Before using the appliance
carefully read these safety
instructions.
Keep them close at hand for
future reference.
These instructions and the
appliance itself provide
important safety warnings, to be
observed at all times.
The manufacturer declines any
liability for failure to observe
these safety instructions, for
inapropriate use of the
appliance or incorrect setting of
controls.
SAFETY WARNINGS
Very young (0-3 years) and
young children (3-8 years) shall
be kept away from the appliance
unless continuously supervised.
Children from 8 years old and
above and persons with reduced
physical, sensory or mental
capabilities or lack of experience
and knowledge can use this
appliance only if they are
supervised or have been given
instructions on safe use and
understand the hazards
involved. Children must not play
with the appliance. Cleaning and
user maintenance must not be
carried out by children without
supervision.
PERMITTED USE
This appliance is solely for
domestic, not professional use.
Do not use the appliance
outdoors.
Do not store explosive or
ammable substances such as
aerosol cans and do not place or
use gasoline or other ammable
materials in or near the
appliance: a re may break out if
the appliance is inadvertently
switched on.
CAUTION: The appliance is not
intended to be operated by
means of an external timer or
separate remote controlled
system.
This appliance is intended to be
used in household and similar
applications such as:
– sta kitchen areas in shops,
oces and other working
environments;
– farm houses and by clients in
hotels, motels and other
residential type environments;
– bed and breakfast type
environments;
– catering and similar non-retail
applications.
The bulb used inside the
appliance is specically
designed for domestic
appliances and is not suitable for
general room lighting within the
home (EC Regulation 244/2009).
The appliance is arranged for
operation in places where the
temperature comes within the
following ranges, according to
the climatic class given on the
rating plate. The appliance may
not work properly if it is left for a
long time at a temperature
outside the specied range.
Climatic Class Amb. T. (°C)
SN From 10 to 32
N From 16 to 32
ST From 16 to 38
T From 16 to 43
This appliance does not contain
CFCs. The refrigerant circuit
contains R600a (HC).
Appliances with Isobutane
(R600a): isobutane is a natural
gas without environmental
impact, but is ammable.
Therefore, make sure the
refrigerant circuit pipes are not
damaged. Keep special attention
in case of damaged pipes
emptying the refrigerant circuit.
WARNING : Do not damage the
appliance refrigerant circuit
pipes.
WARNING : Keep ventilation
openings, in the appliance
enclosure or in the built-in
structure, clear of obstruction.
WARNING : Do not use
mechanical, electric or chemical
means other than those
recommended by the
Manufacturer to speed up the
defrost process.
WARNING : Do not use or place
electrical devices inside the
appliance compartments if they
are not of the type expressly
authorised by the Manufacturer.
WARNING : Ice makers and or
water dispencers not directly
connected to the water supply
must be lled with potable
water only
WARNING : Automatic
icemakers and/or water
dispensers must be connected
to a water supply that delivers
potable water only, with main
water pressure between 0,17
and 0,81 MPa (1,7 and 8,1 bar).
Do not swallow the contents
(non-toxic) of the ice packs (in
some models).
Do not eat ice cubes or ice lollies
immediately after taking them
out of the freezer since they may
cause cold burns.
For products designed to use an
air lter inside an accessible fan
cover, the lter shall be always in
position when the refrigerator is
in function.
Do not store glass containers
with liquids in the freezer
compartment since they may
break.
Do not obstruct the fan (if
available) with food items.
After placing the food check if
the door of compartments
closes properly, especially the
freezer door.
Damaged gasket must be
replaced as soon as possible.
Use the refrigerator
compartment only for storing
fresh food and the freezer
compartment only for storing
frozen food, freezing fresh food
and making ice cubes.
Avoid storing unwrapped food
in direct contact with internal
surfaces of the refrigerator or
freezer compartments.
Appliances could have special
compartments (Fresh Food
4
EN
Compartment, Zero Degree
Box,...).
In case not dierently specied
in the specic booklet of
product, they can be removed,
maintaining equivalent
performances.
