In Sink Erator ISE100, ISE200 User Manual
1
The Evolution series by InSinkErator® is a new standard in sound and grind
performance. Featuring exclusive patented SoundSeal™ and MultiGrind™
technologies, no food waste disposer grinds more with less noise.
Installation
Manual
www.insinkerator.com
2
A
1
N
M
B
D
E
F
I
G
J
K
Stopper
Quiet Collar™
Sink Baffle
C
Sink Flange
Fiber Gasket
Backup Flange
Mounting Ring
1 1/2" Screws
H
1 1/8" Screws
Snap Ring
Jam-Buster®Wrench
Hose Clamp
L
Discharge Tube
Discharge Tube
Disposer
Lower Mounting Ring
Anti-Vibration Mount™
Dishwasher Inlet
Anti-Vibration
Tailpipe Mount™
Plumbers putty
Wire
Connectors
Cable Connector
Tools and Materials (not included)
O
Bio-Charge™ Bottle
P
Extension Tube
A
2
Stopper
(Cover Control Stopper
differs from standard
disposer stopper.)
(Included only with
the Cover Control Model)
(Included only with
the SepticAssist Model)
or
Parts Included:
D
E
C
B
A
Model A B C D E
Excel
6 11/16" 4" 13 1/2" 9" 5 3/4"
Premier
6 11/16" 4" 12 5/8" 8 3/4" 5 3/4"
Essential
6 11/16" 4" 12 5/8" 8 3/4" 5 3/4"
Compact
6" 4" 12 1/8" 8" 5 3/4"
Space Saver
6" 4" 12 1/8" 8" 5 3/4"
Cover Control
6 11/16" 4" 13 1/2" 10" 5 3/4"
SepticAssist
6 11/16" 4" 12 5/8" 8 3/4" 5 3/4"
Dimensions:
3
5
!
*
2
!
Falling Hazard
WARNING
3
K
4
!
*
Removal of old disposer:
Disconnect drain trap from waste
discharge tube. Disconnect
dishwasher if connected to the
disposer.
Support disposer, insert end of
Jam-Buster
®
wrench (K) into
right side of mounting lug, and
turn. Disposer will fall free.
*WARNING: SHOCK HAZARD
With the electrical supply turned
off, flip disposer over and remove
electrical cover plate. Save cable
connector if applicable.
*WARNING: SHOCK HAZARD
With the electrical supply turned
off, disconnect the disposer wires
from the electrical supply.
If the new disposer mount-
ing is the same as the old one,
you can go to step 15. Note:
For sinks thicker than 3/8”, you
will need to replace existing 1
1/2” screws with 1 1/8” screws
(H). See step 14.
SHOCK HAZARD
Turn off electric power at
fuse box or circuit breaker.
W A R N I N G
6
Loosen the 3 screws on the
mounting assembly.
7
8
9
Using a screwdriver, remove the
snap ring.
Remove flange from sink. Remove old plumber’s putty from
sink with putty knife.
1
If you are replacing
an existing disposer,
continue to Step 2.
If there is no existing
disposer, disconnect
sink drain and skip to
Step 10.
4
Loading...