Icom SM-30 Instructions Manual

INSTRUCTIONS
DESKTOP MICROPHONE
PART NAMES AND FUNCTIONS
D FRONT VIEW D BOTTOM VIEW
SM-30
Thank you for choosing this Icom product. READ ALL INSTRUCTIONS carefully and completely before using this product.
The SM-30 is an unidirectional, electret microphone designed for base station operation with an Icom transceiver.
PRECAUTIONS
CAUTION: NEVER expose the microphone to
CAUTION: NEVER let metal, wire or other objects protrude into the microphone or into connector.
CAUTION: NEVER touch or operate the desktop microphone with wet hands.
CAUTION: NEVER use harsh solvents such as benzine or alcohol when cleaning, because they will damage the microphone’s surfaces.
CAUTION: USE with specied Icom
transceivers only. Other manufacturer’s transceivers have different pin assignments and may damage the transceiver or microphone if attached.
DO NOT operate or place the microphone in direct sunlight.
DO NOT place the microphone in excessively dusty environments.
Always place the microphone in a secure place to avoid inadvertent use by unauthorized person.
About CE
The SM-30 complies with the
essential requirements of the 2014/30/EU directive for Electromagnetic Compatibility and the 2001/95/EC directive for
General Product Safety.
DISPOSAL
The crossed-out wheeled-bin symbol on your product, literature, or packaging reminds you that in the European Union, all electrical and electronic products, batteries,
and accumulators (rechargeable batteries) must be taken to designated collection locations at the end of their working life. Do not dispose of these products as unsorted municipal waste. Dispose of them according to the laws in
your area.
SPECIFICATIONS
• Microphone type: Unidirectional electret condenser microphone
(preamp built-in)
• Output impedance: 600 Ω ±30% (at MIC GAIN: Maximum)
• Sensitivity: –28 dB ±4 dB (0 dB=1 V/Pa, at 1 kHz)
• Power requirements: 8 V DC (supplied from the transceiver)
• Cable length (approximate): 1 m, 3 ft 3
• Weight (approximate): 350 g, 12.3 oz
All stated specications are subject to change without notice or obligation.
3
8 in
r t
LOW CUT
ONOFF
q
e
w
MIC GAIN
r MIC GAIN VOLUME [MIC GAIN]
Rotate to adjust the microphone output level. L Use this control as an adjunct to
q PTT SWITCH
Push to transmit, then release to receive.
w PTT LOCK SWITCH
Push to continuously transmit. The transmission continues until pushing this switch again.
e PTT LOCK INDICATOR [LOCK]
Lights red when the PTT lock switch (w) is ON.
the microphone gain setting of the connected transceiver.
NOTE: Rotating the control too far clockwise may result in an output level that is too high and transmit signal distortion.
t LOW CUT SWITCH [LOW CUT]
Cuts out the low frequency components of input voice signals.
D PLUG PIN ASSIGNMENTS
The pins are described from the direction of the arrow in the illustration.
i No connection
q Microphone output
w 8 V DC input
e No connection t PTT
r No connection
Icom is not responsible for the destruction, damage to, or performance of any Icom or non-Icom equipment, if the malfunction is because of:
• Force majeure, including, but not limited to, res, earthquakes, storms, oods, lightning, other
natural disasters, disturbances, riots, war, or radioactive contamination.
• The use of Icom transceivers with any equipment that is not manufactured or approved by Icom.
Icom, Icom Inc. and the Icom logo are registered trademarks of Icom Incorporated (Japan) in the United States, the United Kingdom, Germany, France, Spain, Russia, Australia, New Zealand, and/or other countries. and/or other countries.
u GND (Microphone ground)
y GND (PTT ground)
1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003, Japan
A-6829X-1G-w Printed in Japan
© 2010–2016 Icom Inc.
