ILVE 600TCGV, 600TCBV, 600TCI User Manual

INSTRUCTION MANUAL
FOR 60 SERIES BUILT-IN OVEN
OPEN 24
ILVE ACCESSORIES ONLINE SHOP

/
7
EN
TABLE OF CONTENTS PAGE
1 -
Safety Instructions 2
2 -
Product Features 3
3 -
Installation of the Oven 4
Electricals 4 Respect for the environment 4 Connection to the electrical power mains 10
4 -
Instructions for Use 11
The first time you use the oven 11 Removable Guides (if present) 11
5 -
Control panel 12
Keypad 12
6 -
General Oven Information 13
Error codes 13 Beeps 13 Default Settings 13 F Failure Number Codes 13 Preheat and Fast Preheat 13 Timer 13
7 -
General Oven Tips 14
Preheating the Oven 14 Operational Suggestions 14 Utensils 14 Oven Condensation and Temperature 14 High Altitude Baking 14
8 -
Getting Started 15
Instructions for initial switch-on 15
9 -
User Settings 16
Language 16 Temp er at ur e & Weig ht 16 Time 16 Date 17 Brightness 17 Volu me 17
10 -
System Setting 18
Event Log 18 Demo 18
11 -
Starting your Oven 19
Switching the oven on and offf 19 Selecting the cooking mode 19 Changing the cooking mode 19 Changing temperature 19
TABLE OF CONTENTS PAGE
12 -
Cooking Mode Tables 20
Pre-heating phase 22 Fast Preheat 22 Eco 22 Using Oven Lights 22
13 -
Time Oven Mode Operation 23
Cook Time 23 Stop Time 23
14 -
Setting the Meat Probe (if present) 24
15 -
Understand ing the Various Oven Modes
Roast Tips and Techniques 26 General Guidelines 26 True Convection Tips and Techniques 26 Convection Roast Tips and Techniques 27 Convection Broil Tips and Techniques 27 Broil Tips and Techniques 27 Dehydrate Tips and Techniques 27 Dehydrate Chart 28
16 -
Recipes 29
17 -
Sabbath Mode Instructions (on some models) 31
18 -
Oven Care and Cleaning 32
Clean 32 Removing the door 32 Removing the slide oven door 33 How to remove the inner glass of the “FULL
GLASS” panoramic door Replacement of the oven light 34
19 -
Solving Baking Problems 35
20 -
Solving Operational Problems 36
21 -
Assistance or Service 37
Service Data Record 37
26
33
1
EN
1 - Safety Instructions
IMPORTANT
The oven’s data plate is accessible even with the oven fully installed. The plate is visible simply by opening the door. Always quote the details from it to identify the appliance when ordering spare parts.
• Children should be overseen so as to ensure that they don’t play with the equipment.
Keep children under age 8 away, unless constantly
supervised.
• This appliance is not intended for use by persons (including children over age 8) with reduced physical sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsable for their safety.
Children may not perform cleaning and maintenance
unsupervised.
• In order to avoid damage to the oven enamel coat, do not cover the oven muffle sole with any item (e.g. aluminum foil, pans and the likes).
• Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door glass since they can scratch the surface, which may result in shattering of the glass.
• Abrasive detergents and steam cleaning equipment should not be used for cleaning.
Do not disassemble any parts prior to having
disconnected the oven from the mains.
Do not use the appliance if any part is broken (for
example a glass). Disconnect it from the mains and call service.
• Before using the oven, it is recommended to make it operate at noload at the maximum temperature for an hour to eliminate the insulating material odour.
• In all models, leave the door closed when the grill is used.
• The cooling fan may remain in operation so long as the oven is hot, even after it has been switched off.
During the use the appliance becomes very hot; don’t
touch the heating elements inside the oven.
• Parents and adults should pay particular attention when using the product in presence of children.
• The appliance must not be installedbehind a decorative door in order to avoid overheating.
WARNING: Ensure that the appliance is switched off
before replacing the lamp to avoid the possibility of electric shock.
• The oven is cool and power to the oven has been turned off before removing the door. Failure to do so could result in electrical shock or burns.
• Use only the meat probe supplied with the appliance.
IMPORTANT
If the oven is installed in an ambient temperature below 37 °F (3 °C), F*0117 may appear; when a higher ambient temperature is reached, the error will no longer appear.
