Quick guide
EN
THANK YOU FOR BUYING AN INDESIT PRODUCT
In order to receive a more complete assistance, please
register your product on www . indesit . com/ register
Before using the appliance carefully read the Safety
Instruction.
PRODUCT DESCRIPTION
FIRST TIME USE
Wait at least two hours, after the installation, before connecting the
appliance to the power supply.
Connect the appliance to the power supply and turn the thermostat
knob to switch on the appliance.
CONTROL PANEL
B. Thermostat Knob 1. Light bulb
MAX
FREEZING FRESH FOOD
Place fresh food to be frozen on the shelf in the freezer compartment,
avoiding direct contact with food that is already frozen.
The quantity of fresh food that can be frozen in 24 hours is written on
the rating plate.
To freeze fresh food, place the freezer compartment shelf in the
bottom position.
FAN*
The Fan improves temperature distribution inside the refrigerator
compartment, allowing better preservation of stored food. By default,
the fan is switched on. To turn o the fan press the button of fan. Please
note that when the fan is switched on it will not continuously work.
The fan will start/stop working depending on the temperature and/or
humidity level inside the fridge. It is therefore absolutely normal if the
fan does not move even if the fan is switched on. If the appliance has
the Fan it can be equipped with the antibacterial lter. Remove it from
the box placed in the crisper drawer and insert into the fan cover - as in
the picture. The replacement procedure is included in the lter box.
MED
-
MIN
After turning the appliance on, you must wait for 4-6 hours for the
correct storage temperature to be reached for a normally lled
appliance. Position the antibacterial anti-odour lter in the fan as
demonstrated in the lter packaging (if available).
2. Thermostat knob
3. Thermostat seeting indicator
4. Light button
FREEZER AND REFRIGERATOR COMPARTMENT TEMPERATURE
This Fridge/Freezer is switched on by means of the thermostat located
inside the refrigerator compartment.
The temperature of both compartments is adjusted by turning the
thermostat knob.
Thermostat set to MIN: low cooling intensity
Thermostat set between MIN and MAX: cooling intensity can be
adjusted according to the preferences.
Thermostat set to MAX: maximum refrigeration intensity.
For the best food conservation MED position is recommended.
Thermostat set to
Note: Displayed set points correspond to the average temperature
throughout the whole refrigerator.
: cooling and lighting o.
•
HOW TO STORE FOOD AND BEVERAGE
* Available only on certain models
Legend
TEMPERATE ZONE
Suggested for the storage of tropical fruit, cans, drinks,
eggs, sauces, pickles, butter, jam
COOL ZONE
Suggested for storage of cheese, milk, dairy food,
delicatessen, yogurt
FRUIT & VEGETABLE DRAWER
FREEZING ZONE DRAWER
(MAX COOL ZONE) Suggested to freeze fresh/cooked
food.
NORMAL FREEZER DRAWERS
TROUBLESHOOTING
What to do if... Possible reasons Solutions
The appliance is not
working.
There is water in the defrost
pan.
The edges of the appliance
cabinet, which come in
contact with the door seal,
are warm to the touch.
The light does not work. The light may need replacing.
The motor seems to run too
much.
The appliance temperature
is too high.
There may be an appliance power
supply problem.
This is normal in hot, damp weather. The
pan can even be half full.
This is not a defect.
This is normal in hot weather and when
the compressor is running.
The appliance may be in On/Stand-by
model.
Motor running time depends on
dierent things: number of door
openings, amount of food stored,
temperature of the room, setting of the
temperature controls.
There could be various causes (see
“Solutions”).
• Check if power cable plugged into a live socket with the proper
voltage.
• Check if the protection devices and fuses of the electrical system
in your home
• Make sure the appliance is level so that the water does not
overow.
• Make sure if the protection devices and fuses of the electrical
system in your home work well.
• Check if the power cable is plugged into a live socket with the
proper voltage
• In case the LEDs are broken the user must call the Service for
exchange of the same type available only at our After-sales
Service Centers or authorized dealers.
• Make sure that the appliance controls are correctly set.
• Check if there is not a large amount of food been added to the
appliance.
• Check that the door is not opened too often.
• Check that the door close properly.
• Make sure that the condenser (back the appliance) is free of dust
and u.
• Make sure that the door properly closed.
• Make sure that the door seals properly tted.
• On hot days or if the room is warm, the motor naturally runs
longer.
• If the appliance door has been left open for a while or if large
amounts of food have been stored, the motor will run longer in
order to cool down the interior of the appliance.
The doors do not open and
close properly.
You can download the Safety Instructions, User Manual, Product Fiche and Energy data by:
• Visiting our website docs . indesit . eu
• Using QR Code
• Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When
contacting our After-sales Service, please state the codes provided on your product's identication
plate.
There could be various causes (see
“Solutions”).
• Check that food packages are not blocking the door.
• Check that the internal parts or automatic ice maker are not out of
position.
• Check that the door seals are not dirty or sticky.
• Ensure the appliance is level.
400011089376