................................................. 5
#6, 7, and Sink Bowl Mounting Assemblies ................................... 6
Special InSinkErator Mountings ................................................................. 6
Plumbing Connections
Drain Line Connections .................................................................. 7
Water Supply Connections ............................................................ 7
Routing Water Flow ......................................................................... 7
3
Standard Motor Connection Wiring Diagrams .......................................... 8
Electrical Connections
Electrical Connections ................................................................... 9
Disposer Controls ........................................................................... 9
Operating Instructions
Operating the Disposer ................................................................ 10
Grinding Tips ................................................................................ 10
Troubleshooting .......................................................................................... 11
Warranty
FOODSERVICE DISPOSER LIMITED WARRANTY
The InSinkErator® Foodservice Disposers are warranted against defects in material and workmanship for one year
from the date of installation. The warranty includes parts and labor, provided the service is performed by an
InSinkErator Factory Authorized Service Center. This warranty does not apply if failure is due to: faulty or improper
electrical installation, faulty or improper plumbing installation, product abuse or misuse, accidental damage, grinding
elements jammed by foreign objects, clogged drain lines, or an improperly sized unit (as specified by InSinkErator).
InSinkErator Foodservice disposer accessories are included in this warranty only if they are included in the original
disposer purchase package.
2
Introduction
INTRODUCTION
The InSinkErator Foodservice food waste disposer is
UL® and CSA® Listed when installed in conjunction with
InSinkErator mounting adaptors and controls (see Figure
1 for typical installation).
See Table 1 (page 4) for the approved disposer/
mounting adaptor combinations. See Table 3 (page 9)
for the approved disposer/control combinations.
Important – These installation instructions are for
the benefit of the installing contractor. InSinkErator
and/or InSinkErator Factory Authorized Service
Centers do not make original installations. For technical
information not covered in these instructions,
contact the supplier, an InSinkErator Field Sales
Representative, or InSinkErator Foodservice Sales
and Service at 1-800-845-8345.
CLEAN THE DRAIN LINE
With a drain line auger, clear away all hardened waste
material in the horizontal drain pipe running from the
drain trap to the main waste line.
TYPICAL INSTALLATION
A typical Foodservice disposer installation incorporates
the following connections (see Figures 1 and/or 9):
• Water shut off valve
• Syphon breaker
• Solenoid valve
• Start/stop switch (Control Center)
• Sink or trough
• Flow control valve
REQUIRED TOOLS/MATERIALS
The following items are needed to install the disposer:
• Screwdriver
• Adjustable wrench
• Pipe wrench
• Wire nuts
• 7/16" nut driver
The following items may be needed to install
the disposer:
• Plumbing putty
• Hacksaw
• Drain auger
Figure 1. Typical Installation
3
Installing the Disposer
613/16"
73/8"
73/4"
61/2"
23/4"
/
4
/4
187/16"
2"
65/8"
24 "
TO
32 "
(WITH
OPTIONAL
LEGS
INSTALLED)
65/8"
613/16"
47/8"
63/8"
11/2"
33/8"
61/2"
1
/
2
1
711/16"
17"
24 "
TO
33 "
(WITH
OPTIONAL
LEGS
INSTALLED)
65/8"
5
83/4"
83/4"
71/8"
61/2"
13"
233/4"
311/8"
3"
/
4
5
PERSONAL INJURY
• For safe operation, install the disposer in
compliance with the minimum distance illustrated
in Figure 2.
• Disposer must be properly installed to prevent
serious injury from moving shredder part.
DISPOSER MOUNTING
PROPERTY DAMAGE
To avoid excess vibration, InSinkErator
recommends a minimum countertop thickness
of 16 gage stainless steel.
Figure 2. Distance from Table Top to Mounting Flange
MOUNTING ADAPTORS
There are two adaptor categories for mounting InSinkErator disposers: Standard & Special Mountings.
Table 1 displays the approved disposer/mounting adaptor combinations.
Adaptor SS-50 SS-75 SS-100 SS-125 SS-150 SS-200 SS-300 SS-500 SS-750 SS-1000
12" Sink
15" Sink
18" Sink
No. 5
No. 5 short
No. 6
No. 7
Outward
Flange
Inward
Flange
Straight
SPECIAL STANDARD
Flange
Table 1. Foodservice Disposer/Mounting Adaptor Combinations
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
O
O
X
X
X
X
X
X
X
X
O
O
X
X
X
X
X
X
X
X
O
O
X
X
X
X
X
X= Approved
O= Not Allowed
(will void warranty)
X
X
X
O
O
X
X
X
X
X
4