Insinkerator Kits Installation Manual
Commercial
Products Group
INSTALLATION INSTRUCTIONS
Throat Guard Kit (# 13620)
This adaptor will fit a sink opening of:
6-5/8" ID and 7-1/8" OD
Part Numbers
Commercial
Products Group
Code
No.
Part
No. Qty Description
1 13500 1 Throat Guard
2 11292 1 Flat Rubber Gasket
3 3135 6 Capscrew
INSTALLATION INSTRUCTIONS (Suggested Assembly Method)
Note: The throat guard kit is to be used with Mounting Adaptor (11599E).
1. Place mounting flange up over the sink bowl connection lip. It may require a slight force fit.
2. Push mounting flange up out of the way and fit mounting gasket onto the sink bowl connection lip.
3. Move mounting flange down over the mounting gasket. Be certain that the threaded fasteners in
the mounting flange fit into recesses in the top of the mounting gasket.
4. Attach two screws (3) through opposite holes in the flat rubber gasket (2), throat guard (1),
mounting gasket and into the threaded fasteners in the mounting flange. The screws (3) should
be protruding about ΒΌ-inch below the flat rubber gasket (2)
5. Position the disposer beneath the flat rubber gasket (2) and engage the two protruding screws in
the keyhole slots in the disposer body flange. Assemble the remaining screws (3) and turn the
disposer into place for plumbing connections. Tighten all screws evenly to secure the unit.
PART NO. 14043 (REV. 10/31/97)
Loading...