INDESIT LR9 S2Q F X B Daily Reference Guide [es]

Quick guide

1

EN

THANK YOU FOR BUYING AN INDESIT PRODUCT

In order to receive a more complete assistance, please
register your product on www . indesit . com/ register

PRODUCT DESCRIPTION

APPLIANCE

1

2

3

4

5
6

11

Before using the appliance carefully read the Safety
Instruction.

Refrigerator compartment

1. Fan

2. Electronic control panel / light unit

8

9

15

7

10

3. Shelves

4. Rating plate with commercial name

5. Fresh crisper

6. Door reversibility kit

7. Door trays

8. Egg tray

9. Bottle balcony

10. Door seal

Freezer compartment

10. Door seals

11. Freezer drawers

12. Shelves

13. Bottom drawer: coolest zone best

for freezing fresh food

14. Ice tray

15. Black Out Sensor

12

13

14

CONTROL PANEL

1. Indicator Leds (to display the current

temperature setpoint or the Super
Cool function)

2. Super Cool button /Temperature

button

2

1

ACCESSORIES

EGG TR AY BOTTLE SEPARATOR IF PRESENT ICE TRAY

FIRST TIME USE

HOW TO START THE APPLIANCE

After plugging the appliance to the mains, it starts the
operation automatically. After starting the appliance, wait at
least 4-6 hours before placing food into the fridge and into
the freezer compartment.

DAILY USE

FUNCTIONS

TEMPERATURE SETTING

Press the Temperature button on the control panel to

adjust the temperature from the warmest through the lower
to the coldest level.
Pressing the Temperature button, the temperature
setting will change cyclically. At rst plug-in of appliance
temperature setpoint is present at medium position (factory
setting).
Following table shows temperature setpoints:

HIGH TEMP.
MEDHIGH TEMP.

MEDIUM TEMP.

MEDLOW TEMP.

LOW TEMP.

SUPER COOL

When the appliance is connected to the power supply, the
display lights up and all the icons appear on the display for
approximately 1 second. The default (factory) values of the
fridge compartment settings light-up.

See Use and Care Guide for more details on functions / see last
page for information on how to obtain the Use and Care Guide

The function is automatically deactivated after 24 hours and
return to previous selected set point.

The function can be manually deactivated by pressing and
holding for 3 seconds the Temperature button on the control
panel.

REFRIGERATOR LIGHT

The light system inside the refrigerator compartment uses
LEDs light, allowing a better lightning as well as a very low
energy consumption.
If the LED light system does not work, please contact the
Service to replace it.

Important: The refrigerator compartment light switches
on when the refrigerator door is opened. If the door is kept
open for more then 8 minutes the light will be automatically
switched o.

Led on Led o

Note: Displayed set points correspond to the average
temperature throughout the whole refrigerator.

SUPER COOL

The use of the Super Cool function is recommended
to increase the cooling capacity of the refrigerator
compartment when placing a very high quantity of food
within it. To activate the Super Cool function, press and hold

for 3 seconds the Temperature button on the control panel

till all the 3 LEDs will turn on.

FAN

The Fan improves temperature distribution inside the
refrigerator compartment, allowing better preservation of
stored food. By default, the fan is switched on.
To turn o the fan press the button of fan.
Please note that when the fan is switched on it will not
continuously work. The fan will start/stop working depending
on the temperature and/or humidity level inside the fridge.
It is therefore absolutely normal if the fan does not move even
if the fan is switched on.

ALARM TABLE

ALARM TYPE SIGNAL CAUSE CURE

Door open alarm Refrigerator Light blinks The door has remained open for

more than 5 minutes.

Door open alarm Refrigerator Light OFF The door has remained open for

more than 8 minutes.

Malfunction Any temperature indicators blinks Product malfunction. Contact the After-sales Service

2

Close the door

Close the door

BLACK OUT SENSOR

ݲ

Through the two liquids
contained, the black out sensor
will give you indication in case
blackout occurs.

HOW TO USE (set up required at rst use)

1 2 3 4

EN

1. RED LIQUID

2. YELLOW LIQUID

Plug the fridge The sensor must be in this

position:

Wait 24 hours to make the

liquid frozen

+24h

24 hours later, you must rotate the

blackout sensor of 180° clockwise.

Now the sensor is ready to work.

Check the sensor to inform if black out is

occurred.

CHECK THE SENSOR TO INFORM IF BLACK OUT IS OCCURRED

If one or both of the liquids are dissolved, this is an indication of increased temperature in the freezer that could be caused by a blackout. Even the
partial melting of one of the 2 liquids can show and abnormal increase of the internal temperature.

Default conguration:

No problem

YELLOW liquid fault down:

food must be eaten in a week

RED + YELLOW liquid fault down: food

should be thrown away

3