INDESIT UI6 F1T S UK Daily Reference Guide

Quick guide

THANK YOU FOR BUYING AN INDESIT PRODUCT

In order to receive a more complete assistance, please register your product on www . indesit . com/ register

PRODUCT DESCRIPTION

FIRST TIME USE

Wait at least two hours, after the installation, before connecting the appliance to the power supply. Connect the appliance to the power supply and turn the thermostat knob to switch on the appliance.

CONTROL PANEL

TEMPERATURE ALARM INDICATOR

When the product is plugged in to the mains, during the rst 10 minutes of working, any temperature sensor failure will be displayed on the control panel.

Led ON Led OFF

Legend:

Led ﬂashing

The appliance will work anyway preserving the food stored, but it is necessary to contact after-sales service and provide alarm code.

Note: The Temperature alarm may activate if the door is left open for a prolonged period of time or following the introduction of fresh food in the freezer compartment; this temporary rise in temperature does not aect the storage of already frozen food in any way.

FAST FREEZING FUNCTION

The use of this function is recommended to increase the cooling speed when placing a very high quantity of food in the freezer compartment. To activate this function press the Temperature button on the control panel repeatedly until 3 LED’s ash and then remain lit.

The function is automatically deactivated after 48 h.

Before using the appliance carefully read the Safety Instruction.

After turning the appliance on, you must wait for 4-6 hours for the correct storage temperature to be reached for a normally lled appliance. Position the antibacterial anti-odour lter in the fan as demonstrated in the lter packaging (if available).

1. Temperature alarm indicator

2. Fast freezing function

3. Temperautre settings

(stand by button)

TEMPERATURE SETTING

Press the Temperature button on the control panel to adjust the temperature from the warmest through the lower to the coldest level.

Pressing the Temperature button, the temperature setting will change cyclically.

At rst plug-in of appliance temperature setpoint is present at medium position (factory setting).

Following table shows temperature setpoints:

high temp.

med-high temp.

medium temp.

med-low temp.

low temp.

Led ON Led OFF

Led ON

Led OFF

Note: Displayed set points correspond to the average temperature throughout the whole freezer.

STANDBY BUTTON

To put the product in Stand-by, press and hold for 3 seconds the Standby button. All the indicators turn o. To reactivate the appliance press once (briey) or for 3 seconds this button.

HOW TO STORE FOOD AND BEVERAGE

Legend

TROUBLESHOOTING

What to do if... Possible reasons Solutions

FREEZING ZONE

All food items

The appliance doesn’t work. There may be an appliance power

The inside light does not work.

The internal temperature of the compartments is not cold enough.

There is water on the bottom of the refrigerator compartment.

Excessive amount of frost in the freezer compartment.

The front edge of the appliance that the door gaskets seal against is hot.

The temperature of the refrigerator compartment is too cold.

supply problem.

It may be necessary to replace the light bulb.

The reasons could vary (see “Solution”) column.

The defrost water drain is blocked. Clean the defrosting water drain (see section “Cleaning and

The door to the freezer compartment is not closed properly.

This is not a problem. It prevents condensation from forming.

• The set temperature is too cold.

• A large amount of fresh food may have been placed in the freezer compartment.

Make sure:

• there is not a power failure;

• the plug is properly inserted in the power socket and the doublepole switch (if present) is in the correct position (on);

• the household electrical system protection devices function;

• the power cable is not broken.

Disconnect the appliance from the power supply and contact the Technical Assistance Service if you need a replacement.

Check that:

• the doors are closed properly;

• the appliance is not installed near a heat source;

• the temperature is appropriately set;

• the circulation of air through the ventilation grilles on the base of the appliance is not obstructed.

Maintenance").

• Check that there is nothing preventing the door from closing properly.

• Defrost the freezer compartment.

• Make sure the appliance has been correctly installed.

A solution is not needed.

• Try to set a less cold temperature.

• If fresh food has been put in the freezer compartment, wait until the freezing has been completed.

• Turn o the fan (if present) described in the paragraph “FAN”.

You can download the Safety Instructions, User Manual, Product Fiche and Energy data by:

• Visiting our website docs . indesit . eu

• Using QR Code

• Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When contacting our After-sales Service, please state the codes provided on your product's identication plate.

19515389200