C-Pentane is used as blowing
agent in the insulation foam and
it is a ammable gas.
INSTALLATION
Installation and repairs must be
carried out by a qualied
technician, in compliance with
the manufacturer’s instructions
and local safety regulations. Do
not repair or replace any part of
the appliance unless specically
stated in the user manual.
Children should not perform
installation operations. Keep
children away during
installation. Keep the packaging
materials (plastic bags,
polystyrene parts, etc.) out of
reach of children, during and
after the installation.
The appliance must be handled
and installed by two or more
persons. Use protective gloves
to unpack and install the
appliance.
Be careful not to damage the
oors (e.g. parquet) when
moving the appliance.
Install the appliance on a oor or
support strong enough to take
its weight and in a placesuitable
for its size and use.
After unpacking the appliance,
make sure that it has not been
damaged during transport. In
the event of problems, contact
the dealer or your nearest
Aftersales Service.
The appliance must be
disconnected from the power
supply before any installation
operation.
During installation, make sure
the appliance does not damage
the power cable.
To guarantee adequate
ventilation, leave a space on
both sides and above the
appliance.
The distance between the rear
of the appliance and the wall
behind the appliance should be
50mm, to avoid access to hot
surfaces.
A reduction of this space will
increase the Energy
consumption of product.
Only activate the appliance
when the installation has been
completed.
Wait at least two hours before
switching the appliance on, to
ensure that the refrigerant
circuit is fully ecient.
Make sure the appliance is not
near a heat source.
ELECTRICAL WARNINGS
For installation to comply with
current safety regulations, an
omnipolar switch with minimum
contact gap of 3mm is required
and the appliance must be
earthed.
If the tted plug is not suitable
for your socket outlet, contact a
qualied technician.
The power cable must be long
enough to connect the
appliance, once tted in its
housing, to the main power
supply. Do not pull the power
supply cable.
If the power cable is damaged,
replace with an identical one.
The power cable must only be
replaced by a qualied
technician in compliance with
the manufacturer instruction
and current safety regulations.
Contact an authorized service
center.
For appliances with tted plug, if
the plug is not suitable for you
socket outlet, contact a qualied
technician.
Do not use extension leads,
multiple sockets or adapters.
Do not operate this appliance if
it has a damaged mains cord or
plug, if it is not working properly,
or if it has been damaged or
dropped. Keep the cord away
from hot surfaces.
The electrical components must
not be accessible to the user
after installation.
Do not touch the appliance with
any wet part of the body and do
not operate it when barefoot.
CLEANING AND
MAINTENANCE
Wear protective gloves for
cleaning and maintenance.
The appliance must be
disconnected from the power
supply before any maintenance
operation.
Never use steam cleaning
equipment.
Do not use abrasive or harsh
cleaners such as window sprays,
scouring cleansers, ammable
uids, cleaning waxes,
concentrated detergents,
bleaches or cleansers containing
petroleum products on plastic
parts, interior and door liners or
gaskets. Do not use paper
towels, scouring pads, or other
harsh cleaning tools.
5
SAFEGUARDING THE ENVIRONMENT
DISPOSAL OF PACKAGING
MATERIALS
The packaging material is 100%
recyclable and is marked with the
recycle symbol.
The various parts of the packaging
must therefore be disposed of
responsibility and in full compliance
with local authority regulations
governing waste disposal.
SCRAPPING OF HOUSEHOLD
APPLIANCES
When scrapping the appliance, make
it unusable by cutting o the power
cable and removing the doors and
shelves (if present) so that children
cannot easily climb inside and
become trapped.
This appliance is manufactured with
recyclable
Dispose of it in accordance with local
waste disposal regulations.
For further information on the
treatment, recovery and recycling of
household electrical appliances,
contact your competent local
authority, the collection service for
household waste or the store where
you purchase the appliance.
This appliance is marked in
compliance with European Directive
2012/19/EU, Waste Electrical and
Electronic Equipment (WEEE).
