Insignia NS-SCR116 Quick Setup Manual
PACKAGE CONTENTS
• Projector screen
• Inatable frame
• Tethers (4 long, 4 short)
• Pump stakes (2)
2 Align the intake tube on the back of the frame with the mouth
of the inator pump, then wrap the attached strap around the
mouth of the pump and attach tightly.
3 Attach the four long tethers to the upper X-shaped straps on
each side of the frame (two on each side).
QUICK SETUP GUIDE
96” Outdoor
Inflatable
Screen
NS-SCR116
• Pump
• Tether stakes (14)
• Storage bag
• Quick Setup Guide
YOU’LL NEED
• Hammer
• Projector
• Sound system (Built-in projector speakers may not provide loud
enough audio outdoors.)
FEATURES
Frame
Screen
Tethers
Attaching the screen
• Connect the clips along the edges and corners of the frame to
the screen.
Inating the screen
1 Make sure that the air intake is clear of obstructions and that
the frame’s zipper is closed completely.
To p Bottom
Long tethers
4 Attach the four short tethers to the lower X-shaped straps on
each side of the frame (two on each side).
To p Bottom
Short tethers
5 Stand the inatable screen upright, then insert the yellow
tether stakes through the tethers and into the ground. Make
sure that the tethers are taut.
Pump
Tether stakes
Pump stakes
SETTING UP YOUR SCREEN
Attaching the pump
1 Lay out the deated frame on a at surface that is clear of debris.
Make sure that the side with the clips faces up.
Note: Select a location where the pump is well-ventilated and the power cord
can reach a power outlet.
Intake tube
To p Bottom
2 Plug the pump’s power cord into a power outlet to inate the
frame.
Note: The pump must be left running while screen is in use.
Tether stakes
6 Insert the two orange pump stakes through the plastic legs of
the pump to secure the pump to the ground.
Pump stakes
Before using your new product, please read these instructions to prevent any damage.
USING YOUR SCREEN
• Aim your projector at the front of the screen. The screen is not
intended for rear projection.
• You can run the pump continuously. However, turn the pump
o when leaving it unattended.
Weather restrictions
• You can use your screen in light weather conditions like
gentle rain or snow. Use during extreme weather conditions
isn’t recommended.
• Do not use in temperatures below 14°F (-10°C).
• Do not use in winds higher than 20 mph (32.2 km/h).
STORING YOUR SCREEN
1 Remove the stakes from the ground and unclip the tethers.
2 Unplug the pump and open the zipper (in the back near the
bottom) to deate your screen.
3 Disconnect the air intake tube from the pump.
4 Unclip the screen from the frame.
5 Carefully fold the frame and screen and store them in the
included carrying case.
MAINTAINING YOUR SCREEN
Frame
• Check the product at regular intervals for any signs of damage
or deterioration. Damage or deterioration could cause the
product to become unstable and a signicant safety hazard.
• If any part is damaged or deteriorated, stop use and contact
the manufacturer.
• Regularly check the condition of the ground stakes that hold
the screen in place. Damage to or deterioration of the stakes
could result in the screen becoming unstable and could result
in serious injury.
Screen
• Wipe the screen with a dry or damp cloth. Use only water or a
neutral, inammable, nontoxic cleaning and sanitizing
solution.
• If water has soaked the screen, move it to a dry location, then
plug in the pump. The fan will dry your screen.
• If the inatable is covered in a light dusting of snow,
re-ination should not harm it. However, if it has been
subjected to a large amount of snow or ice, do not re-inate it.
Instead, carefully remove the screen from the extreme
conditions (such as bring it indoors) and allow it to thaw
before re-inating. This helps prevent cracks in the material.
Do not use in temperatures below 14°F (-10°C).
• Check the screen regularly for holes or other damage. DO NOT
use a damaged product. Use of a damaged product could
result in injury.
Pump
• Do not clean the pump with a chemical solution as this may damage
the coating and plastic parts. Never clean the pump in water.
• Use a dry cloth to clean the foot holes and remove debris after each
use.
• Store the pump in a dry, indoor place that is unreachable by children.
• Regularly check the condition of the pump stakes. Damage to or
deterioration of the stakes could result in the pump becoming
unstable which could result in serious injury.
• Regularly check the condition of the pump’s power cord. Damage to
or deterioration of the cord could cause a serious electrocution
hazard. If the cord is damaged or deteriorated, immediately
discontinue use of the pump and contact the manufacturer.
To keep the power cord in good condition, hand-support the product
when carrying. Do not twist the cord.
TROUBLESHOOTING
The frame will not inate.
• Make sure that the pump is connected to a working power outlet.
The pump must stay on for the frame to stay inated.
• The zipper that seals the inatable may not be completely closed.
Make sure that the zipper is closed.
• The air-intake area may become clogged with grass, leaves, or other
debris. For best results, check this area and remove any debris.
• The hanging fabric of a partially-inated frame can become attached
to the motor’s air intake area. Make sure that that fabric is not
hanging near the motor during ination.
• Check for rips in the fabric. You can hand sew rips with any type of
thread or cover the tear with clear packing tape.
