Insignia NS-MG1205-C User Manual
68” Metal and
Glass TV Stand
NS-MG1205-C
USER GUIDE
SAFETY INFORMATION AND SPECIFICATIONS....2
PACKAGE CONTENTS: PARTS.....................................3
PACKAGE CONTENTS: HARDWARE..........................4
ASSEMBLY INSTRUCTIONS.........................................5
CARE AND MAINTENANCE...................................... 16
Before using your new product, please read these instructions to prevent any damage.
68” METAL AND GLASS TV STAND
Maximum weight: 300 lbs. (136.4 kg)
Maximum screen size: 68" diagonal
Overall dimensions (W × H × D):
68 × 19.75 × 19.75" (172.7 × 50.2 × 50.2 cm)
68 in. (172.7 cm)
19.75 in. (50.17 cm)
19.75 in. (50.2 cm)
Phillips screwdriver
Drill
SAFETY INFORMATION AND SPECIFICATIONS
CAUTION: The top surface of this stand
is designed for use with a product
weighing no more than
300 lbs. (136.4 kg) and having a 68"
wide flat-panel TV dimensions permits
it to sit evenly on the stand with no more than a
one-inch overhang on each side of the shelf. Use
with products that weigh more than the maximum
weight allowed, or with dimensions that extend
beyond the maximum width may result in
instability, which may result in injury.
CAUTION: This product contains small
items that could be a choking hazard if
swallowed.
Keep these items away from young children!
Model #: NS-MG1205-C
Tools needed:
2
www.insigniaproducts.com
68” METAL AND GLASS TV STAND
A Front Support (1)
B Front base (1)
C Back base (1) D Left base (1)
E Right base (1) F Rear support panel (1) G Top shelf (1 )
I Middle shelf (1) R Top frame (1)J Bottom shelf (1)
H Pillar support (2)
Note: The front base
has one screw tab on
each end.
Note: The back
base has two screw
tabs on each end.
PACKAGE CONTENTS: PARTS
www.insigniaproducts.com
3
PACKAGE CONTENTS: HARDWARE
Label Hardware Qty.
K6
L2
M16
N6
Foot
Medium screw 1 1/4" (33 mm)
Short screw 3/4" (19 mm)
Long screw 1 3/4" (45 mm)
An optional anti-tipping hardware kit is included.
Instructions on how to install the hardware are
included on the bag containing the kit.
Label Hardware Qty.
O4
P2
Q1
S2
Suction cup
Clamp screw
Allen wrench
Shelf pad
Note: You may receive extra hardware.
Make sure that you have all of the hardware necessary to assemble your new TV stand:
68” METAL AND GLASS TV STAND
4
1234in
10 20 30 40 50 60 70 80 90 1 00mm
www.insigniaproducts.com
68” METAL AND GLASS TV STAND
O (4)
ASSEMBLY INSTRUCTIONS
Step 1: Preparing the bases
• Insert two suctions cups into the front base (B) and two suctions cups in the back base (C).
You’ll need:
www.insigniaproducts.com
5
68” METAL AND GLASS TV STAND
M (2)
Q (1)
Step 2: Attaching the front base to the front support
• From the inside of the front base (B), insert a short screw (M) through the screw hole on each tab and into the
screw holes on the front support (A). Make sure that the tabs with the screw holes on the front base (B) point
down. Use the Allen wrench (Q) to tighten the screws.
6
You’ll need:
www.insigniaproducts.com
Loading...