Insignia NS-HAF-CIN-1, NS-HAF-CIN-2, NS-HAF-CIN-2-C Quick Setup Manual
Quick Setup Guide | NS-HAF-CIN-1/NS-HAF-CIN-2/NS-HAF-CIN-2-C
Refrigerator Filter
Congratulations on your purchase of one of the highest performing
water lters on the market today. Insignia lters use a high-grade
coconut carbon that has 50% more micro-pores than standard carbon.
They also use fewer high-compression binders, giving you the best
water ltration possible.
PACKAGE CONTENTS
• Refrigerator lter(s) (1 or 2 pack)
• Quick Setup Guide
*Actual product may
vary slightly from
what is pictured
GENERAL INSTALLATION GUIDELINES
• It is normal for black carbon nes (particles) to appear on the outside
of your lter. This happens when the lter is jarred in shipping. It is
safe, simply wipe it o.
• The lter connectors are larger to prevent leaks. You might have to
twist the lter hard to make sure the connection is secure.
INSTALLING THE WATER FILTER
Carefully remove the plastic cap from the new lter before installation
1 YOU MUST SOAK your new lter in water for 15 minutes prior to
installing it in your refrigerator to remove air from the carbon block.
2 Twist the old lter a quarter-turn counter-clockwise.
3 Pull the lter straight out and discard.
4 Push the new lter into the refrigerator until it stops.
5 Twist the lter a quarter-turn clockwise.
6 Please make sure the indicator arrows on the new lter are lined up with
the indicator arrow on the refrigerator after installation.
7 Run about two to three gallons of water through your refrigerator’s water
dispenser to remove air and loose carbon pieces. The water may be
cloudy and sputter until the air is removed.
8 Reset your “change lter” indicator (if your refrigerator has one). See
below.
RESETTING YOUR CHANGE FILTER INDICATOR
Note: These are the most common lter reset instructions. If the instructions don’t
work for your refrigerator brand, see the documentation that came with your
refrigerator.
REFRIGERATOR BRAND
Samsung
INSTRUCTIONS
Press and hold the ICE TYPE and CHILD LOCK
buttons for three seconds. The water lter
indicator should turn green.
Note: Only hold these buttons for three seconds. Holding
these buttons for ve seconds cancels the reset. If you
cancel the reset, repeat the procedure.
Before using your new product, please read these instructions to prevent any damage.
TROUBLESHOOTING
PROBLEM
My refrigerator is not
dispensing water
My water dispenser is
dripping
My water is cloudy or
contains black carbon
pieces
My new lter is making
noises or sputtering
My water tastes bad
SOLUTION
• Make sure that you soaked your lter in water
• Make sure that the lter is securely connected
• Make sure that the water line to the refrigerator
• Make sure that the refrigerator door is closed or
• A few drops are normal. If the water is dripping
• Cloudy water is caused by microscopic air
• Black carbon pieces in the water are normal and
• Make sure that you soaked your lter in water
• Noises and sputtering are caused by trapped air
• If you do not use your water dispenser for more
• Make sure that you replace your lter every
for 15 minutes before installing.
to the receiver. Do not use tools to tighten the
lter in place.
is turned on. The valve must be completely
open for the refrigerator to receive water.
the dispenser will not work.
constantly, have a service technician check your
refrigerator’s water valve.
bubbles. Run two to three gallons of water from
your dispenser to clear the air bubbles out.
appear with all carbon lters. Run two to three
gallons of water through your dispenser to
remove loose carbon pieces.
for 15 minutes before installing.
pockets. Run two to three gallons of water from
your dispenser to push the air out.
than four days, run two gallons of water
through the dispenser before using it.
three to six months to prevent bacteria growth.
STORAGE AND MAINTENANCE
• Replace your lter every three to six months to prevent bacteria and
fungus growth in your lter, supply lines, and storage tank.
• Stored lters do not expire. Keep your unused lters in a cool, dark,
and dry place until you need them.
• If you do not use your water dispenser for more than four days, run
two gallons of water before using it to prevent bad tasting water.
ONE-YEAR LIMITED WARRANTY
For complete warranty, visit www.insigniaproducts.com.
CONTACT INSIGNIA
1-877-467-4289 (U.S. and Canada) or 01-800-926-3000 (Mexico)
www.insigniaproducts.com
CERTIFICATIONS:
Tested and Certied by NSF International in Model EFF-6027S
against NSF/ANSI Standard 42 for the reduction of chlorine,
taste and odor.
INSIGNIA is a trademark of Best Buy and its aliated companies.
Distributed by Best Buy Purchasing, LLC
©2018 Best Buy. All rights reserved.
Made in China
V4 ENGLISH 18-0427
Loading...