iHome iCVBT20 User Manual

Model: iCVBT20

Instruction manual - US English Size: 102 x 150 mm

Date: July 13 2020

Mat’l: 260gsm paper Color: Black text on white background

Home Beaut

PORTABLE

iCVBT20

Quick Start Guide

Adjusting the Mirror

The door on the back of the unit also works as a kickstand for

Reset

In the event of interrupted operation, use the extended wire of a paper clip or other thin tool to push in the Reset

Button on the back of the unit.

Maintenance

This unit comes with a cleaning cloth to keep the mirror smudge free. If more cleaning is needed, try washing with mild soap and water.

the mirror.

add art of kicks

tand

Charging the Mirror

• Connect the included USB charging cable to the micro USB Charging Port on the back of the unit, and the

standard end to a powered USB port.

Status LED Red = Charging Status Blue = Pairing Status

Reset

Button

Pairing Button

Charging

USB charging

cable

(included)

USB

Port

USB AC adaptor

(not included)

Bluetooth

• The LED will ﬂash red while charging, and will shut o automatically when the internal battery is fully charged.

• Note: If the battery is very weak, the LED may not ﬂash during the ﬁrst few minutes of charging.

• If the LED ﬂashes red when the unit is not charging, this

indicates that the battery is weak and should be charged.

IMPORTANT SAFETY INSTRUCTIONS

When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit.

GENERAL

• Please exercise caution when in use as the mirror is made of glass.

1. Water and Moisture – The unit should not be used near water. For example: near a bathtub, washbowl, kitchen

sink, laundry tub, swimming pool or in a wet basement.

2. Ventilation – The unit should be situated so that its location or position does not interfere with its proper

ventilation. For example, it should not be situated on a bed, sofa, rug or similar surface that may block ventilation openings. Also, it should not be placed in a built-in installation, such as a bookcase or cabinet, which may impede the flow of air through the ventilation openings.

3. Heat – The unit should be situated away from heat sources such as radiators, heat registers, stoves or other

appliances (including amplifiers) that produce heat. Do not use around aerosol products or in the presence of oxygen being administered.

4. Sunlight – Never place the mirror in or expose the mirror to direct sunlight. The sun’s rays can reflect to

become focused and cause excessive heat and/or fire. Do not use mirror in direct sunlight as reflected sunlight could injure eyes.

5. Power Sources – The unit should be connected to a power supply only of the type described in the operating

instructions or as marked on the appliance.

6. Power-Cable Protection – Power supply cables should be routed so that they are not likely to be walked on

or pinched by items placed upon or against them. It is always best to have a clear area from where the cable exits the unit to where it is plugged into an AC socket.

7. Cleaning – The unit should be cleaned only as recommended. See the Maintenance section of this manual

for cleaning instructions.

8. Objects and Liquid Entry – Care should be taken so that objects do not fall and liquids are not spilled into

any openings or vents located on the product.

9. Attachments – Do not use attachments not recommended by the product manufacturer.

10. Lightning and Power Surge Protection – Unplug the unit from the wall socket and disconnect the antenna

or cable system during a lightning storm or when it is left unattended and unused for long periods of time. This will prevent damage to the product due to lightning and power-line surges.

11. Overloading – Do not overload wall sockets, extension cords, or integral convenience receptacles as this

can result in a risk of fire or electric shock.

12. Damage Requiring Service – The unit should be serviced by qualified service personnel when:

A. the power supply cable or plug has been damaged. B. objects have fallen into or liquid has been spilled into the enclosure. C. the unit has been exposed to rain. D. the unit has been dropped or the enclosure damaged. E. the unit exhibits a marked change in performance or does not operate normally.

13. Periods of Nonuse – If the unit is to be left unused for an extended period of time, such as a month or longer,

the power cable should be unplugged from the unit to prevent damage or corrosion.

14. Servicing – The user should not attempt to service the unit beyond those methods described in the user’s

operating instructions. Service methods not covered in the operating instructions should be referred to qualified service personnel

15. Attention should be drawn to the environmental aspects of battery disposal”

16. Do not dispose of batteries in the household trash or fire”

17. No naked flame sources, such as lighted candles, should be placed on this product”

18. This product is suitable for use in tropical and/or moderate climates.”

Light Function

• Press and hold the Light Button to turn the light ON or OFF. (Lights are independent from Power ON/OFF.)

Light

Play/Pause

Power

ON/OFF

Volume

Down

• Press the Light Button to select a brightness level:

Hi, Mid, or Low.

Note: When not connected to the charger, the mirror light runs on a timer that will automatically power o after 60 minutes.

FCC Information

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference and (2) This device must accept any interference received, including interference that may cause undesired operation

This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

• Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

• NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

CAN ICES-3 (B)/NMB-3(B)

IC Statement

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :

(1) L’appareil ne doit pas produire de brouillage; (2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

le dispositif a été évalué à satisfaire l'exigence générale de l'exposition aux rf. l'appareil peut être utilisé dans des conditions d'exposition portatif sans restriction.

Volume

Button

Audio Function

• Press and hold power button to turn speak

er ON or OFF (located on top of mirror)

• When mirror is ON, press and hold the Bluetooth Pairing Button (located on back of mirror) to enter pairing mode, indicated by the blinking blue LED

• Select ‘iHome PORTABLE’ on your

device’s Bluetooth menu to connect

• Press to play / pause Bluetooth audio

• Press twice for Previous Track

• Press three times for Next Track

• Press to lower or raise volume

Note: If no audio is playing for 60 minutes, the unit will automatically power o to conserve the battery.

Limited One Year Warranty

FCC ID:

IC:

iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of one (1) year from the date of original purchase. Should this product fail to function in a satisfactory manner, it is best to first return it to the store where it was originally purchased. Should this fail to resolve the matter and service still be required by reason of any defect or malfunction during the warranty period, SDI will repair or, at its discretion, replace this product without charge. This decision is subject to verification of the defect or malfunction upon delivery of this product to the Factory Service Center authorized by Customer Service. If service is required, please call contact Customer Service at ihome.com/support/contact to obtain a Return Authorization Number and shipping instructions. A copy of the sales receipt is required to validate in-warranty coverage. If proof of purchase cannot be produced, the product will be deemed out-of-warranty. The date of purchase, vendor, product model number, and purchase price must be legible and verifiable.

Disclaimer of Warranty NOTE: This warranty is valid only if the product is used for the purpose for which it was designed. It does not cover (i) products which have been damaged by negligence or willful actions, misuse or accident, or which have been modified or repaired by unauthorized persons; (ii) cracked or broken cabinets, or units damaged by excessive heat; (iii) damage to digital media players, CD’s or tape cassettes (if applicable); (iv) the cost of shipping this product to the Factory Service Center and its return to the owner. This warranty is valid only in the United States of America and does not extend to owners of the product other than to the original purchaser. In no event will SDI or any of its affiliates, contractors, resellers, their officers, directors, shareholders, members or agents be liable to you or any third party for any consequential or incidental damages, any lost profits, actual, exemplary or punitive damages. (Some states do not allow limitations on implied warranties or exclusion of consequential damages, so these restrictions may not apply to you.) This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Your acknowledgment and agreement to fully and completely abide by the above mentioned disclaimer of warranty is contractually binding to you upon your transfer of currency (money order, cashier's check, or credit card) for purchase of your SDI product.

iCVBT20-071420-A

Questions? Visit www.ihome.com

Printed in China