Infocus LP800 User Manual

LP800

How do I install a new lamp?

1. Unplug the projector and wait for 60 minutes for lamp to cool off.

2. Turn the projector upside down on a soft surface.

3. Loosen the screw that secures the lamp door to the projector. Then remove the door.

4. Loosen the two screws that fasten the lamp to the projector. Then use the handle to pull the lamp out.

5. When you replace the lamp, make sure it seats securely before tightening the screws.

6. Make sure the lamp door completely shuts before tightening the screws. The projector will not operate if

the lamp door is partially open.

How do I reset the lamp timer?

1. Power up the projector.

2. Press the Reset button on the projector keypad for five seconds.

The Lamp Counter appears on the screen.

3. Press the Reset button again.

A menu appears, prompting you to reset the counter or to cancel.

4. Press the Left Arrow key

on the keypad to reset the counter to zero.