2
Refer to the figures below for the correct placement of the grills
EMBOSSED GUIDES
2 - Product Features
EN
REMOVABLE GUIDES
3
EN
3 - Installation of the Oven
Respect for the environment
To install the oven into the kitchen a cutout should be made in accordance with the dimensions shown in the Cutout & Dimensions figure. The apparatus is to be fastened to the top by means of the two screws provided in the kit through the holes made on the oven uprights. The cabinet in which the apparatus is installed shall be open on the back side to ensure a sufficient air circulation and prevent overheating.
WARNING
As the apparatus is to be fitted in your kitchen furniture, make sure that all surfaces in contact with the oven can resist a temperature of approx 90°C.
Electricals
Maximum absorbed power: (see data plate).
Supply voltage: (see data plate).
The documentation for this appliance is printed on paper bleached without chlorine or recycled paper to contribute to protecting the environment. The packaging was designed to prevent damage to the environment; they are ecological products that can be recovered or recycled. Recycling the packing saves raw materials and reduces the volume of industrial and domestic waste.
THE PACKING MATERIAL is 100% recyclable and marked with the recycling symbol. Dispose of in conformity with local law. The packing material (plastic bags, polystyrene parts, etc.) must be kept out of the reach of children because it is potentially dangerous. THIS APPLIANCE is marked in conformity with European Directive 2012/96/UE, Waste Electrical and Electronic Equipment (WEEE). By making sure that this product is disposed of correctly, the user contributes to preventing potential negative consequences for the environment and health.
THE SYMBOL on the product or accompanying documentation indicates that this product must not be treated as domestic waste but must be delivered to a suitable collection point for the recycling of electrical and electronic equipment.
4
MOD. 45
min 3
EN
min 460
50
510
595
50
510
560
140
560
50
144
min
432
450
510
533
540
560
432
594
min
455
min 458
3
540
455
528
545
554
26
596
533
594
Dimensions are in millimeters
5
EN
MOD. 60
595
50
510
560
50
594
595
535
21
min 5
595
50
510
560
min
min 600
5
540
594
594
535
21
Dimensions are in millimeters
6
MOD. 75
EN
595
50
510
710
568
545
682
594
750
21
min 5
5
min
682
min
585
5
594
568
595
50
510
710
545
750
21
Dimensions are in millimeters
7
EN
min 5
MOD. 90x48
480
min
50
510
860
849
477
472
893
517
538
5
min
475
min
860
50
510
min
5
472
517
538
849
477
893
Dimensions are in millimeters
8
MOD. 90x60
min 5
EN
595
50
510
860
826
594
563
895
530
551
min 5
595
860
50
510
min 5
563
530
551
826
594
895
Dimensions are in millimeters
9
EN
Connection to the electrical power mains
WARNING
This apparatus must be earthed.
The oven is only for domestic use. The feed voltage and the absorbed power are as indicated on the data plate attached to the left-hand side upright, which can be seen when the oven door is open. Connecting must be carried out by qualified personnel and in accordance with the regulations currently in force. The manufacturer can not be held responsible for any damages to persons or objects caused by failure to observe these instructions. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. The oven must be connected to the mains through a multipole circuit breaker with a contact-to-contact gap of at least 3 mm, making sure that the earth wire is not disconnected. For connecting use a flexible cable remembering to make it long enough to allow the oven to be removed from its housing unit when maintenance work is required. Such a device must be fitted to the power supply in compliance with the regulations governing electrical installations.
The socket or switch must be easily reachable with the oven fully installed.
CABLE TYPES AND MINIMAL DIAMETERS
SASO H05RR-F 3x1,5 mm² H05RR-F 3x2,5 mm² H05VV-F 3x1,5 mm² H05VV-F 3x2,5 mm² H05RN-F 3x1,5 mm² H05RN-F 3x2,5 mm² H05V2V2-F 3x1,5 mm² H05V2V2-F 3x2,5 mm²
10
The first time you use the oven
Clean the oven thoroughly with soapy water and rinse well. Operate the oven for about 30 minutes at maximum temperature to burn off all traces of grease which might otherwise create unpleasant smells when cooking.
WARNING
Never use aluminum foil to cover the oven racks or to line the oven. It can cause damage to the oven liner if heat is trapped under the foil.
WARNING
Make sure you do not force it to avoid damage to the enamel.
4 - Instructions for Use
EN
Removable Guides (if present)
To remove the lateral frames from smooth-walled ovens, proceed as shown in the figure.
11
Loading...
+ 29 hidden pages