Infinity Outrigger junior Owners manual
OWNER’S MANUAL
OUTDOOR
SPEAKERS
1
UNPACKING
1. Carefully unpack the speakers. If you suspect damage from
transit, report it immediately to your dealer and/or delivery
service. Keep the shipping carton and packing materials for
future use.
2. Verify that the package includes the following items:
– (2) Outrigger jr. Speakers
– (2) Mounting Brackets
– (2) Paint Masks
– (1) Owner’s Manual
PLACEMENT
Although Outrigger jr. Outdoor Speakers are weather-resistant, they
are not weatherproof. We recommending placing or mounting
them in a protected location, such as under the eaves of a roof or
on a porch.
For the best stereo effect, separate your Outrigger jr. speakers
by at least seven to ten feet. Use the built-in pedestal for placement on a table or other surface (see Figure 1). Experiment with
different placement to find the most pleasing effect for your
system. Placing your speakers near a wall or other surface will
increase bass output.
For vertical or horizontal mounting on a wall, use the enclosed
mounting bracket and hardware (see Figures 2 and 3). Locate a
stud for secure mounting. Use heavy-duty screws with long
threads (not included) so there is an adequate number of threads
holding the speaker/bracket to the wall. Test the mounting thoroughly before final installation. Rotate the logo (on the grille) to
match the mounting position.
NOTE: After determining placement position, you may wish to
paint each speaker (see next section).
rotate
logo
OUTRIGGER jr.
(Front View)
Figure 1. Use the built-in pedestal for placement of an Outrigger jr.
speaker on a table or other surface. Note logo orientation.
OUTRIGGER jr.
(Rear View)
MOUNTING
BRACKET
Wood Screws
(fasten to
wall stud)
KNOB
(1 of 2)
FIGURE 3. Horizontal wall mounting of an Outrigger jr.
speaker. If desired, tilt the speaker up or down before tightening
knobs.
OUTRIGGER jr.
(Rear View)
MOUNTING
BRACKET
Wood Screws
(fasten to
wall stud)
KNOB
(1 of 2)
FIGURE 2. Vertical wall mounting of an Outrigger jr. speaker.
If desired, tilt the speaker left or right before tightening knobs.
Loading...