iLive ISBW108 User Manual

Waterproof Wireless Speaker
User’s Guide for Model ISBW108 v2043-01
Protect for Today
Sustain for Tomorrow
Made Green
Specications are subject to change without notice.
Copyright © 2018 Digital Products International (DPI, Inc.)
of their respective owners.
Contact Information
Website: www.iLiveElectronics.com
Email Support: prodinfo@dpiinc.com
Email Parts: partsinfo@dpiinc.com
Phone Support: 1-888-999-4215
Warranty
For Warranty Information and the most up-to-date version of this User’s Guide, go to:
www.iLiveElectronics.com.
FCC WARNINGS
• Warning: Changes or modications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
ADDITIONAL WARNINGS
• WARNING: To prevent re or shock hazards, do not expose this unit to rain or moisture.
• WARNING : Where the mains plug or appliance coupler is used as the disconnect device, such disconnect device shall remain readily operable.
• Lithium batteries, like all rechargeable batteries, are recyclable and should be recycled or disposed of according to state and local guidelines. They should never be disposed of in normal household waste and they should never be incinerated, as they might explode. Contact your local government for disposal or recycling practices in your area.
To avoid hearing damage, make sure that the volume on your music player is turned down before connecting your earbuds or headphones. After placing earbuds in/on your ears, gradually turn up the volume until you reach a comfortable listening level.
WARNING : This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www. P65Warnings.ca.gov. This product meets and complies
with all Federal regulations.
Aux In (3.5mm Audio Input)
1. Connect a 3.5mm audio cable (not included) to the Aux In on the unit and the audio output/ headphone jack on a media player.
2. The unit will automatically detect the input and switch to Aux In Mode, indicated by a voice prompt and a slowly blinking indicator light. Use the controls on the connected device to select and play audio.
Previously Connected Devices
• The speaker can remember multiple Bluetooth devices and will always try to re-connect to the last device used.
• To re-connect to a dierent device, turn o Bluetooth on unwanted devices, then access the Bluetooth settings menu on the device you wish to use and select ISBW108.
• If the speaker should become unpaired or will not connect normally, follow these steps in your device’s Bluetooth Settings Menu.
» Delete the speaker (“Forget This Device”).
» Turn Bluetooth OFF then ON again, and
repeat the Initial Bluetooth Connection.
Features
• Bluetooth wireless: range 60 ft.
• Durable fabric & rubberized coating
• DC battery power ­built-in rechargeable battery: approx. 2.5 hrs playtime at 100% volume
Includes
• USB charging cable
• Carabiner
• User’s Guide
Waterproof Rating - IPX5
• Protection from contact with enclosed equipment.
• Protection from heavy splashing water.
• Protection from dust, oil, and other non-corrosive material.
IMPORTANT: To ensure your speaker is prepared for use in a wet environment, disconnect and remove any power cables, and tightly close the charging port water cap. If the water cap is not properly closed, water resistance will be compromised and could result in damage to the speaker or personal injury.
Overview
Power Status Indicator Light
Low Battery Flashing red light
Charging Solid Red light
Finished Charging No light
Charging the Battery
Warning: Do not charge the speaker while it is in or near water. If splashed or wet, allow ample time to dry before charging.
Initial charge time is approximately 2 hours. Charge fully before use.
• Pull back the water cap and use a Micro-USB to USB cable (included), to connect to the USB port of a powered on computer or USB power adapter (not included).
Initial Bluetooth Connection
1. Power on and press and hold the button. A voice will announce “Bluetooth is connecting” and the indicator will begin quickly ashing blue.
When pairing, remain within 3 feet of the unit.
2. Using the controls on your Bluetooth device, select ISBW108 in the Bluetooth Settings to pair.
If need be, refer to the user’s manual for your specic device for more information.
3. When successfully paired, a voice will announce “Bluetooth is connected” and the LED indicator will turn solid blue. Audio from the connected Bluetooth device will now play on the speaker.
4. Use the controls on the connected Bluetooth device to select and play audio. Use the speaker controls or the connected Bluetooth device to play, pause, and adjust the volume level.
Waterproof Cap /
Micro-USB Charging Port / Aux In (rear)
Top View
Power / LED Indicator Light
Press and hold to power on or o.
Microphone
Play / Pause
Press to play or pause audio (BLUETOOTH MODE).
Volume - / +
AUX
DC IN
Pair Bluetooth / Speakerphone
Press to begin pairing.
Press to answer/end a phone call.
Using the Speakerphone
• To accept a call, press the button or use the controls on the connected phone.
• To end a call, press the
button or use the
controls on the connected phone.
• To re-dial the last dialed number, press the button twice.
Loading...