Ihome IPL8XH User Manual

Model iPL8XH
Docking FM clock radio for
iPod or iPhone
QUESTIONS? Visit www.ihome.com
WELCOME
get you up and running quickly and provide helpful hints to
maximize enjoyment. For more information about this and other
iHome products, please visit www.ihome.com
GETTING STARTED
This unit ships with the following items. Please check to see that all
items are present.
1 iPL8XH speaker system
2 100-240V Universal AC power adaptor
3 FM antenna
1
2 3
1
FEATURES & FUNCTIONS
Top panel
Removable rubber
docking insert
Power On/O
Button
RED when connected to power
WHITE when unit is powered ON
Mode Button
+/– Settings
Buttons
Alarm 1 Button
Sleep Button
Back panel
Display
PM Indicator
AM Indicator
Low Backup
Battery Indicator
DC Jack
DC 9V 2.7A
Backrest
Snooze/Dimmer Button
USB charging
port
Time Display
FM Antenna jack
Lightning Dock
Connector for iPhone/iPod
Time Sync Button
Play/Pause/Presets Button
Volume Control Buttons
Alarm 2 Button
Aux-in jack
Alarm Indicators
Minute Indicator Volume Indicator
Sleep Mode Indicator
Wake-To/Mode Indicators (Tone/Dock/Aux/FM Radio)
Alarm Time/Date Display
2
CONNECTING AC ADAPTER AND FM ANTENNA
This unit operates on AC power
using the included 100V-240V
universal AC adaptor. Place unit on
a stable surface. Plug the power
adaptor into the DC jack on back
of the unit and the other end into a
RESET
RESET
TEST
TEST
DC 9V 2.7A
working wall socket. The Power
Button will glow red. Connect the
included FM radio antenna to the
FM Antenna
FM antenna jack on the back of the
unit.
BACKUP BATTERY
The iPL8XH ships with a CR2450 battery installed for backup to provide
continuous alarm operation and clock settings in the event of a power failure.
Remove the pull tab from the battery compartment on the bottom of the unit
before use. If a power failure occurs or the AC cord is accidentally
disconnected, the display backlight will not remain lit, but current time and
alarm time settings will be temporarily maintained. Otherwise, you must reset
the time and alarm settings.
Note: The Battery Low icon is located at the left side of clock display.
When the backup battery is low and needs to be replaced, the Battery
Low icon will flash. To replace, follow steps below:
3
BACKUP BATTERY (CONTINUED)
1. Please make sure the AC adaptor is connected. Otherwise all settings
may be lost during battery replacement.
2. Use a Phillips screwdriver to open the backup battery compartment
door located on the bottom of the unit.
3. Remove the exhausted battery. Insert a
new CR2450 battery by easing it under the
tabs in the battery well and pressing down.
Make sure the side marked + is facing up.
4. Close the battery compartment door and
tighten the battery door screw.
Note: Make sure you dispose of battery
properly (see your local regulations).
WARNING: Lithium batteries can explode or cause burns if disassembled,
shorted, recharged, exposed to water, fire, or high temperatures. Do not
place loose batteries in a pocket, purse, or other container containing metal
objects, mix with used or other battery types, or store with hazardous or
combustible materials. Store in cool, dry, ventilated area. Follow applicable
laws and regulations for transport and disposal.
4
Loading...
+ 10 hidden pages