Icom PS-125 User Manual

INSTRUCTIONS

DC POWER SUPPLY

PS-12 5

Thank you for purchasing the PS-125 DC

POWER SUPPLY

Icom equipments required 13.8 V DC/25 A
(Max.).
Please read these instructions thoroughly
before operating the PS-125.

PRECAUTION

. The PS-125 is designed for

• RNEVER apply AC voltage that exceeds the

specified voltage for the PS-125 rear panel.
Excessive voltage could cause a fire or ruin
the power supply.

• RNEVER expose the power supply to rain,

snow or any liquids.

• RNEVER open the top or bottom covers.

There are no user adjustment points. Opening
the case may expose you to electric shock and
incorrect reassembly may cause a fire hazard.

• RNEVER let metal, wire or other objects touch

any internal components through the slits of
the cases. This will electric shock.

• RCAUTION! The socket-outlet must be near

the DC power supply and must be easily
accessible.

• RACHTUNG! Die Steckdose muß nahe bei

diesem Gerät angebracht und zugängliich
sein.

• KEEP the power supply out of the reach of
children.

• USE the power supply with an Icom equipment
only. Other brands may have different pin
assignment.

• USE an AC outlet that can supply more than
750 VA capacity. AVOID the use of a multi-plug
adaptor.

• DO NOT use strong cleaning agents such as
benzine or alcohol. ALWAYS unplug the AC
cable from the AC outlet, then use a dry soft
cloth when cleaning the power supply.

• DO NOT place liquids on or near the power
supply.

• DO NOT place the power supply against walls
or put anything to behind the power supply.
This will obstruct heat dissipation.

IMPORTANT!

The connected transceiver may receive switch­ing noise from this power supply depending on
the antenna used and/or installing conditions,
etc.

SPECIFICATIONS

• Input voltage : 230 V AC (50/60 Hz)

• Input current : 2.3 A

• Output voltage : 13.8 V DC±5%

• Max. output current : 25 A, 50% duty (1 min. ON/1 min. OFF)

• Dimensions : 111(W)×94(H)×287(D) mm

(projections not included) 4.4(W)×3.7 (H)×11.3(D) in

• Weight (approx.) : 3.0 kg; 6 lb; 10 oz

• Usable temperature range : –10˚C to +40˚C; +14˚F to +104˚F

OPERATION

q Make sure the [POWER] switches on the PS-

125 and other equipment are OFF.

w Connect the DC output cable of the PS-125

to the DC power input socket of the equip­ment.

e Connect the AC power cable to an AC outlet

and the PS-125.

r Turn the PS-125 ON.

• “ I ” : ON (red indicator lights)

• “O” : OFF (red indicator goes off)

t Turn the connected equipment ON.
y To turn OFF the system, turn the connected

equipment power OFF, then the PS-125 in
sequence.

PANEL DESCRIPTION

Power SW

Indicator

POWER PROTECTOR

The PS-125 has an output protection circuit.
When the + and _ pins are shorted, the PS­125 stops functioning. In such a case, remove
the source of the problem, turn OFF the PS-125,
wait several seconds, then turn it ON again.

NC

1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003, Japan

+_

A-6003H-2EU-e Printed in Japan

© 2001–2006 Icom Inc.