Ifrogz Airtime Premier User Manual

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.

THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS
OR CHANGE TO THIS EQUIPMENT. SUCH MODIFICATIONS OR CHANGE COULD VOID THE USER’S AUTHORITY TO OPERATE THE
EQUIPMENT.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged
to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific
operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.

©2019 ZAGG Inc All Rights Reserved | NASDAQ: ZAGG | MADE IN CHINA
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such
marks by ZAGG Inc is under license. Other trademarks and trade names are those of their respective owners.
Other trademarks are property of ZAGG IP Holding Co., Inc.

AIRTIME™ PREMIER

Quick Start Guide314- 0326 -A | 09/ 19/19

AIRTIME™ PREMIER Instructions

Introduction

Welcom e to truly wire less audio. N ow, you never
need to p lug your earb uds in again. AI RTIME
PREMIE R truly wire less earbu ds free you to en joy
music without anything holding you back.

Pairi ng the Wirel ess Earbud s with
Your Device

1. Simply o pen the cas e and remove th e buds.
A pairin g signal will b e sent to your Bl uetooth®
device . The earbud s will flash whi te and red,
indicating pairing mode.

2. Ensure yo ur device’s B luetooth® co nnectio n is
on and se lect “IFR OGZ Airti me Premier.”

3. Compl ete any addit ional pairi ng steps bas ed
on your de vice. The ear buds’ light s will flash
white an d then turn o , indicatin g that pairi ng
was succ essful. C ongrats , your new wirel ess
earbu ds are now ready t o use!

Turning Earbuds On/Off

To turn the e arbuds on, si mply remove t he buds

from th e case.

If you wou ld like to use onl y one bud, simp ly remove
the rig ht earbud fro m the case. T he right earb ud is
the pri mary bud an d can be used wi thout the ot her.
Please n ote, the lef t earbud wil l not work alon e
unles s the right ear bud is also re moved
from th e case.

To turn ear buds o, simpl y return the m to the case.
You can als o press and hol d the IFROGZ i con on the
earbu d for ten secon ds to turn it o ; it will flash re d
indic ating power i s o.

The ear buds will go in to hibernat ion mode if no t
used fo r 20 minutes.

Using the Earbuds

AIRTIME PREMIER has built-in touch navigational
contro ls. Simply t ap on the end of t he earbud (on th e
IFROGZ l ogo) to naviga te.

Music Controls

Left Bu d Actions Right Bud

Play / Pause Quick Tap Play / Pause

Previous Trac k

Decrease Volume

2x Ta ps

Tap & Hold

Nex t Trac k

Increase Volume

Call Controls

Answer Ca ll /
End Call

Cancel Call

Siri / Voice
Command

Quick Tap

Tap & Hold

3x Tap s

Answer Ca ll /
End Call

Cancel Call

Siri / Voice
Command

Charging the Wireless Earbuds

The cas e carries e nough power t o charge the
earbu ds up to 5* times . To charge them:

1. Place t hem in the char ge case.

2. A red light on t he earbuds w ill indicat e
chargi ng. When the re d light disap pears,
they are f ully charge d.

3. Recha rge the case , if needed.

*

Based on 50 % volume and 5 hou rs of playt ime.

Charging the Case

Your case c omes charge d and ready to go, b ut

here’s ho w to recharge i t when you nee d to:

1. Conne ct the incl uded USB- C charging ca ble to
the por t on the back o f your case.

2. Connec t the USB- A end of the incl uded cable
to your pr eferred 5V US B outlet.

3. The Battery Indicator outside the case will
flash acc ording to it s current bat tery le vel. This
indic ates your cas e is charging .

4. Wait for t he Batter y Indicat or lights to t urn o,
indic ating your ca se is fully ch arged.

5. Discon nect the ch arging cabl e and enjoy you r
new, por table pow er.

Checking the Battery Level

Your case c arries eno ugh power for y ou to enjoy
your wir eless earb uds up to 5 times , for a total of up
to 30 hour s. To check how mu ch power it st ill carri es:

1. Place t he buds in the c ase. The LED on t he front
of the ca se will illumi nate indic ating how muc h
battery remains:

a. If it li ghts up compl etely, 75% or

more remains.

b. If it lights u p ¾ of the way,

betw een 50-74% remains .

c. If it l ights up ½ of the w ay,

betw een 25-49% r emains.

d. If it lights u p ¼ of the way, less

than 24% remains.

2. Recharge your case whenever you wish.

Factory Reset

A fact ory reset c an help wit h some troubl eshootin g

issue s. Here’s how to p erform on e:

1. Place b oth buds in the c ase.

2. Reset t he right bud.

a. Remove t he right bud f rom

the case.

b. Tap and h old for 10 second s

until li ght flashes re d and
turn s o.

c. Tap and hold for five s econds

until li ght turns on an d flashes
red and wh ite.

d. Quickly tap t he bud six tim es,

the ligh t will turn o.

e. Return t he bud to the ca se.

3. Rese t the left bu d.

a. Remove l eft bud fro m the case.

b. Quickly tap t he bud six tim es,

the ligh t will turn o.

c. Retu rn the bud to th e case.

4. Conne ct left an d right.

a. Remove b oth buds fro m the

case an d allow them to c onnect
to each ot her for abou t five
seconds.

5. Connec t as normal.

a. The buds are now r eset to

fact ory set tings. Remo ve
them fr om the case an d pair
as normal.