Infinity FMK-1 User Manual

IMPORTANT – DO NOT THROW THIS AWAY

Mounting Template

for FMK-1 Flush-Mount Kit
THE PERFORATED INNER LINE ON THE TEMPLATE MEASURES

9-3/8" X 11-5/8" AND IS THE SIZE OF THE HOLE NEEDED TO MOUNT
THE FRAME. THE OUTSIDE OF THE CARD IS THE SIZE OF THE BEZEL –
USE IT TO POSITION AND CUT THE HOLE.

Please Note the molded bezel that mounts in front of this frame measures
11" x 12-1/2", so allow at least 1" clearance around the hole you cut to allow for
the bezel.

1. Cut hole and locate cable.

2. Locate the thicker, long side of the frame onto the upper edge of hole, swing

the frame into the hole and allow the frame to drop down and locate onto
the lower long edge of hole. Tighten 4 x S/T screws to clamp drywall or
ceiling panel.

3. Connect cable, remove grille and insert speaker. Ensure that the 4 x corner
holes on the black loudspeaker baffle are cleaned out and fix using the 4 x S/T
screws supplied onto the steel frame. Ensure the speaker and frame do not
rattle – do not overtighten. Replace grille.

4. Remove backing film from S/A pads on rear of bezel and locate over the grille,
ensuring that the pads make good contact with the lip of the steel frame, and
press home.

Parts supplied in this mounting kit:

Card template
Assembled steel frame x 2 (zinc coated steel)
Mounting bezel x 2 (paintable ABS) fitted with S/Apads
Loudspeaker fixing screws x 4
Parts list drawing with mounting instructions

Powered Subwoofer

A

B

A

B

A

B

Bezel (2 per kit)
Top Clamp (2 per kit)

Adhesive Pads on rear
of Bezel (8 per kit)

Main Frame (2 per kit)

Bottom Clamp (2 per kit)

Speaker Fixing Screw
No. 8 x 1" (8 per kit)

[16 No. 8 Screws total in kit]

View showing rear of speaker with flush-mount kit in position

View showing speaker fixing screws

Washer to suit No. 8 Screw

(8 per kit)

Compression Spring (8 per kit)

Clamping Screw

No. 8 x 1" (8 per kit)

View showing clamping screws

FMK-1 Flush-Mount Kit Parts List Drawing