InnoSenT IPS154US User Manual
User Manual
Product Family: K-Band Transceivers
K-Band Transceiver
with two integrated patch antennas and IF-pre-amplifier
IPS-154_US
Description:
-
radar-based motion detector
-
advanced PHEMT-oscillator with low current consumption
-
split transmit and receive path for maximum gain
-
stereo (dual channel) operation for direction of motion
identification
-
IF-pre-amplifier, bandwidth limited for lowest noise
performance
-
economic flat-pack housing, extra small outline dimensions
-
enable input for oscillator shut down
Absolute Maximum Ratings:
Parameter Symbol Rating Units
supply voltage VCC 5.5 V
operating temperature (out of spec) TOP - 40 / + 85 °C
storage temperature T
STG
Electrical Characteristics:
Parameter Symbol min. typ. max. units comment
f
output power (EIRP) P
temperature drift
antenna pattern horizontal 45 ° azimuth
vertical 38 ° elevation
side lobe suppression horizontal 13 dB azimuth
vertical 13 dB elevation
I/Q balance amplitude 6 dB
phase 60 90 120 °
IF output voltage offset 1.0 2.2 4.0 V
IF-amplifier gain 20 dB
bandwidth DC – 50
supply voltage VCC 4.75 5.0 5.25 V
supply current I 35 50 mA
operating temperature TOP - 20 + 60 °C
outline dimensions 44 x 30 x 8.3 (19) mm compare drawing
IPS-154_US
out
∆f
24.075 24.125 24.175 GHz
16 20 dBm
- 1 MHz/°C
+ 90 °C
kHz
Version 1.0 IPS-154_US page 1 of 3
2007-06-06
Interface:
The sensor provides a 2.54 mm grid, single row pin header (square pin 0.635 mm).
Pin # Description In/Out Comment
1 NC not connected
2 enable input active low
3 VCC input supply voltage (+5 V)
4 GND input analog ground
5 IF1 output Signal I(nphase)
6 IF2 output Signal Q(uadrature)
7 NC not connected
8 NC not connected
9 GND input analog ground
10 NC not connected
azimuth
Mechanical Outlines:
(dimensions in mm)
elevation
Certification and environment protection:
InnoSenT GmbH has established and applies a quality system for:
Development, production and sales of radar sensors for commercial and
industrial sensors
An audit was performed, Report No. 010350 Proof has been furnished that
the requirements according to DIN EN ISO 9001:2000 are fulfilled.
This InnoSenT product is compliant to the restriction of hazardous substances
(RoHs – European Union directive 2002/95/EG).
Version 1.0 IPS-154_US page 2 of 3
2007-06-06
Loading...