Page 1
INFINITY OVERTURE
ASSEMBLY GUIDE
Thanks for choosing Infinity Massage Chairs
to help unlimit your wellness!
INFINITY OVERTURE
ASSEMBLY GUIDE
72 Stard Road, Seabrook, NH 03874
603-910-5000
www.infinitymassagechairs.com
Please contact Technical Support at
603-910-5000 with any questions or concerns, or watch our
helpful tutorials at www.youtube.com/infinitymassagechairs!
Page 2
1
UNPACKING THE MASSAGE CHAIR
For best results, please follow these instructions in order.
This chair must be removed from the shipping container before
powering on. The wooden frame on the bottom of the container will
impede chair movement. Try to have two people, one on either side,
lift the chair straight up using the metal frame. Carefully remove the
armrests from their box and lay them flat on the floor. Remove the
legrest from its box by gripping the front and back sides and carefully
sliding it out.
Two people grasp left
and right seat metal
frame, while another
holds the back of the
chair as it is tilted.
Then remove the
massage chair body
from the box.
Installation is complete! Enjoy your
Overture massage chair!
Page 3
5
ATTACHING THE ARMRESTS
ATTACHING THE LEGREST
2
Next, carefully insert the alignment nub on the arm with the
corresponding socket on the chair body. Bump it into place and make
sure it is secure:
Move the legrest over to the front of the chair. Attach the air hose to
the air nozzle, marked with the yellow arrow below. Attach the two
power cables to the connectors, marked with red arrows. Make sure
the thumb release lines up with the right side of the connectors so
they lock in.
Now tighten the Phillips screw on the hole of the arm until tight.
Replace the rubber plug in place and repeat on the other armrest:
Finally, zip the backrest into place and put the velcro pillow in place.
Page 4
3
ATTACHING THE LEGREST
ATTACHING THE ARMRESTS
4
Remove the Phillips screw from the legrest axle holder on the front of
the chair body. Flip up the axle holder into the position shown:
Make sure to install the axle bushings onto the axles on the legrest
before placing the legrest on the chair:
Attach the power cord and remote control to the chair, then power on
the chair and put it into the zero gravity position (if it is not already in
that position). Take one of the armrests and position it on the correct
side of the chair—not fully in place, just enough so you can connect
the air and power. Connect the air hoses as shown, Black to #1 and
Gray to #2. Connect the power connector, carefully making sure the
thumb button is lined up correctly and clicks into place:
Now place the legrest axles on the axle holders, lower the latch, and
install the Phillips screws.
Remove the rubber plug from the hole shown below in the arm.
Under the plug is a captive Phillips screw for tightening on the arm.
Lower the arm onto the metal frame of the chair carefully:
Loading...