各部の名称と機能
547ー0003
取扱説明書
DESKTOP MICROPHONE
SM-30
安全上のご注意
安全にご使用いただくために、必ずお読みください。 ◎ ここに示した注意事項は、使用者および周囲の人への危害や財産への損害を未然に防ぎ、製品を安全に
正しくご使用いただくために、守っていただきたい事項を示しています。
お読みになったあとは、いつでも読める場所へ大切に保管してください。
下記の記載事項は、これを無視し て誤った取り扱いをすると 「使用
R 警告
◎湿気やホコリの多い場所、風通しの悪い場所で使
用しないでください。
火災、感電、故障の原因になります。
◎水などでぬれやすい場所(加湿器のそばなど)で使
用しないでください。
火災、感電、故障の原因になります。
◎線材のような金属物を入れたり、水につけたりし
ないでください。
火災、感電、故障の原因になります。
◎ぬれた手で接続プラグや機器に絶対触れないでく
ださい。
感電の原因になります。
マイクロホンタイプ :単一指向型エレクトレットマイクロホン(プリアンプ内蔵)
出力インピーダンス :600Ω±30%(
マイク感度 :-28dB±4dB(0dB=1V/
電源電圧 :DC8V(弊社製無線機より供給)
マイクケーブル長 :約1m
重量  :約350g
※定格、外観、仕様などは、改良のため予告なしに変更することがあります。
者および周囲の人が、死亡または 重傷を負う可能性が想定される内 容」 を示しています。
MICGAIN:MAXにて
このたびは、本製品をお買い上げいただき まして、まことにありがとうございます。
本製品は、固定局用に設計された単一指向 型エレクトレットマイクロホンです。
ご使用の前に、この説明書をよくお読みく ださい。
下記の記載事項は、これを無視し て誤った取り扱いをすると 「人が
R 注意
◎本製品は、弊社製無線機専用です。
本製品に接続された無線機から電源を供給してい るため、弊社製以外の無線機には使用できません。 また、故障の原因になることがあります。
清掃するときは、洗剤や有機溶剤(シンナー、ベンジ
ンなど)を絶対に使用しないでください。
ケースが損傷したり、塗装がはがれたりする原因 になることがあります。 ふだんは、乾いたやわらかい布でふき、汚れのひ どいときは、水を含ませたやわらかい布をかたく 絞ってふいてください。
傷害を負う可能性が想定される内 容および物的損害のみの発生が想 定される内容」 を示しています。
定格
Pa、
1kHzにて)
D
上面部
D
底面部
r t
LOW CUT
ONOFF
MIC GAIN
q
q PTTスイッチ
スイッチを押しているあいだは送信状態にな り、はなすと受信状態に戻ります。
w PTT LOCKスイッチ
スイッチを押すごとに送信と受信を切り替え ます。
e PTT LOCK LED [LOCK]
PTTLOCKスイッチ(w)を送信に切り替えた とき、赤く点灯します。
接続プラグのピン配置について
D
 この図は、イラスト中の矢印の方向から見たピン配置を示します。
e
どこにも接続されていません
【免責事項について】
地震・雷・風水害などの天災および当社の責任以外の火災、本製品の違法な使用、お客様または第三者が 取扱説明書とは異なる使用方法で本製品を使用することにより生じた損害につきましては、法令上の 賠償責任が認められる場合を除き、当社は一切責任を負いませんので、あらかじめご了承ください。
アイコム株式会社、アイコム、IcomInc.、アイコムロゴは、アイコム株式会社の登録商標です。
e
w
q
マイク出力
w
8VDC入力
r MIC GAINボリューム[MIC GAIN]
マイクロホンの出力レベルを調整します。 ボリュームを時計回りの方向に回すと出力レ ベルが大きくなり、反時計回りの方向に回すと 小さくなります。 お使いになる無線機によって、マイクロホンの 出力レベルが不足するときなどにご利用くだ さい。
ご 注 意: ボリュームを時計回りの方向に回しす
ぎると、出力レベルが過大となり、音声 がひずむことがあります。
t LOW CUTスイッチ[LOW CUT]
入力音声信号の低い周波数成分を除去する フィルターをON/OFFします。
i
どこにも接続されていません
u
マイクロホン用GND
y
PTT用GND
t
PTT
r
どこにも接続されていません
大阪市平野区加美南
1ー1ー32
Loading...