iHome iB12 User Manual

Model: iB12

ﬁtness earbuds with clip-on LED safety ﬂasher

+ cordwrap

Using Your iHome Headphones

The earpieces are marked “L” and “R”. Place the “L” earpiece in your left ear

and the “R” earpiece in your right ear for proper ﬁt and best sound. If the earpieces are inserted incorrectly they will not ﬁt properly in your ears and the sound quality will not be satisfactory. For added stability the cables of these ear buds should be looped over your ears as shown in the following illustration.

NOTE: Your iB12 headphones are supplied with three different size silicon tips (S-M-L) for maximum comfort and to seal out unwanted noise. The “M”

(medium) size tips were installed at our factory. If you ﬁnd that the installed tips are too small or too large for your ears, you may remove them and replace

them with the larger or smaller size accessory tips. To replace the tips simply pull them off the earpieces. To install different size tips, push them on to the earpieces and make sure they are fully seated on each earpiece so that they do not come off when you

remove the earpiece from your ear. If one of the tips remains in your ear when you remove the headphones, remove the tip carefully and avoid pushing it further into your ear canal. Seek medical assistance if one of the tips becomes lodged in your ear and you are unable to remove it.

Connect the headphone plug to the headphone jack of your music player. Be sure that the plug is fully

inserted into the jack. If the plug is not fully inserted you may only hear sound from one earpiece.

To protect your hearing, always start listening with the volume control of your music source set to a low level and then gradually increase the volume to a comfortable listening level.

Press here to open belt clip

LED Safety Flasher

Your iHome iB12 Ear Buds are supplied with a

LED safety ﬂasher that includes a convenient belt clip and an integrated cord wrap to keep your cables tangle free. Remove the battery

pull tab before use.

Press the Mode Button on the front panel to

turn the ﬂasher on and cycle through the 3

operating modes as follows:

First press – LED’s ﬂash rapidly

Second press – LED’s ﬂash slowly

Third press – LED’s ‘On’ continuously

Fourth press – LED’s ‘Off’

Replacing Batteries

Two CR1625 batteries that were installed at our factory should provide sufﬁcient power for up to 96 hours of continuous operation. When the lighting effect begins to dim or no longer turns ‘On’ you should replace the batteries as soon as practical.

Mode Button

CR1625X2

Slide-out Cord Wrap

Battery Compartment

Belt Clip

Remove the battery pull tab before use

To open, unscrew center screw only and pull out the batteries tray

LITHIUM BATTREY

CR1625

Install two fresh CR1625 batteries in the battery tray as shown above

The LED ﬂasher also includes a convenient integrated cord wrap to help keep your ear bud cables tangle free. Gently slide the cord wrap out of the cabinet as shown and wind the ear bud cables

around the cord wrap when not in use.

The LED ﬂasher can be clipped to your belt or clothing to provide increased visibility while running, jogging, or walking after dark.

IMPORTANT! Listening at high volume for long periods of time can result in long-term hearing damage. For your safety, do not use headphones if they would prevent you from hearing warning sounds, such as while driving a car or motorcycle, riding a bike, etc. Remember that noise isolation type earphones such as the iB12 are very effective in blocking outside noise, including warning sounds. Always be aware of your surroundings and do not use these

earphones in situations that require you to hear warning sounds.

NOTE: In extremely cold or dry air conditions you may notice a slight ‘tingling’ feeling in your ears when using in-ear headphones. This is the result of the build-up of static electricity in your body. This is normal and not an indication of any problem with your

headphones.

Limited One-Year Warranty Information

iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI), warrants this product to be free from defects in workmanship and materials, under normal use and conditions,

for one year of the product from the date of original purchase.

Should this product fail to function in a satisfactory manner, it is best to ﬁrst return it to the store where it was originally purchased. Should this fail to resolve the matter and service still be required by reason of any defect or malfunction during the warranty period, SDI will repair or, at its discretion, replace this product without charge. This decision is subject to veriﬁcation of the defect or malfunction upon delivery of this product to the Factory Service Center authorized by SDI Customer Service. The product must include proof of purchase, including date of purchase. An out-of-warranty fee for service will be charged for units that are received without proof of purchase.

Before returning this product for service, please ﬁrst replace the batteries (if applicable) with fresh ones, as exhausted or defective batteries are the most common cause of problems encountered. If service is still required:

1. Call SDI Customer Service at 1-800-288-2792 for Return Authorization and for the address of the Factory Service Center.

2. Remove the batteries (if applicable) and pack the unit in a well padded, heavy corrugated box. SDI is not responsible for damage that occurs during shipping to the Factory Service Center.

3. Enclose a photocopy of your sales receipt, credit card statement, or other proof of the date of purchase, if within the warranty period. Also include your name and address information, a brief description for why the unit is being returned, and the return authorization number. No unit can be processed without a return authorization number.

4. Write the return authorization number on the side of the shipping package and send the unit prepaid and insured to the Factory Service Center address authorized by SDI Customer Service.

Disclaimer of Warranty

NOTE: This warranty is valid only if the product is used for the purpose for which it was designed. It does not cover (i) products which have been damaged by negligence or willful actions, misuse or accident, or which have been modiﬁed or repaired by unauthorized persons; (ii) cracked or broken cabinets, or units damaged by excessive heat; (iii) damage to digital media players, CD’s or tape cassettes (if applicable); (iv) the cost of shipping this product to the Factory Service Center and its

return to the owner.

This warranty is valid only in the United States of America and does not extend to owners of the product other than to the original purchaser. In no event will SDI or any of its afﬁliates, contractors, resellers, their ofﬁcers, directors, shareholders, members or agents be liable to you or any third party for any consequential or incidental damages, any lost proﬁts, actual, exemplary or punitive damages.

(Some states do not allow limitations on implied warranties or exclusion of consequential damages,

so these restrictions may not apply to you.) This warranty gives you speciﬁc legal rights, and you may also have other rights which vary from state to state. Your acknowledgement and agreement to fully and completely abide by the above mentioned disclaimer of warranty is contractually binding to you upon your transfer of currency (money order, cashier's check, or credit card) for purchase of your SDI product.

Questions? Visit www.ihomeaudio.com or call 1-800-288-2792 Toll Free.

iB12-073113-A Printed in China