Ingersoll-Rand 67386 User Manual
OPERATOR’S MANUAL
INCLUDING: OPERATION, INSTALLATION & MAINTENANCE
CYCLE SENSOR KITS
(CLOSED ELECTRICAL CONTACT TYPE)
FOR 3/8” & 1/2” DIAPHRAGM PUMPS
67386
RELEASED: 3-28-06
REVISED: 8-2-10
(REV. 03)
CYCLE SENSOR KITS
67386 can be used on the following diaphragm pumps:
3/8” -- PD03P-XXX-XXX
1/2” -- PD05A
XXX-B
-XXX-XXX-B, PD05P-XXX-XXX-B and PD05R-XXX-
GENERAL DESCRIPTION
The ARO diaphragm pump cycle sensor kits provide a closed contact
output each time the pump completes a cycle. This signal may be used
to record cycles for maintenance purposes or batching if the discharge
volume of each complete cycle is known.
Some parts of thepumpmust be replaced with those included in the kits
to enable the activation of the switch.
OPERATION
Maximum Operating Voltage - 200 V DC.
Switching Current - 0.5 Amps
Once the kit is installed in the pump, it may be interfaced with a control
device in the following ways:
As a SOURCING switch (see figure 1) for use with PLC’s.
As a SINKING switch (see figure 2) for use with PLC’s.
As a closed contact switch (see figure 3) for use with meters.
Sourcing Switch
+V
67386 SENSOR INSTALLATION
Refertofigure4.
1. Remove (134) bolts from the major valve and remove (135) valve
block.
2. Remove (141) valve plate and (140) valve insert from the valve
block.
3. Remove (136) plug and (111) spool. Assemble 67407 spool and
(136) plug into valve block. NOTE: Apply Lubriplate (94276) to all
“O” rings, “U” cups and mating parts.
4. Replace (140) valve insert and (141) valve plate in valve block.
NOTE: Assemble (140) valve insert with “dished” side toward (141)
valve plate.
5. Assemble 96563 adapter (with 95276 sensor attached) to valve
block. Attach (135) valve block to (101) motor body, using (134)
bolts. NOTE: Torque to 15 - 20 in. lbs (1.7 - 2.3 Nm).
. 134
135
140
141 k
132
Identification dot this side.
INPUT
Sinking Switch
INPUT
Closed Contact Switch
INPUTS
INGERSOLL RAND COMPANY LTD
209 NORTH MAIN STREET – BRYAN, OHIO 43506
(800) 495-0276
www.ingersollrandproducts.com
FAX(800) 892-6276
Figure 1
Figure 2
Figure 3
© 2010 CCN 15257850
111
136
Included but not shown:
94276 Lubriplate grease
95275 Magnet
k Assemble with identification dot toward (132) gasket.
. Torque to 15 - 20 in. lbs (1.7 - 2.3 Nm).
g Included in 67386 kit.
67407
Y325-29 (2) g
95276 g
96563 g
Figure 4
g
ASSEMBLY VIEW
CROSS SECTION VIEW
Figure 5
Figure 6
PN 97999-1189
67386Page 2 of 2
Loading...