• Make sure that the connection between the inatable and fan is
secure.
• The temperature may be below 14°F (-10°C). Remove the unit from
extreme temperatures until weather conditions improve.
The frame is torn.
• You can hand sew rips with any type of thread or cover the tear with
clear packing tape.
The frame deates after unplugging the pump.
• This is normal. The screen will not stay inated unless the pump is
turned on.
SPECIFICATIONS
• Dimensions (inated): 82 H × 92 W × 25 D in. (208.3 × 233.7 × 63.5 cm)
• Weight: 24 lbs. (10.9 kg)
• Electrical rating: 110-120V AC, 60 Hz, 0.8A
SAFETY INFORMATION
READ ALL INSTRUCTIONS BEFORE ASSEMBLING THIS INFLATABLE DEVICE AND
KEEP INSTRUCTIONS FOR FUTURE USE.
FAILURE TO FOLLOW THESE WARNINGS AND INSTRUCTIONS CAN RESULT IN
SERIOUS INJURY OR DEATH TO USERS, ESPECIALLY CHILDREN.
WARNING
• Keep children in your direct sight, stay close, and actively supervise them when they
are near this inatable. Assign an adult to supervise the inatable.
• Empty the inatable or prevent access to it when not in use.
• Store the empty inatable in a way that it does not collect water.
• Do not use in winds more than 20 mph.
Electrocution Risk:
• Keep all electrical lines, radios, speakers, and other electrical appliances away from
the inatable.
• Do not place the inatable near or under overhead electrical lines.
• Do not use extension cords with this product.
PUMP WARNINGS:
This product is only to be used for inating the inatable projector screen. Household
Use Only.
• Electrical current requirements: 110-120VAC/60Hz
• The power supply to the pump should include a grounding plug.
• The power cord to the pump should be clearly marked, so that persons using lawn
mowers or other types of equipment are aware that there is a cord on the ground.
• The pump should never be left unattended when in use. The pump is not to be used
by children.
• No objects should cover the air intake when the pump is in use. Sand, small stones,
or other objects should not be allowed to be sucked into the pump.
• Under no circumstances should a nger or any sharp object be inserted into the air
intake.
• The power supply to the pump should not be exchanged for any other type of
supply. If the power supply is damaged, it should be repaired by a technician.
• To avoid the danger of electrical shock, do not immerse the pump in water.
• Do not use extension cords as this would present an electrocution hazard.
• Do not leave the pump exposed to strong sunlight.
• Operation of the pump is not recommended for children under 14 years of age. As
with all electric products, precautions should be observed during handling and use
to prevent electric shock.
• Children should not touch the pump. Children must not play on the product.
• Children should not attach foreign objects to the pump that are not specically
designed for use with the pump, such as, but not limited to jump ropes, clothesline,
pet leashes, cables, and chains as they may cause a strangulation hazard.
• Sudden gusts of wind may lift the inatable o of the ground.
• Pumps and electrical cords should be kept out of reach.
• To avoid electrical shock, never plug in or unplug the pump with wet hands.
• The power supply should be disconnected if the pump or the inatable needs to be
moved.
• To reduce the risk of re or electric shock, do not use this pump with any solid-state
speed control device.
• Do not operate the pump with a damaged cord or plug. Discard pump or return to
an authorized service facility for examination and/or repair.
• Do not run the cord under carpeting. Do not cover cord with throw rugs,
runners, or similar coverings. Do not route cord under furniture or appliances.
Grounding instructions:
• This product should be grounded. In the event of an electrical short circuit,
grounding reduces the risk of electric shock by providing an escape wire for the
electric current. This product is equipped with a cord containing a grounding
wire with an appropriate grounding plug. The plug must be plugged into an
outlet that is properly installed and grounded in accordance with all local codes
and ordinances.
• DANGER – Improper installation of the grounding plug can result in a risk of
electric shock. If repair or replacement of the cord or plug is necessary, do not
connect the grounding wire to either at blade terminal. The wire with
insulation having a green outer surface with or without yellow stripes is the
grounding wire.
• Check with a qualied electrician or serviceman if the grounding instructions
are not completely understood or if in doubt as to whether the product is
properly grounded. Do not modify the plug provided. If it will not t the outlet,
have the proper outlet installed by a qualied electrician.
• This product is for use on a nominal 120V circuit and has a grounding plug
similar to the plug illustrated. Only connect the product to an outlet having the
same conguration as the plug. Do not use an adapter with this product.
Grounding methods
GROUNDED
OUTLET
GROUNDING
PIN
GROUNDED
OUTLET BOX
ONE-YEAR LIMITED WARRANTY
Visit www.insigniaproducts.com for details.
CONTACT INSIGNIA:
For customer service, call 1-877-467-4289 (U.S. and Canada) or 01-800-926-3000
(Mexico) www.insigniaproducts.com
INSIGNIA is a trademark of Best Buy and its aliated companies
Distributed by Best Buy Purchasing, LLC
7601 Penn Ave South, Richeld, MN 55423 U.S.A.
©2016 Best Buy. All rights reserved
Made in China
V1 ENGLISH 16-0493
Loading...