By ensuring this product is disposed
of correctly, you will help prevent
potential negative consequences for
or reusable materials.
the environment and human health,
which could otherwise be caused by
inappropriate waste handling of this
product..
The symbol
the accompanying documentation
indicates that it should not be treated
as domestic waste but must be taken
to an appropriate collection center for
the recycling of electrical and
electronic equipment.
on the product or on
ENERGY SAVING TIPS
Install the appliance in a dry, well
ventilated room far away from any
heat source (eg. radiator, cooker, etc.)
and in place not exposed directly to
the sun. If required, use an insulating
plate.
To guarantee adequate ventilation
follow installation instructions.
Insucient ventilation on back of the
product increases energy
consumption and decreases cooling
eciency.
The internal temperatures of the
appliance may be aected by the
ambient temperature, frequency of
door opening, as well as location of
the appliance. Temperature setting
should take into consideration these
factors.
Reduce to a minimum door opening.
When thawing frozen food, place
them in the refrigerator. The low
temperature of the frozen products
cools the food in the refrigerator.
Allow warm food and drinks to cool
down before placing in the appliance.
Positioning of the shelves in the
refrigerator has no impact on the
ecient usage of energy. Food should
be placed on the shelves in such way
to ensure proper air circulation (food
should not touch each other and
distance between food and rear wall
should be kept).
You can increase storage capacity of
frozen food by removing baskets and,
if present, Stop Frost shelve,
maintaining an equivalent energy
consumption.
High energy class products are tted
with high eciency motors that
remain operational for longer, but
have a low power consumption. Do
not worry if the engine continues to
run for longer periods.
DECLARATION OF CONFORMITY
This appliance has been designed,
constructed and distributed in
compliance with the requirements of
European Directives:
LVD2014 / 35 / EU, EMC2014 / 30 / EU and
RoHS2011 / 65 / EU.
6
This appliance has been designed,
constructed and distributed in
compliance with the Ecodesign and
energy Labeling Requirements of EC
Directives: 2009/125/EC and
2010/30/EU.
Use and Care guide
PRODUCT
DESCRIPTION
APPLIANCE
PRODUCT DESCRIPTION
1
2
3
4
5
11
12
EN
Refrigerator compartment
1. Electronic control panel / light
unit
6
7
8
9
10
2. Shelves
3. Rating plate with commercial
name
4. Fruits and vegetables crisper
5. Door reversibility kit
6. Door trays
7. Egg tray
8. Bottle holder
9. Bottle balcony
10. Door seal
Freezer compartment
10. Door seals
11. Freezer drawers
12. Shelves
13. Bottom drawer: coolest zone
best for freezing fresh food
14. Ice tray
13
14
CONTROL PANEL
MAX
TEMPERATURE SETTING
Thermostat set to MIN: low cooling intensity
Thermostat set between MIN and MAX : cooling
intensity can be adjusted according to the
preferences.
Thermostat set to MAX: maximum refrigeration
intensity.
MED
-
MIN
A. Light bulb
B. Thermostat knob
C. Thermostat seeting
indicator
D. Light button
A
For the best food conservation MED position is
recommended.
Thermostat set to • : cooling and lighting off.
Note: Displayed set points correspond to the average
temperature throughout the whole refrigerator.
BC
D
7
DOOR
DOOR REVERSIBILITY Note: The direction of door opening can be changed .
If this operation is performed by After-sales Service
it is not covered by the warranty . Is recommended
to reverse door swing by two persons .
Follow instruction in
installation guide.
REFRIGERATOR
LIGHT
To remove the light bulb turn anticlockwise as
shown in the picture:
Check the bulb. If necessary unscrew the broken
SHELVES
All shelves, flaps and pull-out baskets are removable.
bulb and replace it with a LED bulb of the same
type available only at our After-sales Service
Centers or authorized dealers.
The refrigerator compartment light switches on
when the refrigerator door is opened .
8
Loading...
+ 17 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.